Venture Global HAX900X Wireless Indoor PIR Sensor User Manual 2
Venture Global Limited Wireless Indoor PIR Sensor 2
User manual
PIR lens
LED indicator
Mounting
bracket
Part & Function
Battery Installation
The PIR sensor works with the receiver
(chime) and must be paired before using
Step 1: Insert battery to the sensor.
Step 2: Insert batteries to the receiver
(chime).
Step 3: Enter pairing mode for receiver
(chime unit).
Press and hold the zone selector
button 3 seconds. The LED #1 will flash.
Step 4: Press the button again to move to
the zone you want to pair with.
Press melody selector to scroll
through the melodies. Once you hear
your preferred melody, do not press
again as it is now selected.
Step 5: Once you have selected the zone and
melody, trigger the PIR sensor once.
To trigger the sensor move your hand
across the lens or press the test button
inside the battery cover.
If successful, the receiver will generate a
short tone. Press the button to exit
pairing mode, the system is now ready to
use.
Timer
Power
switch
Test
ID
Zone selector
button Melody selector
button
FunctionSwitch
*Chime
*Light & Chime
*Light
Slide to open the
battery cover
Insert a CR123A
battery to the battery compartment.
+
-
Test the Sensor
Insert the battery into the PIR detector, the PIR detector
will start to detect motion automatically after 15 seconds.
Walk to the front of the detector within 8m.
Once the motion has been detected, the detector will
send out a trigger signal to the receiver (chime) then go
into a sleep mode for 10 seconds. During this time it will
not detect motion.
CA U TI O N RISK OF EXPL O SIO N IF BATT E RY IS REP L ACE D BY AN
INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE
INSTRUCT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 25mm between the Wireless Intercom &
your body or face.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: Modifications to this product will void the user's authority to operate this equipment.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment