Texas Instruments 76519 Radio Frequency Identification (RFID) User Manual FCC Declaration

FCC Declaration

HandHeld Unit (E.S.P)

Radio Frequency Interference Requirements

This device must operate in compliance with Federal Communications Commission (FCC) Rules and

Regulations Part 15.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

− Reorient or relocate the receiving antenna.

− Increase the separation between the equipment and receiver.

− Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

− Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including

interference that may cause undesired operation.

FCC ID A92-76519

This device does not contain any parts, which need service by the user.

Any change or modification not expressly approved by the party responsible for compliance can void

FCC certification and user’s authority to operate the equipment.

Do not open or modify.

P/N 76519

MX MSPN 73214