Visonic MCT212 Wrist Transmitter User Manual User Guide 16304
Visonic Inc. Wrist Transmitter User Guide 16304
Visonic >
Users Manual Revised
MCTMCT-212 RL Waterproof PowerCode Wrist Transmitter User Guide 1. INTRODUCTION The MCT-212 RL is a miniature waterproof transmitter, designed for home health care signaling. In the event of an emergency, help can be summoned at the press of the transmitter button. All MCT-212 RL units are supplied with a wrist band and neck strap. They can be worn on the wrist or around the neck. (See Figure 1a.&1b.) The LED lights during a transmission to indicate a good battery. If the LED flashes during a transmission, this means that the battery is low and must be replaced immediately. Anytime the MCT212 RL is pressed when the battery is low, a trouble signal will automatically be sent to the Base Unit. To alert you of the trouble, a red LED will flash and a trouble message will appear on the display of the Base Unit. All troubles are reported to Monitoring Center. The transmitter case is hermetically sealed screws) to ensure complete waterproofing of case. Therefore battery replacement must performed by the factory only. the (no the be TRANSMIT BUTTON LOOP SAFETY RELEASE MECHANISM LED INDICATOR NECK CORD FASTENER Figure 1a. MCT-212 RL with Wrist Band FASTENER Figure 1b. MCT-212 RL with Neck Strap 2. TESTING, TESTING, MAINTENANCE AND ENROLLMENT 2.1 Enrolling Transmitters In order for a transmitter to function, its ID must be enrolled into the Base Unit. The Transmitter ID is a 6 character code (ex: EB1772) that can be found both on the unit’s package and on the reverse side of the unit. To enroll a transmitter, provide ResponseLINK (either by telephone or by fax) of the Transmitter ID. 2.2 Initial Test Upon pressing the transmit button, the Base Unit will sound and display simultaneously CALLING FOR HELP. This indicates that the transmitter is working properly. Note: If for any reason the MCT-212 RL does not result in the above response from the Base Unit, please contact the central station at 1-800-8941428 and verify the Transmitter ID located both on the unit's package and on the reverse side of the transmitter beneath the wrist band. 3. GENERAL COMMENTS 3.1 Product Limitations Our wireless systems are very reliable and are tested to high standards. However, due to their low transmitting power (required by FCC, DTI and other regulatory authorities) there are some limitations to be considered: A. Receivers may be blocked by radio signals occurring on or near their operating frequencies, regardless of the code selected. DE2457U B. A receiver can only respond to one transmitted signal at a time. C. Wireless equipment should be tested regularly (at least once a week) to determine if there are sources of interference and to protect against faults. 4. SPECIFICATIONS Frequency (MHz): 315 Transmitter ID: Over 16 million possible code combinations. Minimum Transmit Duration: 2 sec Power Supply: 3-volt Lithium cell type CR-2032 Battery Life Expectancy: 3 years (for typical use) Battery Supervision: Good battery - LED lights steadily upon activation. Low battery - LED flashes upon activation. Note: If transmission is still possible despite the battery condition, the MCT-212 RL will send a low battery report to the receiver. Operating Temperature: 0° to 50°C (32° to 122°F). Dimensions: 39 x 37 x 13 mm (1-9/16 x 1-7/16 x 5/8 in.). Weight: 25 g (0.9 oz). Color: Gray This device complies with Part 15 of the FCC Rules and RSS-210 of Industry and Science Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. The digital circuit of this device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio and television reception. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause such interference, which can be verified by turning the device off and on, the user is encouraged to eliminate the interference by one or more of the following measures: – Re-orient or re-locate the receiving antenna. – Increase the distance between the device and the receiver. – Connect the device to an outlet on a circuit different from the one which supplies power to the receiver. – Consult the dealer or an experienced radio/TV technician. IF YOU HAVE ANY QUESTIONS PLEASE CALL (800) 894-1428. W.E.E.E. Product Recycling Declaration For information regarding the recycling of this product you must contact the company from which you orignially purchased it. If you are discarding this product and not returning it for repair then you must ensure that it is returned as identified by your supplier. This product is not to be thrown away with everyday waste. Directive 2002/96/EC Waste Electrical and Electronic Equipment. RESPONSELINK L.L.C. 9555 SEMINOLE BLVD. SUITE 207 SEMINOLE Fl. 33772. MCT-212 RL DE2457U (REV. 0, 12/04) PHONE: (727) 466-9373 FAX: (727) 466-9322 DE2457U
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Encryption : Standard V1.2 (40-bit) User Access : Print, Fill forms, Extract, Assemble, Print high-res Create Date : 2005:04:18 17:29:36 Producer : Acrobat Distiller 4.05 for Windows Author : marina Creator : PScript5.dll Version 5.2 Title : Microsoft Word - User_Guide_16304.doc Modify Date : 2005:04:18 17:30:57+02:00 Page Count : 2EXIF Metadata provided by EXIF.tools