Tranwo Technology MDD24R2001 2.4GHz DIGITAL AV module User Manual
Tranwo Technology Corp 2.4GHz DIGITAL AV module
Users Manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 1489690 |
| Application ID | cwK59J/ltB//zRoS9gAsEA== |
| Document Description | Users Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 21kB (262475 bits) |
| Date Submitted | 2011-06-24 00:00:00 |
| Date Available | 2011-06-24 00:00:00 |
| Creation Date | 2011-06-22 16:45:34 |
| Producing Software | Bullzip PDF Printer / www.bullzip.com / Freeware Edition |
| Document Lastmod | 2011-06-22 16:47:02 |
| Document Title | Untitled |
| Document Creator | UnknownApplication |
| Document Author: | user |
AL MDD-24R2001 2.4GHz Digital Audio Video Modules A. Features Operating frequency range from 2403 to 2475 MHz EN Maximum 25 hopping channels TI Date: 2011/5/16 Maximum data rate 12 Mbps (@16QAM) 4-wire SPI interface support max. 30MHz clock rate The 16-bit CRC checking NF ID Modulation scheme : 16QAM,QPSK Hardware retransmission for packets Power supply range: 2.7 ~ 3.3V Transmission range: 250 m (Line of sight) Outline: 20.40 x 27.65 x 4.4 mm B. Applications Digital AV Sender Digital Baby Monitor CO CE & FCC compliance AN WO Wireless Video Door phone Security Camera TR Portable Video Recorder Preliminary data subjects to change without notice MDD-24R2001 AL MDD-24R2001 2.4GHz Digital Audio Video Modules C: Specification Min. Typ. Electrical Section Supply Voltage 4.9 5.0 Supply current in TX mode Modulation Mode Unit 5.1 200 mA 65 NF ID Supply current in RX mode RF Section Max. EN Parameter TI Date: 2011/5/16 mA QPSK,16QAM Operating Frequency Channel Bandwidth Channel Data Rate 2403 3M 25 channels 12M 40 bps dBm +18 @QPSK Power control range Power control resolution MHz +14 @16QAM Transmission Power MHz CO Transmitter Section 2475 dB dB AN WO Receiver Section Overlay channel spacing MHz -78 @ 16QAM Sensitivity dBm -86 @ QPSK Operation -10 +60 ℃ Storage Temperature -20 +70 ℃ TR Operating Temperature Preliminary data subjects to change without notice AL MDD-24R2001 2.4GHz Digital Audio Video Modules TI Date: 2011/5/16 D: Pin Assignment Marks Function VCC Power Supply GND Ground CLK12M IRQ_N Interrupt indication for external MCU CS_N Chip Selection SDO Serial data output SDI Serial data input SCK Serial clock input RST_N Negative active reset input 10 CLK32K 32KHz clock output EN No. AN WO CO NF ID 12MHz clock output TR Model: MDD-24R2001 Preliminary data subjects to change without notice AL MDD-24R2001 2.4GHz Digital Audio Video Modules TI Date: 2011/5/16 TR AN WO CO NF ID EN E: Mechanical Dimension Preliminary data subjects to change without notice AL MDD-24R2001 2.4GHz Digital Audio Video Modules Module User Manual TI Date: 2011/5/16 EN The purpose of this manual is to explain correct way how to integrate module MDD-24R2001 to the end product. It includes procedures that shall assist you to avoid unforeseen problems. This manual presents information that shows how module and OEM product, where module integrated, complies with regulations in certain regions. Note that any modifications, not expressly approved by the manufacturer could void the authority to operate in these regions. Integration NF ID The RF module, model MDD-24R2001 has to be installed and used in accordance with the technical installation instructions provided by the manufacturer. For detail information concerning type approval of this module please contact the authorized local distributor or the manufacturer. The system may only be implemented in the configuration that was authorized. USA-Federal Communications Commission (FCC) Labeling CO This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. AN WO The RF module MDD-24R002 for controller labeled as below. TR The label that is placed on the module is too small to hold the required FCC information, then that information appear in the user manual for this device. In addition, the” Contains FCC ID : O6L-MDD24R2001” label also must be placed on the outside of the end product system. Preliminary data subjects to change without notice AL MDD-24R2001 2.4GHz Digital Audio Video Modules TI Date: 2011/5/16 EN This device is to be used only for mobile and fixed applications. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter. TR AN WO CO NF ID OEM integrators must be provided with antenna installation instructions. OEM integrators and end-users must be provided with transmitter operation conditions for satisfying RF exposure compliance. This grant is valid only when the device is sold to OEM integrators and the OEM integrators are instructed to ensure that the end-user has no manual instruction to remove or install the device. Separate approval is required for all other operating configurations, including portable configurations with respect to 2.1093 and different antenna configurations. Preliminary data subjects to change without notice
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No XMP Toolkit : 3.1-701 About : 7e13d7db-9f07-11e0-0000-49c59ad5613c Producer : Bullzip PDF Printer / www.bullzip.com / Freeware Edition Modify Date : 2011:06:22 16:47:02+08:00 Create Date : 2011:06:22 16:45:34+08:00 Creator Tool : UnknownApplication Metadata Date : 2011:06:22 16:47:02+08:00 Document ID : 7e13d7db-9f07-11e0-0000-49c59ad5613c Instance ID : uuid:3ea54160-3a69-4ac2-a44d-0f017380ee94 Format : application/pdf Title : Untitled Creator : user Page Count : 6 Author : userEXIF Metadata provided by EXIF.tools