Venture Global HAX900X Wireless Indoor PIR Sensor User Manual 2

Venture Global Limited Wireless Indoor PIR Sensor 2

User manual

PIR lensLED indicatorMounting bracketPart & FunctionBattery InstallationThe PIR sensor works with the receiver (chime) and must be paired before usingStep 1: Insert battery to the sensor.Step 2: Insert batteries to the receiver (chime).Step 3: Enter pairing mode for receiver (chime unit). Press and hold the zone selector button 3 seconds. The LED #1 will flash.Step 4: Press the button again to move to the zone you want to pair with. Press melody selector to scroll through the melodies. Once you hear your preferred melody, do not press again as it is now selected.Step 5: Once you have selected the zone and melody, trigger the PIR sensor once.To trigger the sensor move your hand across the lens or press the test button inside the battery cover. If successful, the receiver will generate a short tone. Press the button to exit pairing mode, the system is now ready to use.TimerPower switchTestIDZone selector button Melody selector buttonFunctionSwitch*Chime*Light & Chime*LightSlide to open the battery coverInsert a CR123Abattery to the battery compartment.+-Test the SensorInsert the battery into the PIR detector, the PIR detector will start to detect motion automatically after 15 seconds. Walk to the front of the detector within 8m.Once the motion has been detected, the detector will send out a trigger signal to the receiver (chime) then go into a sleep mode for 10 seconds. During this time it will not detect motion.CA U TI O N RISK OF EXPL O SIO N IF BATT E RY IS REP L ACE D BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCT This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 25mm between the Wireless Intercom & your body or face.FCC Statement:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: * Reorient or relocate the receiving antenna. * Increase the separation between the equipment and receiver. * Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: Modifications to this product will void the user's authority to operate this equipment.Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment

Navigation menu