Venture Global DWS-100 Driveway Alert Sensor User Manual 2
Venture Global Limited Driveway Alert Sensor 2
User Manual
Sensingwindow
Narrow window
adaptor
Sun Blocker
Adjustable base
Sensitivity
12m 8m 7m4m
Filter
Test button
Night switch
Battery compartment
7S30S
After detect an intruder
the sensor will sleep 7
seconds or 30 seconds
to save power
0.5-1m/sec 1-2 m/sec
All way active Active at
darkness
Batteryinstallation
Open the back cover by
unlock the screws
Lock the screws Replace sun blocker
AA
AA
AA
AA
Install the 4 AA batteries
into the battery compartment
as the indication on the
compartment
Installation
Mark the 4 hole on the wall using a pencil.
o
/ 7mm 25mm
Requires an electric drill for holes to fix the
Sensor with the provided ram plug and screws.
AA
AA
AA
AA
Replace the back cover as
the diagram
Pairing
2.8 Deg
5.8 deg
12M
26 x 20mm 9 x 14mm
Narrow Aperture
Normal
1.2M
1.5M
Mountingthesensorwithscrewprovided Adjustthesensortomake
agoodoperationangle
Narrowwindow
adaptor
Code Conflict
If the PIR sensor coding is the same as another transmitter you must
change the code. When you have changed the code, you need to re-
pair the PIR sensor.
AA
AA
AA
AA
AA
AA
AA
Press and hold the test button, insert
the battery and hold the button 5
seconds. The LED will flash 5 time
when a new code is generated
AA
This sensor works with the receiver (chime) and must be paired
before using
Step 1: Insert battery to the sensor.
Step 2: Insert batteries to the receiver (chime).
Step 3: Enter pairing mode for receiver (chime unit).
Press and hold the learning button 3 seconds. The LED
#1 will flash.
Step 4: Press the button again to move to the zone you want
to pair with.
Press melody selector to scroll through the melodies.
Once you hear your preferred melody, do not press
again as it is now selected.
There are 18 melodies & sound effects in sequence.
ID
Learning
button
Melody
selector
CHI ME
LIG HT
LIG HT & CHIM E
Step 5: Once you have selected the zone and melody, trigger the
sensor by pressing test button once.
If successful, the receiver will generate a short tone. Press
the button to exit pairing mode, the system is now ready to
use.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: Modifications to this product will void the user's authority to operate this equipment.