TRIMBLE EUROPE 10900310 Rugged Smart Phone User Manual MobileMapper50 WiFi Quick blue
TRIMBLE EUROPE BV Rugged Smart Phone MobileMapper50 WiFi Quick blue
User Manual
MobileMapper 50 Quick Start Guide Specification Product Name Model Name LCD DISPLAY UNIT SIZE WEIGHT BATTERY FRONT CAM BACK CAM Operating temperature operating voltage Rugged Smart Phone MobileMapper50_WiFi 5.3 1280X720 BRIGHTNESS 400 164x82x14.6 278g 3100mAh 2M 8MP,FLASH Software Set -20°C – 60°C 3.5V-4.2V Unpacking • MobileMapper 50 unit • USB cable • International battery charger • Two spare screen protection films This package does not include the headset for device Front and Rear Views Front Camera Lens * Headphone Function Key 1 Function Key 2 External GNSS Antenna Input Power Button Speaker Rear Camera Lens Power/Data Connector ** Volume Battery Trapdoor Lever This recess to eject the battery trapdoor Battery Trapdoor Touch Screen Home Menu Reset button Lanyard Eye Return Micro USB *: Depending on model ** :Not used Installing Card (SD) Install the card BEFORE inserting the battery: Slide the battery trapdoor lever downward. Then use a flat, rigid plastic strip that you insert into the recess (see picture) to eject the battery trapdoor. Orient the cards as illustrated, contact side facing down, before pushing them in. Inserting the Battery. Insert the battery gently into the compartment, making sure the electrical contacts of the battery are pushed against those located in the battery compartment. Put the trapdoor back in place: First insert its two legs into the lower part of the unit, then push the trapdoor against the unit, gradually from bottom to top, using your two thumbs, until you reach the top of the trapdoor. Then slide the lever upward with a thumb. Charging the Battery before First Use Use the USB cable provided: Connect the small end to the device’s Micro USB connector, and the other end either to a USB connector on your computer, or to the battery charger. In the latter case, connect the charger to a power outlet after choosing the adapter that is suitable in the country of use. Then whatever the charging source used, wait until the screen reports a fully charged battery. Turning on MobileMapper 50. Hold the power button depressed until the splash screen appears. Using MobileMapper 50. Refer to the documentation of the Android application you wish to use so you can safely install and run this application. Entering/Quitting the Sleep Mode. When active, this mode allows you to save battery power while keeping the unit running in the background. To enter the sleep mode, just press the Power button briefly. To return to normal operating mode, press this button again. Turning Off MobileMapper 50. Hold the power button depressed until the shutdown message is displayed. Select Shutdown and touch OK. CAUTION: This product contains a rechargeable Li-ion battery. Please refer to the regulations in force in your country concerning the use and transportation of Li-ion batteries. P/N 631676 © 2016 Trimble Navigation Limited. All rights reserved. Spectra Precision is a Division of Trimble Navigation Limited. Spectra Precision and the Spectra Precision logo are trademarks of Trimble Navigation Limited or its subsidiaries. This product is protected by US and international copyright, trademark and patent law. Revision A. www.spectraprecision.com MobileMapper 50 Quick Start Guide Basics Power on Make sure that the battery is charged for at least 30 minutes before you turn on the device at the first time. 1. Press the power key until the device vibrating . 2. Wait a while for the device to start. To activate the screen, please press the power key firstly. Setting up your device A quick guide book will help you to configure the basic system settings. For example, sign in the account (your googleTM account) . Accessing Settings View and change settings for your device form the Settings menu. The Settings menu is accessible from both the Applicationg screen and the Quick settings panel. To access your device settings 1. From your Home screen, tap 2. Find and tap Key function Basic applications and settings Function key Button A Function key Button B Use the Messaging application to send and receive text and multimedia messages. Go to Goole PlayTM to download free and paid applications for your device. Web browsing In WIFI and data network. Use the camera application to take photos and video by front and back camera. Optimise the device settings to suit your own requirements. WLAN connection Enter settings menu, WLAN interface, turn WLAN on and select Wi-Fi hotspot, enter password to connect Wi-Fi. If the Wi-Fi hotspot does not have the password, the system will connect Wi-Fi automatically. Notification and quick settings Application screen Open the Application screen. Back button Return to the previous interface or exit the application. Home button one time click - Exit the application returns to the main interface. Long pressing – Searching assistant for operating APPs overview. Manu button Open the application list of most recently used. Note: Enter Settings-button Modify the Home button long press function and the menu button click function. Function Key button A Press this button A will enter the U-center application. Function Key button B Press this button B will enter the camera application. Please note: The Function of Button A and Button B could be modified by entering the Setting Menu. Open and close the Notification panel 1. To open the Notification panel, drag the status bar downwards. 