TIC Audio BA2 Bluetooth Speaker User Manual AS350 manual
TIC Audio Inc Bluetooth Speaker AS350 manual
15_BA2 UserMan
Bilbao Bilbao Please follow the instruction in this guide to enjoy the best sound. Bilbao Short press to turn on speaker. Long press to turn off. When the speaker is on, short press to switch between Bluetooth (blue light) and AUX (green light) Increase the volume Decrease the volume Short press for Bluetooth discovery mode. Long press for Bluetooth "Twins" mode (see next section). Bluetooth Twins (additional speaker required) 1) Bluetooth Twins mode is only available with two TIC Bilbao speakers. 2) Turn on both speakers in Bluetooth mode. 3) Long press the "M" buttons on both speakers until you hear a double tone and see quick blue flashing light. 4) If successfully paired, a second double tone is played. A blue light would indicate the Main speaker while a red light would indicate the Pairing speaker. 5) Connect audio device to Main speaker and play music as previously instructed. Note: 1) While in "Twins" mode, control will be only be available via the Main speaker (except for the power off function in the Pairing speaker). 2) The Main speaker will act as the left channel speaker while the Pairing speaker will act as the right channel speaker. 3) If powered off and back on, the two speakers should reconnect automatically. If not, please repeat the step above to set up "Twins" mode. 1) Turn on NFC on a NFC-enabled device. (Refer to device's instruction manual if unsure on how to turn on NFC.) 2) Put device near the NFC area and follow instruction on device when prompted for easy pairing. Power Adapter Connection Safety and Maintenance Bilbao/BA2 Product: Bluetooth Speaker 8.1" x 7.4" x 7.4" NFC for easy pairing Plastic/ Cloth Optional stereo "Twins" mode (additional speaker required) IMPORTANT SAFETY INSTRUCTIONS: 1)Read these instructions. 2)Keep and follow all instructions. 3)Heed all warnings. 4)For indoor products, do not use this apparatus near water. For outdoor products, please do not expose apparatus to water longer than its intended time and level. 5)Clean only with a dry cloth. 6)Do not install this apparatus near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. 7)Do not block any ventilation openings. Install this apparatus in accordance with the manufacturer's instructions. 8)Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A ground-type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 9)Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles and the point where they exit from the apparatus. 10)Use only attachments and accessories specified by the manufacturer. 11)Unplug this apparatus during lightning storms or when unused for long periods of time. 12)Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as when the power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, or the apparatus had been exposed to rain or moisture, does not operate normally or has been dropped. 13)Do not expose this apparatus to dripping or splashing, and ensure that no objects filled with liquids, such as vases, are placed on the apparatus. 14)To disconnect this apparatus from the AC mains completely, disconnect the power supply cord plug from the AC receptacle. 15)The mains plug of the power supply cord shall remain readily operable. 16)Do not expose batteries to excessive heat such as sunshine, fire, or the like. 17)This is not a children's product and is not intended for use by children under 14 years old. CAUTION: Risk of Electric Shock. Do Not Open. The lightning flash with an arrowhead symbol, within an equilateral triangle, is intended to FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. Note 2: 1.Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 2. The minimum separation generally be used is at least 20 cm.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Profile CMM Type : Lino Profile Version : 2.1.0 Profile Class : Display Device Profile Color Space Data : RGB Profile Connection Space : XYZ Profile Date Time : 1998:02:09 06:49:00 Profile File Signature : acsp Primary Platform : Microsoft Corporation CMM Flags : Not Embedded, Independent Device Manufacturer : IEC Device Model : sRGB Device Attributes : Reflective, Glossy, Positive, Color Rendering Intent : Perceptual Connection Space Illuminant : 0.9642 1 0.82491 Profile Creator : HP Profile ID : 0 Profile Copyright : Copyright (c) 1998 Hewlett-Packard Company Profile Description : sRGB IEC61966-2.1 Media White Point : 0.95045 1 1.08905 Media Black Point : 0 0 0 Red Matrix Column : 0.43607 0.22249 0.01392 Green Matrix Column : 0.38515 0.71687 0.09708 Blue Matrix Column : 0.14307 0.06061 0.7141 Device Mfg Desc : IEC http://www.iec.ch Device Model Desc : IEC 61966-2.1 Default RGB colour space - sRGB Viewing Cond Desc : Reference Viewing Condition in IEC61966-2.1 Viewing Cond Illuminant : 19.6445 20.3718 16.8089 Viewing Cond Surround : 3.92889 4.07439 3.36179 Viewing Cond Illuminant Type : D50 Luminance : 76.03647 80 87.12462 Measurement Observer : CIE 1931 Measurement Backing : 0 0 0 Measurement Geometry : Unknown Measurement Flare : 0.999% Measurement Illuminant : D65 Technology : Cathode Ray Tube Display Red Tone Reproduction Curve : (Binary data 2060 bytes, use -b option to extract) Green Tone Reproduction Curve : (Binary data 2060 bytes, use -b option to extract) Blue Tone Reproduction Curve : (Binary data 2060 bytes, use -b option to extract) Page Count : 13 Create Date : 2016:10:24 15:39:51+08:00 Modify Date : 2016:10:24 15:39:51+08:00 Producer : Corel PDF Engine Version 17.1.0.572 Author : Administrator Creator : CorelDRAW X7 Title : AS350 manual.cdrEXIF Metadata provided by EXIF.tools