TENDA TECHNOLOGY A9 Wireless N300 Universal Range Extender User Manual
SHENZHEN TENDA TECHNOLOGY CO., LTD. Wireless N300 Universal Range Extender Users Manual
Users Manual
LED
Button
Red
Blinking Slowly:
Green
Solid:
Orange
Solid:
Solid: The device is starting
The device is negotiating with a router/AP
Detecting signal with auto-extending feature (hasn't developed yet)
The device is performing WPS negotiation to a router/AP
Extended successfully, the WiFi signal is strong
Extended successfully, the WiFi signal is poor
Extended successfully, the WiFi signal is very poor
Blinking quickly:
Blinking:
Use the end of a paper clip or a similar object to press and hold this button for
about 8 seconds, and then release it to restore the extender to factory settings.
Press this button and then (within 2 minutes) press WPS button on a router/AP
to establish a WPS connection.
RST
Launch a web browser, type the default login domain name
or default login IP address into
the address bar, and tap on the keyboard.
re.tenda.cn 192.168.0.254
Enter
Extended successfully.
The device is performing extending process.
Wait for a moment.
Select the WiFi name (SSID) you want to extend, and click
Next.
Tips 1. You can also log in to the extender's web UI to check the WiFi signal strength
(40%~79%
2. Keep the extender away from Bluetooth devices, microwave, refrigerator, etc.
to minimize
is the optimum extending location).
signal interference.
Select WiFi Name > Enter Password
FinishBack
Base Station WiFi Name: Tenda_666666
Set up the extender's WiFi name and
password to the same as those of the Base
Station
........
√
Install Guide
Wireless N300 Universal Range Extender
Model: A9
Tips
Set up the extender's WiFi name
and password to the same as those of the Base Station
Finish.
If you don't want to set up the extender's WiFi name and password to the same as those
of the selected WiFi name, uncheck the option before
, customize the extender's
WiFi name and password, and then click
WiFi Name: Tenda_666666
WiFi Password: 00000000
WiFi Name: Tenda_666666
WiFi Password: 00000000
Poor Signal
Solid Orange
Internet
Blinking Orange Solid Green
Keep moving the extender to outlets
closer to the router until the LED indicator
on the extender lights solid green.
Recommended
extending location
Extending…Please wait… Extended Successfully!
The WiFi name of the extender is changed into
Tenda_666666, Please connect again.
FCC ID:V7TA9
IC:9034A-A9
MAC: C 83A35 XXXXX X
SSID: Tenda_XXXXXX
S/N:
Wireless N300 Universal Range Extender
Default Access: re.tenda.cn
Power: AC100-240V 0.3A 50/60Hz
Model: A9
Made in China
w tendacn.comww.
Next
Select WiFi Name > Enter Password
Please select a WiFi name…
Tenda_666666
Tenda_office
Tenda_ceshi
Tenda_ssid
Tenda_1EEFD8
Select WiFi Name Encryption/Signal Strength
New Tab
re.tenda.cn
Plug the extender (A9) into an electrical outlet near
your wireless router.
1
Enter the WiFi password of the selected WiFi name
(if any), and click Finish.
5
Relocate the extender to other electrical outlet. Observe the LED indicator on the
extender to choose an optimum extended location for best WiFi performance.
8Enjoy your WiFi! The extender's WiFi name and password are the same as those of your
router.
9
Tips 1. You can also log in to the extender's web UI to check the WiFi signal strength
(40%~79%
2. Keep the extender away from Bluetooth devices, microwave, refrigerator, etc.
to minimize
is the optimum extending location).
signal interference.
WiFi Name: Tenda_666666
WiFi Password: 00000000
WiFi Name: Tenda_666666
WiFi Password: 00000000
Poor Signal
Solid Orange
Internet
Blinking Orange Solid Green
Keep moving the extender to outlets
closer to the router until the LED indicator
on the extender lights solid green.
