Weber Fireplace Assembly Instruction FireplaceAssembly OwnersGuide 39935 1093

FirePlace to the manual fef34bf4-19ca-4e3d-b265-ee2ae14761d6

: Weber Weber-Fireplace-Assembly-Instruction-162292 weber-fireplace-assembly-instruction-162292 weber pdf

Open the PDF directly: View PDF .
Page Count: 4

Download
Open PDF In Browser	View PDF

®

®

FirePlace Assembly
Instructions
DANGER

Please read the following warnings carefully before using your FirePlace. Failure to follow these
warnings may result in serious bodily injury or death, or in a fire causing damage to property.

WARNINGS
䡵 The Weber FirePlace is designed solely for
outdoor use. Indoor use can be lethal.
䡵 Use only on noncombustible surfaces,
such as brick, flagstone, concrete, etc.
Do not use on a wooden deck.
䡵 Keep away from flammable materials,
buildings and vehicles when in use.
䡵 Exercise the same care that you would
with an open campfire.
䡵 Your Weber FirePlace is not to be used by
children.
䡵 Keep away from flammable fluids such as
gasoline, charcoal lighter fluid and
alcohol, etc.
䡵 Keep children and pets away from the
FirePlace when in use.
䡵 Never wear loose-fitting or flammable
clothing (such as nylon) when in use.
䡵 Do not overload. Before starting the fire
make sure the lid is capable of closing.
Overloading can be dangerous if the lid
cannot extinguish the fire.
䡵 Do not use soft woods, like pine or cedar.
Soft woods may "pop" and throw sparks.
䡵 Do not burn leaves, paper, plywood or
trash in the Weber FirePlace.
䡵 Do not use volatile fluids, such as
gasoline, charcoal lighter fluid or alcohol,
to light or relight fires.
䡵 Use only sturdy, long-handled fireplace
equipment, when adding or moving logs.
䡵 Do not attempt to move the FirePlace when
in use or hot.
䡵 Use barbecue mitts when handling,
because surfaces will be hot when in use.

䡵 Fill the Weber FirePlace bottom with
approximately two pounds of sand before
use. This helps to insulate the bottom of
the FirePlace.
䡵 Always extinguish fire with the lid. Do not
douse with water; this will fracture the
porcelain finish. Wood fires take a long
time to extinguish. The Weber FirePlace
and the ashes inside may remain hot for
some time. Leave the lid closed until the
Weber FirePlace is cold.
䡵 Do not store the Weber FirePlace with
combustible materials or ashes inside.

®
®

39935

10/93

Assembly

Two steel handles

Tools needed
Screwdrivers, regular

Two top wood handles

®
®

Two bottom wood handles
and Phillips
Two wood screws
7/16 inch open-end or an adjustable wrench

Sixteen large fiber washers
Eight small fiber washers

Step 1
Check Package Contents

Twenty 1/4 inch steel washers

You should have received the parts shown below with your
Weber FirePlace. In the unlikely event a part is missing or
damaged, do not return the FirePlace, instead contact:

Twenty-four 1/4-20 hex nuts

WEBER-STEPHEN PRODUCTS COMPANY
Customer Service Center
250 South Hicks Road
Palatine, IL 60067-6241
(708) 705-8660
(800) 446-1071

Parts
Lid

Twenty-four 1/4-20 x 5/8 inch machine screws

Step 2
Install Steel Handles
You will need: lid, eight small fiber washers, eight steel
washers, two steel handles, four machine screws, four hex
nuts, a regular screwdriver and wrench.
Install handles as shown in Figure 1.

Upper support ring

Four uprights

CAUTION: Do not overtighten; you may crack the
porcelain finish.

Machine screw
Steel handle
Steel washer

Lower support ring

Small fiber washers

Steel washer

Bottom
Hex nut

Heat deflector

Four legs
Figure 1

Step 3

Step 5

Install Wood Handles

Install Heat Deflector and Fourth Leg

You will need: lid assembly, two top wood handles, two
bottom wood handles, two wood screws and a Phillips
screwdriver.

You will need: heat deflector, bottom assembly, one leg,
two machine screws, four large fiber washers, three steel
washers, two hex nuts, a regular screwdriver and wrench.

Install handles as shown in Figure 2.

Insert the heat deflector between the three legs and
position it so it rests on all the leg tabs, as shown in Figure
4.
Now install the fourth leg using the procedure shown in
Figure 3, and making sure the heat deflector rests on all
leg tabs.

Wood screw
®

®

Top wood handle

Bottom wood handle

Heat deflector

Figure 2

Figure 4

Step 4
Install Three Legs
You will need: three legs, bottom, six machine screws,
twelve large fiber washers, nine steel washers, six hex nuts,
a regular screwdriver and wrench.
Install only three legs as shown in Figure 3. Note that the
machine screws are not installed in the same direction.
CAUTION: Do not overtighten; you may crack the
porcelain finish.
Hex nut
Steel washer

Machine screw

Large fiber
washer
Steel washer
Large fiber
washer
Machine screw
Steel washer
Hex nut

Figure 3

Leg tab

Step 6

Step 8

Assemble Upper Support Ring

Final Assembly

You will need: four uprights, upper support ring, four
machine screws, four hex nuts.

You will need: bottom assembly, ring assembly, lid assembly.
Place the ring assembly inside the FirePlace bottom with the
lower support ring down. Figure 7.

Assemble uprights as shown in Figure 5.

Place the FirePlace lid on the upper support ring. It should
rest on the upright tabs.

Machine screw

Hex nut

Figure 5

Step 7
Assemble Lower Support Ring
You will need: lower support ring, upright assembly, eight
machine screws, eight hex nuts, a screwdriver and wrench.
Assemble lower support ring as shown in Figure 6.

Upper ring
assembly from
Step 5

Lower
support ring
Hex nut

Machine screw

Figure 6

Figure 7



---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
XMP Toolkit                     : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04
Keywords                        : Weber Fireplace (1991-1995) 39935
Producer                        : Acrobat Distiller 3.02
Modify Date                     : 2011:12:09 10:38:03-06:00
Create Date                     : 1998:05:22 15:10:00Z
Creator Tool                    : QuarkXPressª 3.32r5: LaserWriter 8 8.4.3
Metadata Date                   : 2011:12:09 10:38:03-06:00
Document ID                     : uuid:5fc55929-25ef-4517-8c83-bb18f71e65e4
Instance ID                     : uuid:de87d5aa-bf43-4a92-954a-69aa3723bf95
Format                          : application/pdf
Title                           : /FireplaceAssembly OwnersGuide 39935 1093.pdf
Creator                         : 
Description                     : Weber Fireplace (1991-1995) 39935
Subject                         : Weber Fireplace (1991-1995) 39935
Page Count                      : 4
Warning                         : [Minor] Ignored duplicate Info dictionary

EXIF Metadata provided by EXIF.tools