TECNO MOBILE T349R Mobile Phone User Manual

TECNO MOBILE LIMITED Mobile Phone

Contents

User Manual

        User Manual Mobile Phone Model: T349R  Hereby,TECNO MOBILE LIMITED declares that this Mobile Phone is in   compliance with the essential requirements and   other relevant provisions of Directive   2014/53/EU.
1.  Basic Information 1.1.  Brief Introduction Thanks for selecting this phone.   Through reading the manual, you can fully know the basic functions of the mobile phone and some precautions during use. This  phone  provides  many  kinds  of  practical  functions,  such  as  name  card  holder,  scene mode, message, audio and video player, camera and video, alarm clock, calculator and etc. so that convenient  for  your  work  and  leisure  activities.  In  addition,  this  phone  adopts  personalized human-computer interface design, its complete function can meet your different requirements.           The company reserves the rights to revise the contents of the manual without prior notice.   2.  Before Use 2.1.  Install SIM Card and Memory Card 2.1.1 SIM Card Before using the phone, you must insert valid SIM (Subscriber Identity Module) card in the phone. SIM card is provided by network supplier.   In order to avoid losing or damaging the information saves in SIM card, please don’t touch the metal contact surface, and place SIM card in the place that away from electricity and magnetic force. Once SIM card is damaged, you can’t use the phone normally.     Prompt: Please make sure to power off the phone before taking out SIM card. It is absolutely forbidden  to  insert  or  take  out  SIM  card  with  external  power  supply;  otherwise it  may  damage SIM card and the phone.   2.1.2 Memory Card Due to the limited size of mobile phone storage, we recommend that you insert an external memory card. You will be able to better experience the camera, video, music, recording and other functions. Prompt: If the memory card is failed, please check whether it is correctly placed  and good contact of metal point.   2.2.  Battery 2.2.1 Charging Insert the charger on the charging interface.       When electric quantity is too low, the phone will power off automatically. Please don’t make the battery in the status of not enough electric quantity for a long time; otherwise it may damage the battery quality and service life. Please don’t charge the battery for a long time.   Prompt:  In  order  to  ensure  normal  operation  of  the  phone,  please  make  sure  to  use  the designated charger.   2.2.2 Battery safety Do not place the battery in fire; follow local laws and ordinances in disposing used battery. Check the model number of the charger before using it to charge the mobile. Only use approved battery, charger and accessories applicable to the specific mobile model. Using  other  types  of  battery,  charger  and  accessories  may  violate  the  certification  or  warranty terms of the equipment and may result in danger.” Return waste and used batteries to the supplier or specified recovery site. CAUTION! Risk of explosion if an incorrect type replaces battery.
3.  E-waste/Recycle your phone   You  are  liable  to  dispose  of  all  your  electronic  or  electrical  waste  equipment  by  relocating over to the specified collection point    for recycling of such hazardous waste. Collection and proper recovery of your electronic waste equipment’s at the time of disposal will allow us to help preserve the environment. Recycling of the electronic waste equipment will ensure safety of human health and environment. 3.1 Instructions for disposal of products a) At the end of their life, should drop used electronic products, batteries, and packaging materials in the nearest disposed products cans or collection center b) Should divide the packaging materials according to corresponding waste disposal options and sort for recycling.   c) Battery should be removed from the product for recycling.   3.2 Prohibition for disposal of equipment   a) Never dump E-wastes in garbage bins or municipal solid waste stream.   3.3 Information on the consequences of improper handling, accidental breakage damage and improper recycling of the end of life product. a) If batteries are not properly disposed of, it can cause harm to human health or the environment. b) If the battery terminals are in contact with metal objects, it may cause a fire. 4.  Care and Maintenance Maintenance of battery •Your device is powered by a rechargeable battery. It is necessary to have the battery charged when it is going to wear out. To prolong battery life, new battery need to run out of power for the first charge. •Unplug the charger from the electrical plug and the device when not in use. Do not  leave fully a  charged battery connected  to  a  charger  over a  week, since overcharging  may shorten  its lifetime. •Do not expose your phone to extreme temperatures lower than 0°C and higher than 45°C. •Temperature tends to affect the limit of battery to be charged. Therefore, it is necessary for the battery to be cooled or warmed before it is charged. Stop charging when battery is higher than 55℃  or below 0℃, and restore charging when below 50℃  or higher than 5℃. •Use  the  battery  only  for  its  intended  purpose  and  avoid  short-circuiting.  Accidental short-circuiting can occur when a metallic object causes direct connection of the positive (+) and negative (-) terminals of the battery.   •Do not use damaged battery. •Leave the battery in hot or cold places will reduce the capacity and lifetime of the battery. A device  with  a  hot  or  cold  battery  may  not  work  temporarily,  even  when  the  battery  is  fully charged. •Do not dispose of batteries in a fire as they may explode. Dispose of batteries according to local regulations. Care of maintenance of your device The suggestions below will help you protect your warranty coverage.   •Keep the device and accessories out of the reach of small children. •Keep the device dry. All types of liquids or moisture will corrode electronic circuits.
