TRIMBLE EUROPE 802111A MobileMapper 100, ProMark 100 and ProMark 200 User Manual CE FCC Canada LegalNotes Print

TRIMBLE NANTES S.A.S. MobileMapper 100, ProMark 100 and ProMark 200 CE FCC Canada LegalNotes Print

Contents

user manual 2 of 2

Notification for Ashtech MobileMapper 100,ProMark 100 and ProMark 200 Handheld PlatformsCEa. Caution:• Risk of explosion if battery replaced by an incorrect type. • Dispose of used batteries according to the instructions. b. Please make sure the temperature for adapter will not be higher than 40 ˚C. FCCFCC Regulations:This device complies with part 15 of the FCC Rules. Opera-tion is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential in-stallation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in ac-cordance with the instructions, may cause harmful interfer-ence to radio communications. However, there is no guarantee that interference will not occur in a particular in-stallation if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and re-ceiver.• Connect the equipment into an outlet on a circuit differ-ent from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.The antenna(s) used for this transmitter must not be co-locat-ed or operating in conjunction with any other antenna or transmitter. RF Exposure Information (SAR)This device meets the government’s requirements for expo-sure to radio waves.This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government.The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certi-fied power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well be-low the maximum value. This is because the device is de-signed to operate at multiple power levels so as to use only the poser required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the pow-er output.The highest SAR value for the device as reported to the FCC when worn on the body, as described in the user guide, is 0.39 W/kg for GSM850 / 1.23 W/kg for PCS1900 (Body-worn measurements differ among device models, depending upon available accessories and FCC requirements.)While there may be differences between the SAR levels of various devices and at various positions, they all meet the government requirement.The FCC has granted an Equipment Authorization for this de-vice with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this device is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: NZI802111A.This device is compliant with SAR for general population /un-controlled exposure limits in ANSI/IEEE C95.1-1999 and had been tested in accordance with the measurement meth-ods and procedures specified in OET Bulletin 65 Supplement C.For body worn operation, this device has been tested and meets the FCC RF exposure guidelines for use with an acces-sory that contains no metal and the positions the handset a minimum of 0.5 cm from the body. Use of other accessories may not ensure compliance with FCC RF exposure guide-lines. If you do not use a body-worn accessory and are not holding the device at the ear, position the handset a mini-mum of 0.5 cm from your body when the device is switched on. ICOperation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.This Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.This Category II radio communication device complies with Industry Canada Standard RSS-310.Ce dispositif de radiocommunication de catégorie II respecte la norme CNR-310 d’Industrie Canada. IMPORTANT NOTE:IC Radiation Exposure StatementThis EUT is compliant with SAR for general population/un-controlled exposure limits in IC RSS-102 and had been test-ed in accordance with the measurement methods and procedures specified in IEEE 1528. This equipment should be installed and operated with minimum distance 0.5 cm be-tween the radiator & your body.This device and its antenna(s) must not be co-located or op-erating in conjunction with any other antenna or transmitter.The County Code Selection feature is disabled for products marketed in the US/Canada.

Navigation menu