Voxx Electronics DEI7151 Security/Remote Control Transmitter User Manual 7151X 11 06 indd
DEI Headquarters, Inc. Security/Remote Control Transmitter 7151X 11 06 indd
manual
The Science of Security™
Compatible with the
following systems:
919562L
Clifford Responder
PN 7151X
REPLACEMENT TRANSMITTER
Model 7151X, 5 Button, Stealth Code Remote
11/06P/N 7151X
MADE IN TAIWAN
©2006 Directed Electronics.
Vista CA 92081
All rights reserved.
1. Ignition ON: Place the key into the ignition and turn
to the ON position or start the engine.
2. Enter PIN number: Enter your PIN number using
the Plainview 2 valet switch.
Note: The Factory default PIN number is written on
the back of the system owner’s guide.
3. Press/hold/release: Immediately PRESS and
HOLD the * button until you hear one chirp and the
Status LED turns on, then RELEASE the * button.
4. PRESS/RELEASE: PRESS and RELEASE the
"blank" button once. Pause until you hear one
chirp.
5. PRESS/RELEASE: PRESS and RELEASE the *
button once. The siren will chirp once as you push
the button.
6. TRANSMIT: Press the button on you new trans-
mitter. The siren will chirp once to confirm it has
received the transmission.
7. TRANSMIT again: Press the button a second time.
The siren will chirp twice to confirm it has learned
your new transmitter.
8. IGNITION OFF: Turn the ignition off and remove
the key: The alarm will chirp three times to indicate
exiting transmitter learn routine.
9. TEST TRANSMITTER: Press the button to verify
that the transmitter is operating the alarm system.
Note: This transmitter auto-learn routine is appli-
cable to specific system/transmitter combinations,
use the following reference guide or consult your
local Clifford dealer for your particular application
904120 transmitter: GP1000T/Arrow 5/Arrow 3/Cyber 2
904065 transmitter: Arrow 5 /Arrow 3 / Cyber 2
904100 transmitter: Concept 100 / Concept 450/
Intelliguard 6000 / Cyber 4
904075 transmitter: All other systems
FCC/ID Notice
This device complies with Part 15 of FCC rules.
Operation is subject to the following conditions: (1)
This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause unde-
sired operation.
CAUTION! Changes or modifications not express-
ly approved by the party responsible for compli-
ance could void the user's authority to operate this
device.