Vue Technology 34000003-001 IntelliRouter User Manual
Vue Technology, Inc. IntelliRouter Users Manual
Users Manual
IntelliRouter User Guide Document Version: 1.0 Last Modified: 1/24/2006 3:06:00 PM Vue Technology, Inc. 103 N. Pointe Lake Forest, CA 92630 www.vuetechnology.com Vue Technology, Inc. IntelliRouter User Guide Table of Contents 1. INTRODUCTION ...................................................................................................................................................... 3 2. PRODUCT DESCRIPTION...................................................................................................................................... 3 3. FIRMWARE ............................................................................................................................................................... 3 4. PHYSICAL CONNECTIONS................................................................................................................................... 3 5. TYPICAL CONFIGURATION................................................................................................................................. 5 6. REGULATORY INFORMATION ........................................................................................................................... 6 Date Last Modified: 1/24/2006 Page 2 Vue Technology, Inc. Vue Technology, Inc. IntelliRouter User Guide 1. Introduction This User Guide provides information for the Vue Technology IntelliRouter device. The User Guide includes LED definitions, port descriptions, and configuration information. 2. Product Description The IntelliRouter is a hardware device connected to both the RF and data networks. The device connects to a RF reader, and routes and switches RF to Vue Technology IntelliSwitches and IntelliPads. 3. Firmware The IntelliRouter is shipped with the current firmware version. Contact Vue Technology (www.vuetechnology.com) for information about obtaining firmware upgrades. Note: Ensure that power is not interrupted during a firmware upgrade. 4. Physical Connections The IntelliRouter hardware form factor consists of a circuit board, microprocessor, moulded plastic housing, and the following input and output ports: • • • • • • • • • • • • • On/Off Switch DC Power Reset Parameters button Auxiliary WLAN 4 LAN Ports 4 RF Output Ports (1.0/2/3) 1 RF In Port (1.0/2/3) RS 232 Port Switched Power (In and Out) RS 485 Port ID Button Power, Antenna, and Ready LEDs Date Last Modified: 1/24/2006 Page 3 Vue Technology, Inc. Vue Technology, Inc. IntelliRouter User Guide 4.1.1.1. Back Panel Description IntelliRouter Back Panel 4.1.1.2. Side Panel Description IntelliRouter Side Panel Date Last Modified: 1/24/2006 Page 4 Vue Technology, Inc. Vue Technology, Inc. IntelliRouter User Guide 5. Typical Configuration CAUTION: Use only Vue Technology provided parts, or parts approved/recommended by Vue Technology. Substituting other cables or parts may degrade system performance, damage the device, and/or void the warranty. Date Last Modified: 1/24/2006 Page 5 Vue Technology, Inc. Vue Technology, Inc. IntelliRouter User Guide 6. Regulatory Information The following statements address FCC compliance for the installation and use of Vue Technology devices. • The Vue Technology system is approved to function with the following tag reader: Symbol XR400 multi-protocol radio frequency identification (RFID) reader. FCCID: H9PRD11320 • IMPORTANT: The HF port is not supported in the current version of this product. Do not connect any device to the HF port. • CAUTION: To comply with FCC RF exposure compliance requirements, a separation distance of 20cm must be maintained between the antenna of this device and all persons. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This equipment has been certified to comply with the limits for a class B computing device, pursuant to FCC Rules. In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with non-approved equipment or unshielded cables is likely to result in interference to radio and TV reception. The user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could void the user's authority to operate this equipment. Date Last Modified: 1/24/2006 Page 6 Vue Technology, Inc.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Page Count : 6 Page Layout : OneColumn XMP Toolkit : XMP toolkit 2.9.1-13, framework 1.6 About : uuid:85f38654-0d7d-4a71-9427-292c4a7bd629 Producer : Acrobat Distiller 7.0.5 (Windows) Source Modified : D:20060124230634 Headline : Creator Tool : Acrobat PDFMaker 7.0.5 for Word Modify Date : 2006:01:25 11:32:52-08:00 Create Date : 2006:01:24 16:51:43-08:00 Metadata Date : 2006:01:25 11:32:52-08:00 Document ID : uuid:a5f0f852-1a93-47e2-9fa5-6b74f5470d1a Instance ID : uuid:235990cf-8422-4a15-ae00-d0ac706d21e6 Version ID : 11 Format : application/pdf Title : Creator : Kyle Byron Subject : Tagged PDF : Yes Author : Kyle ByronEXIF Metadata provided by EXIF.tools