Verifone E2853G Point of Sale Terminal User Manual Statements

VeriFone Inc Point of Sale Terminal Statements

Contents

User Manual (Statements)

Download: Verifone E2853G Point of Sale Terminal User Manual Statements
Mirror Download [FCC.gov]Verifone E2853G Point of Sale Terminal User Manual Statements
Document ID3560340
Application IDTA7fbknaV5j8WBLfkXlRpQ==
Document DescriptionUser Manual (Statements)
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize77.6kB (969975 bits)
Date Submitted2017-09-13 00:00:00
Date Available2017-09-14 00:00:00
Creation Date2017-09-11 11:11:52
Producing SoftwareMicrosoft® Office Word 2007
Document Lastmod2017-09-13 14:08:31
Document TitleUser Manual (Statements)
Document CreatorMicrosoft® Office Word 2007

Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:




Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
 Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
 This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.

Radiation Exposure Statement:
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for exposure to
radio frequency (RF) energy set by the Federal Communications Commission of the U.S.
Government.
The exposure standard for wireless device employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. *Tests for SAR
are conducted using standard operating positions accepted by the FCC with the device
transmitting at its highest certified power level in all tested frequency bands.
Note: The country code selection is for non-US model only and is not available to all US
model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation
channels only.
Industry Canada statement

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the

following two conditions:
1) this device may not cause interference, and
2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes:
1) l'appareil ne doit pas produire de brouillage, et
2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.


This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

This device and its antenna(s) must not be co-located or operating in conjunction with any other
antenna or transmitter, except tested built-in radios.
Cet appareil et son antenne ne doivent pas être situés ou fonctionner en conjonction avec une autre
antenne ou un autre émetteur, exception faites des radios intégrées qui ont été testées.


The County Code Selection feature is disabled for products marketed in the US/ Canada.

La fonction de sélection de l'indicatif du pays est désactivée pour les produits commercialisés aux
États-Unis et au Canada.
Radiation Exposure Statement:
This device has been tested for compliance with IC SAR values at a typical operating near the body.
To ensure that RF exposure levels below the levels tested, use accessories with this equipment to
maintain a minimum separation distance of 1cm between the body of the user and the device.
These accessories should not contain metallic components. It is possible that the accessories used close to
the body that do not meet these requirements are not consistent with the SAR limits and it is advisable to
avoid using them.
Déclaration d'exposition aux radiations:
Ce dispositif a été testé pour la conformité avec les valeurs SAR à un fonctionnement typique près du corps .
Pour assurer que les niveaux d'exposition aux radiofréquences en deçà des niveaux testés , utiliser des
accessoires avec cet équipement pour maintenir une distance de séparation minimale de 1cm entre le corps
de l'utilisateur et l'appareil. Ces accessoires ne doivent pas contenir des composants métalliques . Il est possible
que les accessoires utilisés près du corps qui ne répondent pas à ces exigences ne sont pas compatibles avec les
limites SAR et il est conseillé d'éviter de les utiliser.
Source Exif Data: 
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Extract
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Create Date                     : 2017:09:11 11:11:52+08:00
Creator Tool                    : Microsoft® Office Word 2007
Modify Date                     : 2017:09:13 14:08:31+08:00
Metadata Date                   : 2017:09:13 14:08:31+08:00
Producer                        : Microsoft® Office Word 2007
Format                          : application/pdf
Document ID                     : uuid:827b3e97-38f2-41b4-9bcf-19ce68f4baba
Instance ID                     : uuid:01e22b12-621d-4cbf-aa99-fb372e1c6328
Page Count                      : 2
Language                        : zh-TW
Creator                         : Microsoft® Office Word 2007
EXIF Metadata provided by EXIF.tools

User Manual(Statements)

Download: Verifone E2853G Point of Sale Terminal User Manual Statements
Mirror Download [FCC.gov]Verifone E2853G Point of Sale Terminal User Manual Statements
Document ID3560604
Application IDz5RYAYVCrPMZXpAHbIvNEg==
Document DescriptionUser Manual(Statements)
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeYes
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize77.6kB (969975 bits)
Date Submitted2017-09-14 00:00:00
Date Available2017-09-14 00:00:00
Creation Date2017-09-11 11:11:52
Producing SoftwareMicrosoft® Office Word 2007
Document Lastmod2017-09-13 14:08:31
Document TitleUser Manual(Statements)
Document CreatorMicrosoft® Office Word 2007

Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:




Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
 Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
 This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.

Radiation Exposure Statement:
This device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for exposure to
radio frequency (RF) energy set by the Federal Communications Commission of the U.S.
Government.
The exposure standard for wireless device employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. *Tests for SAR
are conducted using standard operating positions accepted by the FCC with the device
transmitting at its highest certified power level in all tested frequency bands.
Note: The country code selection is for non-US model only and is not available to all US
model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation
channels only.
Industry Canada statement

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the

following two conditions:
1) this device may not cause interference, and
2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes:
1) l'appareil ne doit pas produire de brouillage, et
2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.


This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

This device and its antenna(s) must not be co-located or operating in conjunction with any other
antenna or transmitter, except tested built-in radios.
Cet appareil et son antenne ne doivent pas être situés ou fonctionner en conjonction avec une autre
antenne ou un autre émetteur, exception faites des radios intégrées qui ont été testées.


The County Code Selection feature is disabled for products marketed in the US/ Canada.

La fonction de sélection de l'indicatif du pays est désactivée pour les produits commercialisés aux
États-Unis et au Canada.
Radiation Exposure Statement:
This device has been tested for compliance with IC SAR values at a typical operating near the body.
To ensure that RF exposure levels below the levels tested, use accessories with this equipment to
maintain a minimum separation distance of 1cm between the body of the user and the device.
These accessories should not contain metallic components. It is possible that the accessories used close to
the body that do not meet these requirements are not consistent with the SAR limits and it is advisable to
avoid using them.
Déclaration d'exposition aux radiations:
Ce dispositif a été testé pour la conformité avec les valeurs SAR à un fonctionnement typique près du corps .
Pour assurer que les niveaux d'exposition aux radiofréquences en deçà des niveaux testés , utiliser des
accessoires avec cet équipement pour maintenir une distance de séparation minimale de 1cm entre le corps
de l'utilisateur et l'appareil. Ces accessoires ne doivent pas contenir des composants métalliques . Il est possible
que les accessoires utilisés près du corps qui ne répondent pas à ces exigences ne sont pas compatibles avec les
limites SAR et il est conseillé d'éviter de les utiliser.
Source Exif Data: 
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Extract
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Create Date                     : 2017:09:11 11:11:52+08:00
Creator Tool                    : Microsoft® Office Word 2007
Modify Date                     : 2017:09:13 14:08:31+08:00
Metadata Date                   : 2017:09:13 14:08:31+08:00
Producer                        : Microsoft® Office Word 2007
Format                          : application/pdf
Document ID                     : uuid:827b3e97-38f2-41b4-9bcf-19ce68f4baba
Instance ID                     : uuid:01e22b12-621d-4cbf-aa99-fb372e1c6328
Page Count                      : 2
Language                        : zh-TW
Creator                         : Microsoft® Office Word 2007
EXIF Metadata provided by EXIF.tools
FCC ID Filing: B32E2853G

Navigation menu