Taiyo A14249 Remote Control Transmitter User Manual CR inst 1 4

Taiyo Co., Ltd. Remote Control Transmitter CR inst 1 4

users manual

Download: Taiyo A14249 Remote Control Transmitter User Manual CR inst 1 4
Mirror Download [FCC.gov]Taiyo A14249 Remote Control Transmitter User Manual CR inst 1 4
Document ID186392
Application IDAMr94A0HX3dtEIypoNGMFg==
Document Descriptionusers manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize21.08kB (263518 bits)
Date Submitted2001-12-19 00:00:00
Date Available2001-12-18 00:00:00
Creation Date2001-11-06 17:40:08
Producing SoftwareAdobe PDF library 4.800
Document Lastmod2001-11-30 13:41:31
Document TitleCR inst 1-4.pdf
Document CreatorAdobe Illustrator 9.0.2

R/C Facts for Improved Operation
1. When batteries start to discharge, vehicle may slow, stop, or refuse to respond to
your control. It's time to replace both vehicle batteries and/or remote battery. This is
absolutely the #1 cause of all problems and questions! Observe polarity when
replacing batteries.
2. Radio frequency interference can interfere with the control of your vehicle.
Buildings, power wires, other R/C remotes, or CB radio can all cause problems. Pick a
place to drive that's away from these things.
3. Hold remote so antenna points up, not toward the vehicle. Keep vehicle within
range (about 30 to 40 feet) to keep control. If vehicle goes out of range, try lifting
remote high into air to increase range.
4. Wipe vehicle clean and dry after each use, including inside battery compartments.
5. Turn vehicle power switch off immediately after running. Remove batteries for
storing or shipping. Keep vehicle and Remote away from heat and direct sunlight and
moisture.
6. Do not run vehicle in or near water.
Troubleshooting Guide
Don't take your vehicle back to the store--try solving problems using this valuable
guide.
Problem
Probable Cause
Correction
Vehicle runs slowly, or
won't move, or won't steer
• Batteries dead or low charge
• Batteries installed incorrectly
in remote or vehicle
• Loose battery connection
• Dirty battery or battery
compartment contacts
• Power switch is off
• Install 2 fresh new "AA" alkaline cells
• Remove and replace batteries, making
sure battery direction (polarity, +/-) is
correct and battery compartment contacts,
plug and socket are clean.
• Replace remote battery.
• Turn on Power switch.
Erratic operation, loss of
control, short range
• Radio interference
• Loose or curled
remote antenna
• Antenna touching hands
or body
• Weak remote battery
• Weak vehicle batteries
• Move to another location.
• Extend antenna fully. Point up in the air,
not at vehicle.
• Don't touch antenna during operation.
• Replace both vehicle batteries and / or
remote battery
Vehicle stops working after
going through water, mud
or snow
• Water in battery, electronics
or motor areas
• Any time vehicle is run through water,
turn power knob off IMMEDIATELY,
remove batteries, dry inside and out with
clean soft cloth and allow to dry overnight
with battery door open. Always avoid wet
surfaces, puddles or rain.
COMPLIANCE WITH FCC REGULATIONS
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION OF THIS DEVICE IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE.
(2) THIS DEVICE MUST ACCEPT ANY HARMFUL INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
This device generates and uses radio frequency energy and if not used properly may cause interference to
radio and television reception. It has been tested and found to comply with the limits set by the FCC, which are
designed to provide reasonable protection against such interference.
CAUTION: FCC Regulations state that changes or modifications to this product not expressly approved by the
party responsible for compliance could void the user's authority to operate the equipment.
PRINTED IN CHINA
© 2001 Taiyo Edge Ltd. Co., P.O. Box 1470, New Smyrna Beach, FL 32170, U.S.A. All Rights Reserved. U.S. and Foreign Patents
Pending.Taiyo Edge; Get the Edge!; On Road, Off-Road, No Road!; and Cell Racer are licensed trademarks of Tilbor Marketing and
Development Inc. Product specifications subject to change. Product may differ from illustrations.
™
TM
Taiyo Edge™ R/C Consumer Service
We want to assist you!
DO NOT RETURN THE PRODUCT TO THE STORE!
Log on: Click “Help/Service” at www.taiyoedge.com
