ViVOtech VIVOPAYDINE Low Power Transmitter Wireless Card Reader User Manual
ViVOtech, Inc. Low Power Transmitter Wireless Card Reader Users Manual
ViVOtech >
Users Manual
vivotecw Quicker than cash, Safer than checks M VIVOpay Dine Quick User Guide for stand-alone demo Version 1.0 1) To activate the Stand-Alone 2) 3) Demo, turn-on VP Dlne (using on/ofl button as indicated in green) while keeplng the “1” button on the VP Dine keypad pressed. You should hear 3 consecutive beeps for a successful boot. If only 2 beeps are heard please turn of! device and start again. The VP Dine will be ready to use when the screen shown on the right is displayed: Tap the above screen to simulate the initiation of a new transacfion; and the screen on the right will then be briefly displayed: 4) 5) 6) When the screen on the right is showing, present the VP to the customer. To add a tlp; select “Yes”, If not: select “No", ( mvm , To demo a transaction without signature select “N0". It “Yes” is selected, to add; a tip the VP Dine will display a screen similar to the one shown on the right: The tip screen will already show a preset tip percentage, To change the tip. Tap the “ p“ arrow with a “4” sign to Increase the tlp Tap the "down" arrow with a “-" sign to decrease the tip Tap 0K to accept tip and proceed When a screen similar the one on the right is shown, tap “Yes" to proceed or “No" to re-enter tip 7) When the screen on the right is shown. EITHER Tap a contactless credit card or NFC mobile phone on the VISA” logo above the display, 9) If approved, the VP Dine will display the screen on the right: "WW” “U" h so: 19 \ mun: soul OR Swipe a magnetic-stripe credit card at the top of the VP Dlne orientated correctly as indicated by the logo on the top left-hand corner of the VP Dine 10) lfa signature is required the 8) While obtaining approval the screen screen on the right will be shown. on the right will be shown - Please use ONLY the stylus provided to sign on the line. - Tap clear to sign again or 0K to complete transaction. FCC Regulatory Compliance Notices Class A Equipment This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. . Ope ration is subject to the following two conditions: (1) This device may not cause harmful interference. and (2) this device must accept any interference received, including interference that may cause undesired operation For Ic Regulatory Compliance: "Operation is subject to the following two conditions: (1) this device may not cause interference,and this device must accept any interference,inc|uding interference that may casuse undersired operation of the device. Information to user The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. In cases where the manual is provided only in a form other than paper. such as on a computer disk or over the Internet, the information required by this section may be included in the manual in that alternative form, provided the user can reasonably be expected to have the capability to access information in that form. Cautions and Warnings /‘ CAUTION: Danger of Explosion if battery is incorrectly replaced. Replace / , only with same or equivalent type recommended by the manufacturer. ‘w—a Discard used batteries according to the manufacturers instructions. //'~ CAUTION: The unit should be mounted 1-2 feet away from other units. Can be adjusted based on lane setup, ~ - CAUTION: The unit should not be placed directly on or within 4 inches of it ‘ any large metal surfaces. WARNING: Avoid close proximity to items such as cellular telephones and portable 2-way radios which may reduce the ability of the reader.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Modify Date : 2007:01:03 09:35:54-08:00 Create Date : 2006:12:29 09:14:00-08:00 Creator : Lexmark X1100 Series Page Count : 4 About : uuid:1a6910b6-b067-47c6-b4d0-767202c6be44 Producer : Adobe Acrobat 6.0 Paper Capture Creation Date : 2006:12:29 09:14:00-08:00 Mod Date : 2007:01:03 09:35:54-08:00 Creator Tool : Lexmark X1100 Series Metadata Date : 2007:01:03 09:35:54-08:00 Document ID : uuid:e675ce0e-3084-4458-8664-ed2329890ef1 Format : application/pdfEXIF Metadata provided by EXIF.tools