Ubee Interactive DVW2100 BCM3379 Wireless eMTA For Modular:802.11b/g/n WLAN User Manual
Ubee Interactive Corp. BCM3379 Wireless eMTA For Modular:802.11b/g/n WLAN
user manual
COMPANY CONFIDENTIAL
Product Specification
Hardware Specification
Standards IEEE 802.11b/g/n
Operating Frequency USA: 2.400 ~ 2.4835 GHz
Europe: 2.400 ~ 2.4835 GHz
Japan: 2.400 ~ 2.497 GHz
Host Interfaces PCI Express 1.1
Operation Voltage 3.3V +/- 10%
Data Rate
802.11b: 1, 2, 5.5 and 11Mbps
802.11g: 6, 9, 12, 18, 24, 36, 48, 54Mbps.
802.11n:
20 MHz BW: 150, 130, 117, 104, 78 *
40 MHz BW: 300, 270, 243, 216, 162, 108 *
*Many other data rates are supported by the hardware
Modulation Schemes DSSS with DBPSK, DQPSK, CCK
OFDM with BPSK, QPSK, 16QAM, 64QAM
MAC Protocol CSMA/CA with ACK architecture 32-bit MAC
Operating Channels 11 for North America, 13 for Europe, 14 for Japan
Antenna Connectors Two antennas allowing transmission or reception on
both, simultaneously.
Transmitter Output Power
CCK 18.0 dBm
Legacy OFDM 20MHz SISO 15.5 dBm
Legacy OFDM 20MHz CDD 15.5 dBm
MCS 0-7 20MHz SISO 15.5 dBm
MCS 8-15 20MHz SDM 15.5 dBm
Legacy OFDM 40MHz SISO 14.5 dBm
Legacy OFDM 40MHz CDD 14.5 dBm
MCS 0-7 40MHz SISO 14.5 dBm
MCS 8-15 40MHz SDM 14.5 dBm
MCS 32 14.5 dBm
*Note: this target power means single chain
Product Name: BCM3379 Wireless eMTA For Modular:802.11b/g/n WLAN
Model Number: DVW2100
COMPANY CONFIDENTIAL
WLAN Receiver Sensitivity
Mode Data Rate
Minimum Sensitivity (dBm)
802.11 b 1 Mbps 94
802.11 b 11 Mbps 88
802.11 g 6 Mbps 88
802.11 g 54 Mbps 73
802.11 n HT20 MCS 0 86
802.11 n HT20 MCS 7 69
802.11 n HT20 MCS 15 67
802.11 n HT40 MCS 0 85
802.11 n HT40 MCS 7 67
802.11 n HT40 MCS 15 65
* This is draft and will be modified according to Broadcom final specification.
Current Consumption
ASPM L0 (normal) ASPM L1 (power saving)
Test status Current (mA) Power (W) Current (mA) Power (W)
Module Disable 72 0.24 72 0.24
Idle(unassociated) 97 0.32 72 0.24
Idle(associated) 121 0.40 95 0.31
Search (only for scan AP) 272 0.90 246 0.81
Transmit (max throughput) 740 2.44 740 2.44
Receive (max throughput) 650 2.15 650 2.15
S3/S4 (Standby/Hibernate) 22 0.0726 22 0.0726
*Note: this power consumption means only typical value.
Product Name: BCM3379 Wireless eMTA For Modular:802.11b/g/n WLAN
Model Number: DVW2100
FCC Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
To comply with FCC RF exposure compliance requirements, a separation distance of
at least 20 cm must be maintained between the antenna of this device and all persons.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Only the type of diople antenna tested may be used.
The end product must carry a label stating "Contains FCC ID:XCNDVW2100".