Toy State 90440F27 Hyper Racer R/C Drift Rod User Manual
Toy State International Ltd. Hyper Racer R/C Drift Rod
User Manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 2268930 |
| Application ID | 9LQStw1+f8dYJzu/W7zRXg== |
| Document Description | User Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 112.71kB (1408824 bits) |
| Date Submitted | 2014-05-16 00:00:00 |
| Date Available | 2014-05-16 00:00:00 |
| Creation Date | 2014-04-14 17:11:31 |
| Producing Software | Adobe PDF Library 10.0.1 |
| Document Lastmod | 2014-05-15 20:59:17 |
| Document Title | User Manual |
| Document Creator | Adobe InDesign CS6 (Macintosh) |
CLEANING AND MAINTAINING Brush areas where dirt and dust get trapped. Wipe body off with a soft rag or tact cloth. Do not clean vehicle with chemicals or water. FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. INDUSTRY CANADA NOTICE: CANADA ONLY This radiocommunication device complies with all the requirements of Industry Canada Standard RSS-310. Operation is subject to the follwing two conditions: 1). This device may not cause harmful interference. 2). This device must accept any interference received, including interference that may cause undesired operation. Field Strength and measurement distance: 27.195MHz - 60.49 dBµ V/m at 3 meter. 49.890MHz - 61.61 dBdB V/m at 3 meter. This device complies with the limits of standard RSS-310 issue 1. MANUFACTURER’S NOTE “Modifications not authorized by the manufacturer may void users authority to operate the device.” ATTENTION PARENTS This toy and all accessories need to be periodically examined for potential hazards and any potentially hazardous parts be repaired or replaced. www.toystate.com For questions, e-mail our Consumer Service Dept. at consumerservice@toystate.com Or Call 1-877-473-8015 MADE IN SHENZHEN, CHINA TOY STATE INTERNATIONAL LIMITED 66 MODY ROAD, KOWLOON, HONG KONG WARNING: Not suitable for children under 36 months due to small parts. Choking hazard. HOT WHEELS and associated trademarks and trade dress are owned by, and used under license from Mattel. ©2014 Mattel. All Rights Reserved. IN THE INTEREST OF BETTER QUALITY AND VALUE, WE ARE CONSTANTLY IMPROVING AND UPDATING OUR PRODUCTS. CONSEQUENTLY, PICTURES IN THIS INSTRUCTION SHEET MAY SOMETIMES DIFFER FROM THE MODEL ENCLOSED. 90440_HWrc_IM_03212014_OP_FAR.indd 1 ENG 14/4/14 5:11 pm www.toystate.com 90440_HWrc_IM_03212014_OP_FAR.indd 2 14/4/14 5:11 pm OWNER’S MANUAL 6+ #90440 RADIO CONTROL HYPER RACER CONTROLLER VEHICLE 3 x AA/LR03 6 x AA/LR6 Batteries Not Included Included 90440_HWrc_IM_03212014_OP_FAR.indd 3 14/4/14 5:11 pm GETTING STARTED Remove the R/C vehicle and controller from the package. Insert batteries into the R/C vehicle and controller to begin full function play (see “Battery Installation” section for further details). CAUTION Important Battery Information • Dispose of batteries properly. • Do not dispose of batteries in fire. • Use only batteries of the type recommended. • Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. • Do not mix old and new batteries. • Remove batteries from R/C vehicle and controller if vehicle will not be used for a long period of time. BATTERY INSTALLATION CONTROLLER TO REPLACE THE BATTERIES 1. To remove battery cover, loosen screw to open. 2. Insert 3 “ AA ” batteries into the controller. Be sure the + and – are properly matched. LOOSEN SCREW TO OPEN LOOSEN SCREW TO OPEN R/C VEHICLE TO REPLACE THE BATTERIES 1.5V 1.5V 1. To remove battery cover, loosen screws to open. 1.5V LOOSEN SCREW TO OPEN 2. Insert 6 “AA” batteries into the vehicle. Be sure the + and – are properly matched. 1.5V 1.5V 1.5V NOTE: For best performance, always use alkaline batteries only. ENG 90440_HWrc_IM_03212014_OP_FAR.indd 4 14/4/14 5:11 pm OPERATING R/C VEHICLE PLAY Adjust Trim Switch on bottom of R/C vehicle to ensure precision driving Turn PLAY/DEMO switch located on bottom of R/C vehicle to the PLAY position (as shown) DEMO Turbo Mode Color Shifting Action Turn Left & Right Drive Forward & Reverse After play, always turn vehicle to “DEMO” mode. Remove batteries from controller and R/C vehicle when not in use or when storing. Leakage may occur and cause damage if left for a long period of time. Accelerate With Turbo Boost! Color Shifting Action! Turns In All Directions! 