Voxx Electronics DEI7151 Security/Remote Control Transmitter User Manual 7151X 11 06 indd

DEI Headquarters, Inc. Security/Remote Control Transmitter 7151X 11 06 indd

manual

The Science of Security™Compatible with the following systems: 919562L Clifford Responder PN 7151X
REPLACEMENT TRANSMITTERModel 7151X, 5 Button, Stealth Code Remote11/06P/N 7151XMADE IN TAIWAN©2006 Directed Electronics. Vista CA 92081All rights reserved.1. Ignition ON: Place the key into the ignition and turn to the ON position or start the engine. 2. Enter PIN number: Enter your PIN number using the Plainview 2 valet switch. Note: The Factory default PIN number is written on the back of the system owner’s guide.3. Press/hold/release: Immediately PRESS and HOLD the * button until you hear one chirp and the Status LED turns on, then RELEASE the * button. 4. PRESS/RELEASE: PRESS and RELEASE the "blank" button once. Pause until you hear one chirp. 5. PRESS/RELEASE: PRESS and RELEASE the * button once. The siren will chirp once as you push the button. 6. TRANSMIT: Press the button on you new trans-mitter. The siren will chirp once to confirm it has received the transmission.7. TRANSMIT again: Press the button a second time. The siren will chirp twice to confirm it has learned your new transmitter.8. IGNITION OFF: Turn the ignition off and remove the key: The alarm will chirp three times to indicate exiting transmitter learn routine. 9. TEST TRANSMITTER: Press the button to verify that the transmitter is operating the alarm system. Note: This transmitter auto-learn routine is appli-cable to specific system/transmitter combinations, use the following reference guide or consult your local Clifford dealer for your particular application904120 transmitter: GP1000T/Arrow 5/Arrow 3/Cyber 2904065 transmitter: Arrow 5 /Arrow 3 / Cyber 2 904100 transmitter: Concept 100 / Concept 450/ Intelliguard 6000 / Cyber 4 904075 transmitter: All other systemsFCC/ID NoticeThis device complies with Part 15 of FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause unde-sired operation.CAUTION! Changes or modifications not express-ly approved by the party responsible for compli-ance could void the user's authority to operate this device.

Navigation menu