Venture Global HAX-800 Wireless Entry Mat Sensor User Manual 2

Venture Global Limited Wireless Entry Mat Sensor 2

User Manual

+ +The Entry Mat works with the receiver (chime or vibrating pager) and must be paired before usingStep 1: Insert battery to the sensor.Step 2: Insert batteries to the receiver (chime).Step 3: Enter pairing mode for receiver (chime unit). Press and hold the zone selector button 3 seconds. The LED #1 will flash.Step 4: Press the button again to move to the zone you want to pair with. Press melody selector to scroll through the melodies. Once you hear your preferred melody, do not press again as it is now selected.Step 5: Once you have selected the zone and melody, trigger the Entry Mat with step on the mat If successful, the receiver will generate a short tone. Press the button to exit pairing mode, the system is now ready to use.CODE CONFLICTIf the entry mat sensor coding is same as another sensor. you must change the code of the entry mat sensor .CODE MATCHING AND MELODY SELECTIONENTRY MAT SENSORBATTERY INSTALLATIONOPERATIONPARTS & FUNCTIONSensorSensor pocketTransmitterMat Battery Compartment+ +1. Take out the transmitter from the sensor pocket2. Open the battery with a small screwdriver3. insert 2 CR2032 to Battery compartment.4.Close the battery cover and put the transmitter to the sensor pocket. 1. Take out the transmitter from the sensor pocket2. Open the battery with a small screwdriver3. Take out 2 CR2032 from Battery compartment.4.Step on the mat and install the batteries again. The LED will flash 5 times when a new code is generatedIDZone selectorbuttonMelody selectorPut the entry mat in the entrance. Put a rugon the top of theentrymat to protect the mat sensor.The sensor will transmit a trigger signal to the receiver when someone step on the mat.BATTERY LOW INDICATORThe status of sensor battery is indicate on the receiver. Please refer to the " battery low indicator" on the receiver.FCC StatementNote:This equipment has been tested and found to comply with the Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment of and on, the user is encouraged to try to correct the interference by one or more of the following measures:1. Reorient or relocate the receiving antenna.2. Increase the separation between the equipment and receiver.3. Connet the equipment into an outlet on a circuit different from that to which the receiver is connected.4. Consum the dealer or an experienced radio/TV technician for helpNote: Modifications to this product will void the user's authority to operate this equipment.

Navigation menu