Tranwo Technology VSC5882 5.8GHz Wireless Outdoor Camera User Manual Exhibit E User Manual rev 2 p

Tranwo Technology Corp 5.8GHz Wireless Outdoor Camera Exhibit E User Manual rev 2 p

User manual

5.8GHz Wireless OutdoorCMOS CameraVSC-5882A1107
To prevent fire or shock hazard, do not expose this product to rain andmoisture. For example: do not use near a bathtub, washbowl, kitchensink, or laundry tub, in a wet basement, or nearby a swimming pool. Toavoid electric shock, do not take apart this product, provided as anaccessory. This product should be operated only under power supply.Do not overload wall outlets and extension outlets as this can result inthe risk of fire or electric shock.Contents1.Important Safety Information1.Important Safety Information........................................12.Specification............................................................. .13.Package Content ........................................................24.Panel Control Function ...................................... .. 25.Setup Guide ...............................................................3And12.SpecificationInput Voltage DC 8~28VCurrent Consumption < 200mAOperation temperature & humidity 0 40 less than 85%Storage temperature & humidity -20 ~+70 less than 90%Weatherproof IP65Output power @EIRP 20 dBmChannel selection Dip switch(8CH)℃~+ ℃℃℃□NOTE:This equipment has been tested and found to comply with thelimits regulated by FCC and CE. These limits are designed toprovide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and canradiate radio frequency energy and, if not installed and used inaccordance with the instruction, may cause harmful interferenceto radio communications. The change or modifications noexpressly approved by the party responsible for compliance couldvoid the user's authority to operate the equipment. To comply withthe FCC RF exposure compliance requirements, no change to theantenna or the device is permitted. Any change to the antenna orthe device could result in the device exceeding the RF exposurerequirements and void user's authority to operate the device.FCC 0dBm CE 14dBm
3.Package ContentsCheck to make sure that all units shown as below are enclosed.If something missing, please contact your dealer.4. Bracket X11.5.8GHzCMOSCameraX123.Power Adapters (12V/300mA)2. Cover X1,Screw X 22.Package Contents4.Panel Control and Function1 DIP-Switch for channel selection.DC power jack, connect to power supply. (8~28VDC).23 5.8GHz antenna.4 Power indicator (red).5 Lens.5.8GHz COMS Camera21354
2.Package Contents1 According to the diagram, Connect the DC plug of the poweradapter to the DC jack, and connect the power adapter to anoutlet(As shown in Fig.1).2 DIP-Switch for Channel Selection, to find optimal reception,the transmitter and receiver must to be configured as thesame channel(As shown in Fig.2).35.Setup Guide+123123ONUPPER DownCH1 Down DownCH2CH3CH4CH5CH6CH7CH8Down DownUpperDownUpper DownUpper Upper DownUpperUpperUpperUpperDownDownUpper DownDown UpperUpper UpperFig. 2Fig. 1
Fig. 33 Switch to the optimal channel before put on waterproof coverand fasten the screw. (As shown in Fig 3)Waterproof coverScrew4
1Preliminary SpecificationForVSC-58825.8GHz Wireless Outdoor CMOS CameraDocument Number：PSC08002 Page ：1of4Revision ：1ADate ：2008-10-31TRANWO Technology Corp.www.chemlink.com.tw
21. Introduction This document describes the specifications and features of the CHEMLINK 5.8GHz Wireless outdoor CMOS Camera which use FM modulation technology for wireless A/Vtransmission.2. Features Avoids interference from crowded 2.4GHz ISM applications such as videosenders, 802.11b WLAN equipment, Bluetooth-enable products, cordlessphones, microwave ovens, etc. Operating frequency: 5733 ~ 5866MHz (8 channels) Up to 300 feet range, clear line of sight Supports NTSC / PAL composite Video format Auto white balance control 50Hz / 60Hz flicker cancellation IP65 weatherproof supported3. Specifications3.1 Wireless CMOS Camera3.1.1 General specificationsInput voltage DC 8 ~ 28VCurrent consumption:IR LEDs OFF 120mA @12VDC IR LEDs ON 200mA @12VDCOperating temperature & humidity 0℃ ~ +40℃ less than 85%Storage temperature & humidity -20℃ ~ +70℃ less than 90%Weatherproof IP653.1.2 Electrical specificationsRFOutput power @ EIRP FCC 0 dBm CE 14 dBmModulation type FMChannel Frequency CH1 5733 MHzCH2 5752 MHzCH3 5771 MHzCH4 5790 MHzCH5 5809 MHzCH6 5828 MHzCH7 5847 MHzCH8 5866 MHzChannel selection DIP switchFrequency stability ±250KHzOutput flatness 3 dB
3VideoInput Level 1V p-p ±0.15 V p-p LoadImpedance 75 ohmsPre-Emphasis NTSC & PALImageSensor 1/3” CMOS SensorImage area 5.961mm*4.276mmArray size 510 X 496 (NTSC)628 X 586 (PAL)IlluminationNight Vision Range 10 mLENSLENS f6.0mm, F2.0 ,(4 glasses with IR cut filter)LENS focus FixedView angle 60°AccessoryAdaptor DC 12V/300mABracket Optional3.2 Dip Switch for Channel SelectionCH1 Down Down DownCH2 Upper Down DownCH3 Down Upper DownCH4 Upper Upper DownCH5 Down Down UpperCH6 Upper Down UpperCH7 Down Upper UpperCH8 Upper Upper UpperUpperDown
44. Photograph4.1 Wireless CMOS Camera

Navigation menu