90440_HWrc_IM_03212014_OP_FAR.indd 5 ENG 14/4/14 5:11 pm TROUBLESHOOTING AND CARE FOR R/C VEHICLE INTERFERENCE Other radio signals may cause loss of control. Remove vehicle from an area of interference. LIMITED RADIO CONTROL RANGE While R/C vehicle may be visible at a distance, full operational control may be lost. Hold controller high in the air and direct vehicle back. • Are the + and – contacts correctly matched in the controller? • Are the metal contact tabs touching, rusty or dirty in controller? • Are there batteries in the vehicle and controller? • Is the power switch turned to play? • Are the batteries weak or out of power? R/C VEHICLE DOES NOT MOVE R/C VEHICLE MOVES BY ITSELF • There is radio interference in the area. • Another R/C vehicle with the same frequency is close by. R/C VEHICLE RUNS SLOWLY • There is radio interference in the area. • Another R/C vehicle with the same frequency is close by. • Are the batteries weak or out of power? PERFORMANCE DROP, INCONSISTENT MOVEMENT OR FAILS TO RUN Check batteries. If necessary, replace the batteries in the R/C vehicle and controller with new alkaline batteries. TREAT YOUR R/C VEHICLE WELL Radio waves control the R/C vehicle. Care for your vehicle and it will provide hours of fun! Avoid water, heat, sand and high impact crashes! Store in safe place. No direct sunlight. No rain or water. No Collisions. R/C vehicle may get stuck on carpet or grass. Avoid running 2 vehicles with the same radio control frequencies. ENG 90440_HWrc_IM_03212014_OP_FAR.indd 6 No sand or dust. 14/4/14 5:11 pm
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : Yes Tagged PDF : Yes XMP Toolkit : Adobe XMP Core 5.0-c060 61.134777, 2010/02/12-17:32:00 Create Date : 2014:04:14 17:11:31+08:00 Metadata Date : 2014:05:15 20:59:17+08:00 Modify Date : 2014:05:15 20:59:17+08:00 Creator Tool : Adobe InDesign CS6 (Macintosh) Thumbnail Width : 172 Thumbnail Height : 256 Thumbnail Format : JPEG Thumbnail Image : (Binary data 12388 bytes, use -b option to extract) Instance ID : uuid:2c6978d4-d623-5d44-9c91-36f2fd086b2c Original Document ID : xmp.did:01801174072068118EF18A0B71F41618 Document ID : xmp.id:1B68167407206811822A88E97362E769 Rendition Class : proof:pdf Derived From Instance ID : xmp.iid:1A68167407206811822A88E97362E769 Derived From Document ID : xmp.did:1A68167407206811822A88E97362E769 Derived From Original Document ID: xmp.did:01801174072068118EF18A0B71F41618 Derived From Rendition Class : default History Action : converted History Parameters : from application/x-indesign to application/pdf History Software Agent : Adobe InDesign CS6 (Macintosh) History Changed : / History When : 2014:04:14 17:11:31+08:00 Format : application/pdf Producer : Adobe PDF Library 10.0.1 Trapped : False N Pages : 1 Has Visible Transparency : True Has Visible Overprint : True Max Page Size W : 154.516667 Max Page Size H : 230.716667 Max Page Size Unit : Millimeters Font Name : DINOT-Bold, Helvetica-Condensed, Helvetica-Condensed-Bold, Helvetica-Condensed-BoldObl, Helvetica, HelveticaNeue-Condensed Font Family : DIN OT, Helvetica, Helvetica, Helvetica, Helvetica, Helvetica Neue Font Face : Bold, Medium Condensed, Bold Condensed, Bold Condensed Oblique, Medium, 57 Condensed Font Type : Open Type, Type 1, Type 1, Type 1, Type 1, Type 1 Font Version : Version 7.504; 2005; Build 1020, 001.001, 001.002, 001.002, 001.006, 001.000 Font Composite : False, False, False, False, False, False Font File Name : DINOT-Bold.otf, HelveCon; Helv_Condensed Screen Fonts, HelveConBol; Helv_Condensed Screen Fonts, HelveConBolObl; Helv_Condensed Screen Fonts, Helve; Adobe_Helv_Screens, HelveNeuCon; Helvetica Neue Condensed Plate Names : Cyan, Magenta, Yellow, Black Swatch Groups Group Name : Default Swatch Group Swatch Groups Group Type : 0 Page Count : 6 Creator : Adobe InDesign CS6 (Macintosh)EXIF Metadata provided by EXIF.tools