Targus 000070 Wireless BlueTrace Mouse User Manual manual

Targus International LLC Wireless BlueTrace Mouse manual

manual

    2.4GHz Wireless   Windows 8 hot key BlueTrace Mouse w/Nano Receiver  USER'S GUIDE Ver.:1.00             CAUTION: To use this product properly, please read the user's guide before installing.
 1 Functional Introduction              Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the battery as shown inside the battery compartment. Step 3: Replace the cover.           **Warning: *Please insert the battery with the correct position according to the instruction     AA Battery Left button Right button Battery Cover Metallic Wheel Connect  Button  ON/OFFSwitch Nano Receiver LED Indicator Pull Charms Menu SwitchingAPP
 2   labeled on the mouse. Setup the Connection between the Receiver and the Mouse  1. Insert the battery into the mouse, then follow the steps below. 2. In the meantime, to open the mouse under the cover, take the nano     receiver out.           3. Plug the Nano receiver into the USB port on your computer.         4. If the mouse does not work, please put it into pairing mode. 5. Pairing: Re-plug the receiver into the USB port on your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again. (The receiver has auto pairing function). 6. The LED indicator on mouse flashes steadily when it is in pairing     mode and stops blinking when it is successfully paired with the   receiver.  7. When low battery, the battery indicator on the mouse will start to blink.
 3                         LED Indicator  *Mouse IndicatorLED is on for 3 sec.   Power ON LED Blinks for 3 times During Pairing (LED OFF when paired or failed after 10 sec.)LED Blinks for 10 sec. Low Battery Warning
 4 FCC warning  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.     These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.    However, there is no guarantee that interference will not occur in a particular installation.    If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:  -  Reorient or relocate the receiving antenna. -  Increase the separation between the equipment and receiver. -  Connect the equipment into an outlet on a circuit different from                       that to which the receiver is connected. -  Consult the dealer or an experienced radio/TV technician for help.  FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.  This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
 5 IC warning This device complies with Industry Canada licence-exempt RSS standard(s).Operation is subject to the following two conditions:   (1) This device may not cause interference, and   (2) This device must accept any interference, including interference that may cause undesired operation of the device.  Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.   L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le   fonctionnement  Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Navigation menu