Venture Global SSX-201 Wireless Sound Sensor Transmitter User Manual 2

Venture Global Limited Wireless Sound Sensor Transmitter 2

User Manual

ON/off buttonON/OFF buttonMicrophoneSensitivity Power On/OFFBattery compartmentBattery Installation++Insert 2 AAA battery compartment Turn ON and turn OFFThis device has two ways to turn power on and off.Hardware ON/OFF Slide the switch to ON or OFF position.If the slide switch is OFF, you cannot use the software switch to turn on the power. If the unit is not in use for a long period, use the hardware switch to turn off the unitSoftware ON/OFF This allows the transmitter to be controlled externally. Off: If the sensor is ON, press and hold the software ON/OFF switch 5 seconds, the LED will flash. ON: If the sensor is OFF, press and hold the software ON/OFF switch 5 seconds, the LED will flash. The sound sensor defaults to "ON" when the hardware switch is moved from OFF to ON.Hardware switchSoftware switchCode Matching & Melody SelectionThe sound sensor works with the receiver (chime) and must be paired prior to use.Step 1: Insert batteries in the sensor to be used.Step 2: Insert batteries in the receiver to be used.Step 3: Enter pairing mode for receiver (chime unit). Press and hold the learning button 3 seconds. The LED #1 will flash.Step 4: Press the button again to move to the zone you want to pair with. Press melody selector to scroll through the melodies. Once you hear your preferred melody, do not press again as it is now selected. There are 18 melodies & sound effects in sequence. Step 5: Switch on the sensor and speak into the microphone, the red LED indicator will light. If successful, the receiver will generate a short tone. Press the button to exit pairing mode, the system is ready to useIDLearning buttonMelody selectorCHIM ELIGHTLIGHT & CHIMEOperation1.Open the cover. 2. Slide the power to the ON position, 3.Select the desired sensitivity low, mid, or high, this sets the level of sound required to trigger the transmitter. 4.Stick the microphone to the device you want to detect.Open the cover Slide the on/off switchto OFF positionWhile pressing the test buttonSlide the on/off switch to 'on'position and hold the button 5 seconds. The LED will flash 5 times when a new code is generatedCode ConflictIf the sound sensor coding and another transmitter is the same. you must change the code of the sound sensor.When you have changed the code of the sound sensor you will then need to re- pair the sound sensor with the receiver.FCC Statement:CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TY P E . D I SP O S E O F U S E D BAT TE R I E S AC CO R D I N G TO T H E INSTRUCTIONS This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: * Reorient or relocate the receiving antenna. * Increase the separation between the equipment and receiver. * Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: Modifications to this product will void the user's authority to operate this equipment.USER MANUAL SSX-201

Navigation menu