Verifone 1000CTLS Payment Terminal User Manual Manual Add QX
VeriFone Inc Payment Terminal Manual Add QX
Verifone >
Contents
- 1. Manual
- 2. Manual Add PP
- 3. Manual Add QX
Manual Add QX
2099 Gateway Place, Suite 600 San Jose, CA 95110 USA Telephone: (800) VeriFone (837-4366) World Wide Web: www.verifone.com Qx1000 Certifications and Regulations Compliance Manufacturer: VeriFone, Inc. Models: Qx1000 Equipment NOTE: This page contains Compliance Information regarding U.S.A. and Canada excluding the European Union (EU) Countries, the Compliance Information for which appears in the next page. Damage ElectroMagnetic Compatibility (EMC) Compliance Carefully inspect the shipping carton and its contents for any damage. If the unit or any product component appears damaged or to have been tampered with, immediately notify the shipping company and your VeriFone distributor or service provider. Do not use a unit that has been damaged or tampered with. U.S.A. Requirements: FCC Part 15 Regulations Lithium Battery Caution The Random Access Memory (RAM) contents in the device are protected by a lithium battery. Do not, under any circumstances, attempt to replace this battery. Failure to comply may invalidate the product warranty. Tamper Warning This device has a tamper-evident case to indicate if an unauthorized party has opened the device. Opening the case will make the unit inoperable and void the product warranty. Repairs Do not, under any circumstances, attempt any service, adjustments, or repairs on this equipment. Instead, contact your local VeriFone distributor or service provider for assistance. Failure to comply may invalidate the product warranty. Location – Environmental Considerations Do not operate the device outdoors. It is not waterproof or dustproof, and is for indoor use only. Any damage to the unit from exposure to rain or dust may invalidate the product warranty. Do not use the unit where there is high heat, dust, humidity, moisture, or caustic chemicals or oils. Keep the unit away from direct sunlight and anything that radiates heat, such as a stove or a motor. Location – Ease of Use Select a location for your device that contributes to its ease of use: • A location convenient for both merchant and cardholder. • A flat support surface, such as a countertop or table. Cleaners and Solvents Never use thinner, trichloroethylene, or ketone-based solvents to clean the device — they may deteriorate plastic or rubber parts. Do not spray cleaners or other solutions directly onto the keypad or display. For best results, use a clean cloth dampened with water and mild soap. To remove stubborn stains, use alcohol or an alcohol-based cleaner. Electrical Peripherals Before connecting the device, turn off power to the unit. Turn on power only after you are finished connecting the peripheral device(s). For complete information about peripheral installation and use, please refer to the user documentation supplied with the device. Disconnecting Power Disconnecting power during a transaction may cause transaction data files that are not yet stored in memory to be lost. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1 This device may not cause harmful interference. 2 This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and a receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. WARNING! Any changes or modifications to this equipment not expressly approved by VeriFone may void the user’s authority to operate this equipment. Canada Requirements: Radio Interference Regulations This equipment has been tested and found to comply with the limits for Class B digital device in accordance with the limits of the Standard ICES-003. This digital apparatus does not exceed the class B limits for radio noise emissions from digital apparatuses set forth in the Radio Interference Regulations of the Canadian Department of Communications. Radio Compliance U.S.A. Requirements: FCC Part 15, Subpart C Regulations This device contains a radio transceiver module (the FCC Certification Number is located on the bottom of the terminal), operating under Part 15 of the FCC rules in an unlicensed part of the radio spectrum. Qualified personnel must perform service or repairs to the radio portion of this device. Any unauthorized modification to the radio module, shielding, or antenna system may void the user's authority to operate this device. FCC Certification Number: FCC ID: B321000CTLS Canada Requirements: Standard RSS 210 This device contains a radio transceiver module (the IC Certification Number is located on the bottom of the terminal), operating under the Standard RSS 210 in an unlicensed part of the radio spectrum. Qualified personnel must perform service or repairs to the radio portion of this device. Any unauthorized modification to the radio module, shielding, or antenna system may void the user's authority to operate this device. IC Certification Number: IC: 787C-1000CTLS EU Directives Compliance Statement This product complies with the requirements of the applicable EU Council Directives, and is supported by the Declaration of Conformity (DOC) appearing in the next page. Location – Electrical Considerations Avoid locations near electrical appliances or other devices that cause excessive voltage fluctuations or emit electrical noise (for example, air conditioners, neon signs, high-frequency or magnetic security devices, or electric motors). CAUTION: Due to risk of electrical shock or unit damage, do not use the device near water, including a bathtub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Also, avoid using this product during electrical storms. Qx1000 Certifications and Regulations VeriFonePart Number: DOC115EN08-A, Revision A 2009 VeriFone, Inc. All rights reserved. *DOC115EN08-A* Recycling: DO NOT DISCARD! UNIT MUST BE RECYCLED OR DISPOSED OF PROPERLY For proper disposal instructions go to http://recycle.verifone.com/ reference. continued on rear cover Please retain this sheet for future VeriFone 2099 Gateway Place, Suite 600 San Jose, CA 95110, USA Manufacturer’s Address: P003-2xx-x9-xxx; P003-3xx-x9-xxx All Part Numbers: Product Options: EN 300 330-2 V.1.3.1: 2006 EN 300 330-1 V.1.5.1: 2006; EN 61000-3-3:1995 + A1:2001 + A2:2005 EN 61000-3-2:2000; EN 301 489-1, 3, Class B; Avi Galili, VP Products R&D VeriFone UK Ltd. Symphony House 7 Cowley Business Park High Street Cowley Uxbridge, UB8 2AD United Kingdom Tel: +44-1895 275275 VeriFone, 1400 West Stanford Ranch Road Suite 200, Rocklin, CA 95765, USA Dated: February 26, 2009 European contact for regulatory topics only: Technical Documentation kept at: The product herewith complies with the requirements of the EMC Directive 2004/108/EC, Low-Voltage Directive 2006/95/EC, and the RTT&E Directive 1999/5/EC, and carries the CE marking accordingly Supplementary Information: Radio Standards: EMC Emission and Immunity Standards: conforms to the following Product Specifications: Qx1000 Product Name: declares, that the product VeriFone Inc. Manufacturer’s Name: according to ISO/IEC Guide 22 and EN 45014 DECLARATION OF CONFORMITY Qx1000 Declaration of Conformity
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Encryption : Standard V1.2 (40-bit) User Access : Print, Fill forms, Extract, Assemble, Print high-res Create Date : 2009:02:26 17:50:04+08:00 Author : Michael_P6 Modify Date : 2009:05:20 14:03:36+03:00 XMP Toolkit : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39 Part : 1 Conformance : B Format : application/pdf Title : DOC115EN08-A_Qx1000_Certifications_and_Regulations.fm Creator : Michael_P6 Creator Tool : PScript5.dll Version 5.2 Metadata Date : 2009:02:26 17:50:22+08:00 Producer : Acrobat Distiller 8.1.0 (Windows) Document ID : uuid:ee0dbb4f-3146-4ab1-acbd-7949636ba33e Instance ID : uuid:eaea282f-0896-4ec1-8f92-4626e81f81cb Page Count : 2EXIF Metadata provided by EXIF.tools