•Do  not  store  the  device in hot  areas. High  temperatures  can  shorten  the life of electronic devices and warp or melt certain plastics. •Do not attempt to open the device other than as instructed in this guide. Non-professional handling may damage the device. •Do not use harsh chemicals or strong detergents to clean the device. •Use only the  supplied or an approved replacement attachments, for the unauthorized ones could invalidate the warranty of maintenance. 5.  Additional Safety Information Remember to  follow any special regulations in force and use  the device only in its  normal operation positions. Traffic Safety •Unless  there  is  an  emergency,  otherwise  do  not  use  the  device  when  you  are  driving  a vehicle without safety wireless equipment. Please park the vehicle in a safe place before you use the device in order to guarantee that you pay all attention to drive. Observe related regulations. •In  case  there  is  no  adequate  protection,  certain  electronic  systems  of  the  vehicle  may  be affected by the electric wave of the device. •You are suggested to use the device only in vehicles with antenna. •Only qualified personnel should install the device in a vehicle. Aircraft Safety   Switch  off  your  device  before  boarding  an  aircraft.  The  use  of  wireless  teledevices  in  an aircraft may be dangerous to the operation of the aircraft, disrupt the wireless telephone network, and may be illegal. The GSM service will be unavailable. When you are in flying aircraft, using your device is prohibited. Environment Safety •Remember to follow any special regulations in force in any area, and always switch off your device when its use is prohibited or when it may cause interference or danger. •Operation  of  any  radio  transmitting  equipment,  including  wireless  phones,  may  interfere with  the  functionality  of  inadequately  protected  medical  devices.  Consult  a  physician  or  the manufacture of the medical device to determine if you have any questions. •Your device may interfere with some hearing aids, pacemakers and other medical devices. Please obey the suggestions provided by physicians or medical device manufacturers. •You are suggested to switch off the device in any area with potentially explosive atmosphere, such as gas station, chemical factories etc. •Observe restrictions on the use of radio equipment. Note:The socket-outlet shall be installed near the equipment and shall be easily accessible. 6.  SAR Specific Absorption Rate (SAR) Certification THIS  DEVICE  MEETS  INTERNATIONAL  GUIDELINES  FOR  EXPOSURE  TO RADIO WAVES Your mobile device is a radio transmitter and receiver. It is designed not to exceed the limits for exposure to radio waves (radio frequency electromagnetic fields) recommended by international guidelines. The guidelines were developed by an independent scientific organization (ICNIRP) and include a  substantial safety margin designed to assure the safety of all persons, regardless of age and health.
The  radio  wave  exposure  guidelines  use  a  unit  of  measurement  known  as  the  Specific Absorption  Rate,  or  SAR.  The  SAR  limit  for  mobile  devices  is  1.6  W/kg.  Tests  for  SAR  are conducted  using  standard  operating  positions  with  the  device  transmitting  at  its  highest  certified power level in all tested frequency bands. The highest SAR values under the ICNIRP guidelines for this device model are: Maximum SAR for this model and conditions under which it was recorded. Head  1.19 W/Kg Body  1.00 W/Kg During  use,  the  actual  SAR  values  for  this  device  are  usually  well  below  the  values  stated above.  This  is  because,  for  purposes  of  system  efficiency  and  to  minimize  interference  on  the network, the operating power of your mobile device is automatically decreased when full power is not needed for the call. The lower the power output of the device, the lower its SAR value. A body-worn SAR test has been performed on this device at a separation distance of 15 mm. To meet RF exposure guidelines during body-worn operation, the device must be positioned at least 15 mm away from the body. Organizations  such  as  the  World  Health  Organization  and  the  US  Food  and  Drug Administration have suggested that if people are concerned and want to reduce their exposure, they could use a hands-free accessory to keep the wireless device away from the head and body during use, or reduce the amount of time spent using the device. 7.  CAUTION SAR  tests  are  conducted  using  standard  operating  positions  accepted  by  the  FCC  with  the phone transmitting at its highest certified power level in all  tested frequency bands, although the SAR is determined at  the  highest certified power level, the  actual  SAR level  of the phone  while operating can be well below the maximum value, in general, the closer you are to a wireless base station antenna, the lower the power output.   Before a new model phone is a available for sale to the public, it must be tested and certified to the FCC that it does not exceed the exposure limit established by the FCC, Tests for each phone are performed in positions and locations (e.g. at the ear and  worn on the body)as required by the FCC.   FCC ID: 2ADYY-T349R For body worn operation, this model phone has been tested and meets the FCC RF exposure guidelines when used with an accessory designated for this product or when used with an accessory that   Contains no metal and that positions the handset a minimum of 1.5 cm from the body.   Non-compliance with the above restrictions may result in violation of RF exposure guidelines.  Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.    Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,  pursuant  to  part  15  of  the  FCC  Rules.  These  limits  are  designed  to  provide  reasonable protection against harmful interference in a residential installation. This equipment generates uses and  can  radiate  radio  frequency  energy  and,  if  not  installed  and  used  in  accordance  with  the instructions,  may  cause  harmful  interference  to  radio  communications.  However,  there  is  no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful  interference  to  radio  or  television  reception,  which  can  be  determined  by  turning  the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.  Body-worn Operation This  device  was  tested  for  typical  body-worn  operations.  To  comply  with  RF  exposure requirements,  a  minimum  separation  distance  of  1.5  cm  must  be  maintained  between  the  user’s body  and  the  handset,  including  the  antenna.  Third-party  belt-clips,  holsters,  and  similar accessories  used  by  this  device  should  not  contain  any  metallic  components.  Body-worn accessories that do  not meet  these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.

Navigation menu