2. To close the Notification panel, drag the panel upwards. MobileMapper 50 Quick Start Guide PRODUCT SAFETY WARNINGS Use responsibly. Read all instructions and safety information before use to avoid injury.The maximum operating ambient temperature of the equipment declared by the manufacturer is 60°C. Battery safety Charge battery only at ambient temperatures ranging from 0°C to 60°C. (1) CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type of battery recommended by the manufacturer. Dispose of used batteries according to battery manufacturer’s instructions. (2) CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. (3) CAUTION:Charging temperature upper limit is 45°C. Charger safety When charging, please place the device in an environment that has a normal room temperature and good ventilation. It is recommended to charge the device in an environment with a temperature that ranges from 0°C~40°C. Camflash safety LED is only used as indicating light. Wi-Fi Safety Turn Wi-Fi off in areas where Wi-Fi use is prohibited or when it may cause interference or danger, such as in airplanes while flying. Care & Maintenance Excessive sound pressure from earphones and headphones can cause hearing loss. USB data cables CAUTION: Use of USB data cables is restricted to standard USB version 2.0 or higher.Powered USB is prohibited. Lanyard Use the lanyard responsibly. It is primarily designed to ease hand-held use of the product (limb-worn). The lanyard should not be used to attach the product next to the body. FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must not accept any interference received, including interference that may cause undesired operation. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Author : lijingjing Create Date : 2016:08:23 15:24:17+08:00 Modify Date : 2016:08:23 15:40:03+08:00 XMP Toolkit : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03 Format : application/pdf Title : MobileMapper50_WiFi Quick-blue Creator : lijingjing Metadata Date : 2016:08:23 15:40:03+08:00 Creator Tool : Adobe Illustrator CS5 Thumbnail Width : 256 Thumbnail Height : 88 Thumbnail Format : JPEG Thumbnail Image : (Binary data 12377 bytes, use -b option to extract) Instance ID : uuid:bd34d228-7cd5-4345-a55d-f768106fa8cc Document ID : xmp.did:58C793E4B84FE611A696CA2F4455E213 Original Document ID : uuid:5D20892493BFDB11914A8590D31508C8 Rendition Class : proof:pdf Derived From Instance ID : uuid:ec468cc8-770c-4083-8112-e0624c0aa55e Derived From Document ID : xmp.did:293f358e-4f13-c44b-8890-989421269c06 Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8 Derived From Rendition Class : proof:pdf History Action : saved, saved, saved History Instance ID : xmp.iid:25B077991E17E6119D0FCE8E575C7E14, xmp.iid:293f358e-4f13-c44b-8890-989421269c06, xmp.iid:58C793E4B84FE611A696CA2F4455E213 History When : 2016:05:11 14:32:01+08:00, 2016:07:19 15:21:49+08:00, 2016:07:22 14:37:46+08:00 History Software Agent : Adobe Illustrator CS5, Adobe Illustrator CC 2015 (Windows), Adobe Illustrator CS5 History Changed : /, /, / Manifest Link Form : EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference, EmbedByReference Manifest Reference File Path : E:\2016work\EE7738\认证说明书\WLAN.png, D:\桌面\用户手册0614更新\icon-4.jpg, D:\桌面\用户手册0614更新\icon-5.jpg, D:\桌面\用户手册0614更新\icon-1.jpg, D:\桌面\用户手册0614更新\icon-3.jpg, D:\桌面\用户手册0614更新\blue-1.jpg, D:\桌面\用户手册0614更新\blue-2.jpg, D:\桌面\用户手册0614更新\blue-3.jpg, D:\桌面\粘贴图片.png, D:\桌面\1-2.jpg, D:\桌面\1-3.jpg Manifest Reference Document ID : 0 Manifest Reference Instance ID : 0 Ingredients File Path : E:\2016work\EE7738\认证说明书\WLAN.png, D:\桌面\用户手册0614更新\icon-4.jpg, D:\桌面\用户手册0614更新\icon-5.jpg, D:\桌面\用户手册0614更新\icon-1.jpg, D:\桌面\用户手册0614更新\icon-3.jpg, D:\桌面\用户手册0614更新\blue-1.jpg, D:\桌面\用户手册0614更新\blue-2.jpg, D:\桌面\用户手册0614更新\blue-3.jpg, D:\桌面\粘贴图片.png, D:\桌面\1-2.jpg, D:\桌面\1-3.jpg Ingredients Document ID : 0 Ingredients Instance ID : 0 Startup Profile : Print Has Visible Overprint : False Has Visible Transparency : True N Pages : 1 Max Page Size W : 21.000166 Max Page Size H : 29.699994 Max Page Size Unit : Centimeters Font Name : ArialMT, Arial-BoldMT, TradeGothicLTStd-Bold, Arial-Black, AdobeSongStd-Light Font Family : Arial, Arial, Trade Gothic LT Std, Arial, Adobe 宋体 Std Font Face : Regular, Bold, Bold, Black, L Font Type : Open Type, Open Type, Open Type, Open Type, Open Type Font Version : Version 5.06, Version 5.06, OTF 1.029;PS 001.002;Core 1.0.33;makeotf.lib1.4.1585, Version 5.06, Version 5.017;PS 5.002;hotconv 1.0.67;makeotf.lib2.5.33168 Font Composite : False, False, False, False, False Font File Name : arial.ttf, arialbd.ttf, TradeGothicLTStd-Bold.otf, ariblk.ttf, AdobeSongStd-Light.otf Plate Names : Cyan, Magenta, Yellow, Black Swatch Groups Group Name : 鲜艳 Swatch Groups Group Type : 1 Swatch Groups Colorants Swatch Name: C=60 M=90 Y=0 K=0 Swatch Groups Colorants Mode : RGB Swatch Groups Colorants Type : PROCESS Swatch Groups Colorants Red : 126 Swatch Groups Colorants Green : 49 Swatch Groups Colorants Blue : 142 Producer : Acrobat Distiller 11.0 (Windows) Page Count : 4EXIF Metadata provided by EXIF.tools