TECHCity Technology LC-321S LIGHT SWITCH User Manual LC 311 312

TECHCity Technology Co., Ltd. LIGHT SWITCH LC 311 312

User Manual

Download: TECHCity Technology LC-321S LIGHT SWITCH User Manual LC 311   312
Mirror Download [FCC.gov]TECHCity Technology LC-321S LIGHT SWITCH User Manual LC 311   312
Document ID1894378
Application IDEP7HZdjvqLS4EYrHYEq/wg==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize17.65kB (220632 bits)
Date Submitted2013-02-05 00:00:00
Date Available2013-02-05 00:00:00
Creation Date2013-01-10 15:04:12
Producing SoftwareAcrobat Distiller 8.0.0 (Windows)
Document Lastmod2013-02-01 11:52:43
Document TitleMicrosoft Word - LC-311_&_312.doc
Document CreatorPScript5.dll Version 5.2
Document Author: Patrick

Name : 1 Circuit --- RF & Touch Control
Model No. : LC-321S
Power & Loading: LC-321S (AC-110V, Max. Load 1,000W)
Button/Circuit(s) Settings
Setting / Control
1. PLS check Annex A to uninstall the panel.
2. Press & hold the Touch Sensor Area w/ your finger
3. Take a stick to press the Setup Button (feel a “click”),
when the red light on, let go your finger & setup stick.
4. The red light on, means the switch is under the setting mode
(window = 10 Sec.), if not, PLS repeat step (1) & (2).
5. Take a remote (ex. RC-07/RC-09), select Zone (Zone 1,2 or
3), press number (position) then press ON to send the RF
code to the switch.
6. When red led blinks then turns off, it means the setting is
completed. PLS use the remote to control the switch
ON/OFF, to confirm the setting.
7. PLS wait 30 sec. after installed the panel, till the sensor adapt
the thickness of the panel, then you may touch the panel to
switch ON/OFF the light.
8. Control: a.) Touch sensor area to turn ON/OFF the light.
b.) Remote: select Zone (Zone 1,2 or 3), press number
(position) then press ON/OFF.
Warning!
1. Be sure to determine the correct wiring of the power supply polarity, wrong wiring will result in damage to the product and may endanger
2. Before setup, make sure the voltage loading of the circuit switch complies with local regulations. Improper usage of electric
power and exceeding loading voltage will cause damage to the product.
3. This product is a low-power RF wireless carrier communications transmission systems, in order to reduce environmental obstacles
lead to remote insensitive, please try not to use the larger than the average residential space (details contact Dealer)
4. If for unavoidable necessary, must do installation under electrified condition, PLS connect LINE (Black) & NEUTRAL (White),
each to their corresponding wire first, turn off the switch, then connect the FIXTURE (Blue), & done!。
Annex A:Panel Install / uninstall
[Uninstall]
Put the sucker on the marked spot, press to squeeze out air
& make sure the sucker is fixed, then pull out of the panel.
[Install]
There are 2 latches on the top of the panel, & a crystal in the
buttom.
there is 2 slot for those 2 latches & a magnet for
crystal. PLS make sure the direction correctly.
Slide latches
into slots first then press the crystal side into the magnet side
till the panel sink completely.
Pull!
FCC WARNING
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE 1: Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
XMP Toolkit                     : 3.1-701
Creator Tool                    : PScript5.dll Version 5.2
Modify Date                     : 2013:02:01 11:52:43+08:00
Create Date                     : 2013:01:10 15:04:12+08:00
Metadata Date                   : 2013:02:01 11:52:43+08:00
Format                          : application/pdf
Title                           : Microsoft Word - LC-311_&_312.doc
Creator                         : Patrick
Producer                        : Acrobat Distiller 8.0.0 (Windows)
Document ID                     : uuid:933a4153-aff0-4bf6-ba8b-01ae7b19745b
Instance ID                     : uuid:30195a6a-aecd-448f-8f7c-622b4705f533
Page Count                      : 2
Author                          : Patrick
EXIF Metadata provided by EXIF.tools
FCC ID Filing: UQOLC-321S

Navigation menu