Utica Boilers Svb Series Ii Brochure

: Utica-Boilers Utica-Boilers-Svb-Series-Ii-Brochure-719508 utica-boilers-svb-series-ii-brochure-719508 utica-boilers pdf

Open the PDF directly: View PDF .
Page Count: 2

SVB

Up to 84.4% AFUE Gas Fired Hot Water Boiler

There Are Some Things You Can Always Depend On...

• Available in 6 sizes from 42 MBH to 225 MBH.

• Dependable Cast Iron Heat Exchanger with Cast Iron Push Nipples.

The Sections and Push Nipples expand at the same rate when

heated. By using similar materials instead of less expensive

gaskets the boiler maintains a water tight seal over time.

• Honeywell High Limit/Electronic Ignition Control.

- Recessed under the boiler’s protective jacket

- Digital temperature display and diagnostics

- Plug in connection for the inducer fan

- Plug in connection for the system pump

Control monitors the water temperature and delays the burner

starting until residual heat has been transferred. This maximizes

efciency by turning on the burner only when needed.

• Induced Draft Fan - allows ue gases to be pulled through the boiler

and exhausted through a chimney or side-wall vent.

• Textured paint Jacket. Small compact design is ideal for low

clearance installations.

• Limited Lifetime Warranty (Residential Applications)

• Made in the USA

SVB Series II

Contractor

Assistance: 800.325.5479 P.O. Box 4729

Utica, New York 13504

tel: 315.797.1310 • fax: 315.797.3762

www.uticaboilers.com

All ratings and specications subject to change.

Utica SVB Series II Gas Fired Hot Water Boiler

Dimensional

Diagram Model Input Rate

(MBH) (1)

Heating

Capacity

(MBH) (1)

Net AHRI

Rating,

Water

(MBH) (2)

Vent Diameter

AFUE %

To Chimney (3)

(Category I)

Horizontal Vent

(Category III)

SVB-2 42.5 36 31 4” 3” 84.4%

SVB-3 75 63 55 4” 3” 83.4%

SVB-4 112.5 94 82 4” 3” 83.0%

SVB-5 150 125 109 4” 3” 82.7%

SVB-6 187.5 155 135 4” 4” 82.3%

SVB-7 225 186 162 4” 4” 82.0%

1) 1,000 Btuh = British Thermal Unit Per Hour. Boilers are equipped for altitudes up to 2,000 feet only. For altitudes above 2,000 feet, ratings should be

reduced at the rate of 4% for each 1,000 feet above sea level. Heating Capacity based on D.O.E. (Department of Energy) test procedure.

2) Net AHRI Water Ratings indicate amount of remaining heat input that can be used to heat the radiation or terminal units. Net AHRI Ratings shown are based

on an allowance of 1.15. Selection of boiler size should be based upon “Net AHRI Rating” being equal to or greater than calculated heat loss of building.

Manufacturer should be consulted before selecting a boiler for installations having unusual piping and pickup requirements.

(3) Boiler is provided with a 3” x 4” increaser for chimney vent applications. This does not infer that the connection to the chimney will always be 4”.

Please refer to IOM, National Fuel Gas Code, ANSI Z223.1/NFPA54, or applicable provisions of the local building codes for details concerning proper

chimney connections.

General Information (See Installation, Operation and Maintenance Manual for complete instructions)

Clearances

(4) Required

distances

measured from

boiler.

*Denition of

Alcove is three

sided space

with no wall in

front of boiler.

ANSI standard

for alcove is

18 inches from

appliance to

leading edge of

side walls as

shown in IOM.

Top

Combustible Materials (Required) (4)

6” (152 mm)

Rear 6” (152 mm)

Control Side 8” (203 mm)

Opposite Side 6" (152 mm)

Front (Alcove)* 18” (457 mm)

Flue/Vent Connector 6” (152 mm)

Connections

(All Models) Return/Supply Water 1-1/4”, Gas In 1/2” NPT

Electrical 120 Volts AC, 60 hertz, 1 phase, Less than 12 amps (15 amp circuit recommended)

Water

Content

SVB-2 - 1.75 Gallons, SVB-3 - 3.00 Gallons, SVB-4 - 4.25 Gallons, SVB-5 - 5.50 Gallons,

SVB-6 - 6.75 Gallons, SVB-7 - 8.00 Gallons

Dimensions/

Weights

Model A (Width) B (Height) C (Depth) Weight

SVB-2 11” 29” 23-1/4” 225 lbs.

SVB-3 14-1/4” 29” 23-1/4” 265 lbs.

SVB-4 17-1/2” 29” 23-1/4” 322 lbs.

SVB-5 20-3/4” 29” 23-1/4” 370 lbs.

SVB-6 24” 29” 23-1/4” 431 lbs.

SVB-7 27-1/4” 29” 23-1/4” 480 lbs.

Standard

Equipment

Boiler Control Module: Recessed Honeywell Control (High Limit/Electronic Ignition Control).

User Display Interface: Digital Temperature Display.

Heat Exchanger: Cast Iron Sections with Cast Iron Push Nipples.

Combustion: Completely Installed and Wired Gas Control System with Titanium Composite Burners and

Manifold consisting of: Automatic Redundant Combination Gas Valve, 24 Volt Intermittent Pilot Control,

Continuous Retry 100% Shut Off, Combination Pilot Burner/Electrode/Flame Sensor.

Electrical: 24 Volt Transformer, Service Switch.

Safety: Flame Roll-Out Safety Shut-Off (Fuse Link) and Pressure Switch (vent safety shutoff) with Spare

Fuse Link included.

Other: Assembled Boiler with Insulated Jacket, Induced Draft Fan, Combination Temperature/Pressure

Gauge, Circulator Pump, ¾” Drain Valve, 30lb. ASME Relief Valve.

Options Natural Gas or Propane, Combustible Floor Plate, Fill-Trol, Thimble, Sidewall Vent Hood

Certications

Tested for 50 psi

ASME Working Pressure

C.S.A. Certified For

Natural Gas Or Propane

Right Side

Front

Left Side

Control Panel

(Internally Located)

PN 240009708 Rev. 1/15

231

/4"

3"

29"