E-mail: help@taiyoedge.com
90-DAY LIMITED WARRANTY
(a copy of this warranty is inside)
TOLL-FREE CONSUMER HELPLINE NUMBER
1-866-4-EDGE-RC (1-866-433-4372)
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. THEY CONTAIN IMPORTANT
INFORMATION.
Important! Please read your Owner's Manual all the way through before operating your
vehicle.
Safety First
• Drive your vehicle in a safe area away from people, pets, cars, etc. Not in streets, in or
near water, or in darkness!
• Don't touch or try to pick up vehicle when it is in motion. Wait until it stops
completely.
• Keep hair, fingers, face and loose clothing away from wheels while the vehicle is
switched on or while the remote is operating.
• Be a responsible Cell Racer™ R/C operator!
Batteries Required (not included)
2 "AA" Alkaline batteries required for vehicle. One 9-Volt Alkaline battery required for
the remote.
READ AND FOLLOW ALL INSTRUCTIONS
IMPORTANT BATTERY SAFETY INFORMATION
CAUTION: TO AVOID BATTERY LEAKAGE
• Make sure the batteries are inserted with the correct polarity and follow the toy and
battery manufacturers' instructions.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium or
nickel-metal hydride) batteries.
• Remove weak or exhausted batteries from the product.
ADDITIONAL IMPORTANT BATTERY SAFETY
INFORMATION
• An adult should help with battery replacement
• Only batteries of the same or equivalent type as recommended in the "Battery
Installation" (or replacement) instructions are to be used.
• Non-rechargeable batteries are not to be recharged.
• If removable rechargeable batteries are used, they are only to be charged under adult
supervision.
• Rechargeable batteries are to be removed from the product before they are charged.
• If you use a battery charger, it should be examined regularly for damage to the cord,
plug, enclosure and other parts. Do not use a damaged battery charger until it has
been properly repaired.
• Dispose of batteries safely and properly.
Vehicle Battery Installation
1. Slide vehicle BATTERY DOOR open and remove as shown. (Fig. 1)
2. Insert 2 fresh, new Alkaline batteries into battery compartment as
shown. IMPORTANT: OBSERVE BATTERY POLARITY (DIRECTION, +
AND -). (Fig. 2)
3. Replace BATTERY DOOR and slide closed until it latches. (Fig. 3)
Remote Battery Installation
1. Slide open BATTERY DOOR on REMOTE and remove. (Fig. 4)
2. Insert a fresh, new 9-VOLT ALKALINE BATTERY with the polarity
(+/-) as shown on the bottom of battery compartment. (Fig. 5)
3. Replace BATTERY DOOR and slide it closed to secure. (Fig. 6)
Fig 4
Fig 1
Fig 5
Fig 2
Fig 3
Fig 6
ANTENNA
Extend antenna fully for operation. Hold Remote so antenna points straight up
in the air. Don't touch during operation.
Forward
Right Forward
Left Forward
Left
Right
Fig 7
Remote Operation
Press and hold a "dialing" button to move the vehicle in the direction
shown by the arrow on the button. Release button for "neutral."
POWER
SWITCH
Note: There is no on/off switch on Remote. Pressing the buttons turns it
on. Releasing the buttons turns it off.
Right Reverse
Left Reverse
Reverse
R/C Tip
In order to race or operate two vehicles together, they must
be different frequencies. Check the package and the bottom
of your vehicle for the frequency label.
Vehicle Operation
1. Turn on POWER SWITCH on bottom of vehicle. (Fig. 7)
2. Vehicle operates best on flat, smooth, surfaces. KEEP AWAY
FROM WATER, SNOW AND WET SURFACES.
3. If vehicle steers slightly to one side or the other when you
press a button to go straight, move the TRIM TAB on the
bottom in the opposite direction, a little at a time. (Drive vehicle
away from you to test.) Repeat if necessary. (Fig. 8).
TRIM
TAB
Fig 8

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Create Date                     : 2001:11:06 17:40:08-08:00
Creator                         : Adobe Illustrator 9.0.2
Producer                        : Adobe PDF library 4.800
Title                           : CR inst 1-4.pdf
Modify Date                     : 2001:11:30 13:41:31-05:00
Creator Version                 : 9
Container Version               : 9
For                             : virginia Tsai,
Bounding Box                    : 15 -718 784 -9
Page Count                      : 2
EXIF Metadata provided by EXIF.tools
FCC ID Filing: AEKA14249

Navigation menu