Twinhead PN1H Plug-In PC User Manual PN1H Plug In PC 0902
Twinhead International Corporation Plug-In PC PN1H Plug In PC 0902
Twinhead >
User Manual
TWINHEAD 2 Note: 1. HDMI and VGA cannot be used at the same time. 2. Turn On/Off the Plug-In PC from TV remote 3. The Plug-In PC will follow TV power status LED Indicator LED Indicator Item Power LED HDD LED LAN LED Description Green when system is active Green when the read/write data Green when the LAN is connected Yellow when the LAN access data 4 5 6 Copyright Copyright© 2010. All rights reserved. No part of this user manual may be transmitted, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, without the prior written permission of the manufacturer. Information is subject to change without prior notice. Regulatory Statement Federal Communications Commission Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Shielded interconnect cables and shielded AC power cable must be employed with this equipment to insure compliance with the pertinent RF emission limits governing this device. Changes or modifications not expressly approved by the system's manufacturer could void the user's authority to operate the equipment. Declaration of Conformity This device complies with part 15 of the FCC rules. Operation is subject to the following conditions: This device may not cause harmful interference This device must accept any interference received, including interference that may cause undesired operation. RF exposure warning This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. This device is operation in 5.15 – 5.25GHz frequency range, then restricted in indoor use only. This device is slave equipment, the device is not radar detection and not ad-hoc operation in the DFS band. European Notice Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European Norms: EN 55022 ( CISPR 22 ) Radio Frequency Interference EN 55024 ( EN61000-4-2, EN61000-4-3, EN61000-4-4, EN61000-4-5, EN61000-4-6, EN61000-4-8,EN61000-4-11, EN61000-3-2, EN61000-3-3 ) Generic Immunity Standard EN 60950-1 ( IEC 60950-1 ) Product Safety R&TTE (CE) MANUAL REGULATORY REQUIREMENT (WLAN - IEEE 802.11a/b/g/n) 802.11a Restrictions: The low band 5.15 -5.35 GHz is for indoor use only. 802.11b.g.n Restrictions: European standards dictate maximum radiated transmit power of 100mW EIRP and frequency range 2.400-2.4835GHz. In France, the equipment must be restricted to the 2.4465-2.4835GHz frequency range and must be restricted to indoor use." CE Declaration of Conformity CE ! Is herewith confirmed to comply with the requirements set out in the Council Directive on the Approximation of the Laws of the Member States relating to Electromagnetic Compatibility (89/336/EEC), Low- voltage Directive (73/23/EEC) and the Amendment Directive (93/68/EEC), the procedures given in European Council Directive 99/5/EC and 9/3360EEC. The equipment was passed. The test was performed according to the following European standards. EN 301 893 V1.2.3 EN 300 328 V1.7.1 (2006-05) EN 301 489-1 V.1.4.1 (2005-09) / EN 301 489-17 V.1.2.1 (2002-04) EN 60950-1:2001 10 ▓認定番号 本製品は以下に認証を受けたものです。 認証機器名:PN1H 認定番号: 11
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : Yes Author : jinnchen Create Date : 2011:09:05 09:20:30+08:00 Modify Date : 2011:09:05 09:20:30+08:00 XMP Toolkit : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04 Format : application/pdf Creator : jinnchen Title : Microsoft Word - PN1H_Plug-In PC-0902.doc Creator Tool : PScript5.dll Version 5.2.2 Producer : Acrobat Distiller 9.4.5 (Windows) Document ID : uuid:f377b89f-885c-43c8-92a8-a2ec2416e87b Instance ID : uuid:7953e8fb-6325-42e6-b4c5-f3f22769b6c6 Page Count : 11EXIF Metadata provided by EXIF.tools