The Coleman 5357-5358-1-T Remote Control Fluorescent Lantern User Manual

The Coleman Company Inc. Remote Control Fluorescent Lantern

User manual

Download: The Coleman 5357-5358-1-T Remote Control Fluorescent Lantern User Manual
Mirror Download [FCC.gov]The Coleman 5357-5358-1-T Remote Control Fluorescent Lantern User Manual
Document ID17998
Application IDjfmxSh167/DrAAUJFlZi+Q==
Document DescriptionUser manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize7.37kB (92139 bits)
Date Submitted1998-12-30 00:00:00
Date Available1999-03-01 00:00:00
Creation Date1998-12-29 12:54:31
Producing SoftwarePhotoshop PDF Plug-in 1.0
Document Lastmod1998-12-29 12:54:54
Document TitleUser manual
Document CreatorPhotoshop PDF Plug-in 1.0

cgmManualfgr tbsBste 9.9939! Lantern
Specifications
9W U~tube operation with ‘High Range’, ‘Low Range’.
1.8W (12V 0.15A) night light bulb operation
8 X 1.5V ‘D‘ size alkaline battery for lantern.
1 X 12V alkaline battery for remote control transmitter.
1 Red LED on lantern housing to indicate the ‘Remote Control’ standby mode.
1 Green LED on remote control transmitter to indicate a signal is being transmitted
to the built-in receiver on the remote control lantern.
0.0...
Features
0 5 position rotary switch: ‘Remote Control’, 'Oft’. ‘High’, ‘Low’ & ‘Night Light”.
0 Manual operation of ‘High’ power, ‘Low’ power and ‘Night Light’.
O Remote control operation at a cyclic order (‘High’ power on, 'Low’ power on,
‘Night Light’ on, ‘Off’, ‘High‘ power on, ).
Remote Control Operation
0 Place 8 pieces of 'D’ size batteries into the lantern,
0 Place 1 piece of 12V battery into the transmitter,
0 Select ‘Remote Control’ on lantern switch, the Red LED will turn on to indicate the
remote control standby mode.
0 Press the button on the remote control transmitterto operate. The Green LED on
transmitter will turn on each time the button is pressed to indicate a signal is being
transmitted to the built-in receiver on lantern.
0 Remote control operating at a cyclic order (‘High’ power on, ‘Low' power on,
‘Night Light' on, ‘Off', ’High‘ power on, ).
0 Always turn ‘Off’ the’lantern after use
0 Always use new batteries in the lantern and the transmitter for most efficient
remote control operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment,
The Coleman Company, Inc.
3600 N. Hydraulic, Wichita, KS 67219 U.S.A.
Phone : 316 832 3056 Fax : 316 S32 6193
Contact : Rex Weigand
FCC ID: N8Q53S7-5338-1-T
mxmmwms
NOTE: This equipement has been tested and found to comply with the limits for an
ISM equipment, pursuant to Part 18 of the FCC Rules These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and. if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
[1 Reorient or relocate the receiving antenna.
D Increase the separation between the equipment and receiver.
I] Connect the equipment into an outlet on a circuit different from that to which the
receiver is needed.
El Consult the dealer or an experienced radio/TV technician for help.
Important: Do not leave discharged batteries in the lantern for long periods of time.
This could cause permanent damage to the lantern. it your lantern is damaged due to
battery leakage, refer to battery manufacturer‘s warranty for repair or replacement
1) To clean the outside of the lantern and globe, use only a damp cloth and mild dish
washing liquid. Excessive water and strong cleaner can damage the lantem.
2) For repair service, call for location of your nearest service center. if fluorescent
lantern must be returned to service center, attach your name, address, and a
description of problem to product and mail to service center.
The Coleman Company, Inc.
3600 N. Hydraulic, Wichita, KS 67219 U.S.A.
Phone : 316 832 3056 Fax : 316 832 6193
Contact : Rex Welgand
FCC ID: N8Q5357-5338-1-T

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Modify Date                     : 1998:12:29 12:54:54
Creator                         : Photoshop PDF Plug-in 1.0
Producer                        : Photoshop PDF Plug-in 1.0
Create Date                     : 1998:12:29 12:54:31
Page Count                      : 2
EXIF Metadata provided by EXIF.tools
FCC ID Filing: N8Q5357-5358-1-T

Navigation menu