Recommended
extending location
Relocate the extender to other electrical outlet. Observe the LED indicator on the
extender to choose an optimum extended location for best WiFi performance.
3Enjoy your WiFi! The extender's WiFi name and password are the same as those of your
router.
4
2
6
4
7
3
Use your computer to search and connect to the extender's
WiFi. The default WiFi (SSID: Tenda_XXXXXX) is on the
product label on the extender's back panel.
Press the WPS button on your router, and then (within 2 minutes) press the button
on the extender.
When the LED indicator turns to solid green,
it indicates that a successful WPS connection
has been established.
Press
Position the antennas as shown in the figure below for best WiFi performance.
Q1: I cannot log in to the extender's User Interface, what should I do?
192.168.0.254 re.tenda.cn Enter
re.tenda.cn Enter
Q2: What should I do if my router has no WPS button?
Option 1: Use Web Browser to Extend Your WiFi
A1:
Before extending
1.Use your computer to connect to the WiFi name (SSID) on the label of the extender's back panel;
2.Launch a web browser, type or into the address bar and tap on
keyboard.
After extending
1.Use your computer to connect to the extended WiFi name (if you customize the WiFi name of the
extender, connect that);
2.Launch a web browser, type into the address bar and tap on the keyboard.
A2: Folow to set up the extender.
the
FAQ
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the radiator & your body.
(1) The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications
to this equipment. (2) To avoid unnecessary radiation interference, it is recommended to use a shielded RJ45 cable.
IC RSS warning
Industry Canada(RSS-Gen Issue 4)
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-
102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
Le dispositif rencontre l’exemption des limites courantes d’évaluation dans la section 2.5 de RSS 102 et la conformité à
l’exposition de RSS-102 rf, utilisateurs peut obtenir l’information canadienne sur l’exposition et la conformité de rf.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This
equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your
body.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu'aucune autre antenne ou émetteur. Cet
équipement devrait être installé et actionné avec une distance minimum de 20 centimètres entre le radiateur et votre
corps
NOTE:
Technical Support
Copyright
Address Info:
United States Hotline: 1-800-570-5892 Canada Hotline: 1-888-998-8966
Skype: Tendasz
© 2016 Shenzhen Tenda Technology Co., Ltd. All rights reser ved.
Tenda is a registered trademark legally held by Shenzhen Tenda Technology Co., Ltd. Other brand and product names
mentioned herein are trademarks or registered trademarks of their respective holders. Specifications are subject to
change without notice.
6-8 Floor, Tower E3, NO.1001, Zhongshanyuan Road, Nanshan District, Shenzhen, China. 518052
HongKong Hotline: 00852-81931998
Website: http:// www.tendacn.com E-mail: support@tenda.com.cn
Be vertical to the ground
Wall Outlet
Power Strip
CE Mark Warning
NOTE:
Declaration of Conformity
FCC Statement
This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user
may be required to take adequate measures.
(1) The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications
to this equipment. (2) To avoid unnecessary radiation interference, it is recommended to use a shielded RJ45 cable.
Hereby, SHENZHEN TENDA TECHNOLOGY CO., LTD., declares that the radio equipment type A9 is in compliance with
Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
http://www.tendacn.com/en/service/page/ce.htm
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful
l
Operate Frequency：2412-2472 MHz EIRP Power(Max.)：19.5 dBm Software Version：V12.01.01.09
interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouraged
to tr y to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications
to this equipment.
Radiation Exposure Statement
Use Web Browser to Extender Your WiFi
Option 1:
Use WPS Button to Extender Your WiFi
Option 2:
The LED indicator on the extender
will be solid red when it is starting;
and then starts blinking indicating
successful star t.
The LED indicator on the extender
will be solid red when it is starting;
and then starts blinking indicating
successful star t.
Plug the extender (A9) into an electrical outlet near your wireless router
(with WPS enabled).
1 2