Wi Gear MA110 Bluetooth adapter to use with an Apple iPod. User Manual Manual2 ai

Download:
Mirror Download [FCC.gov]
Document ID	633716
Application ID	Mu3Wblwh89GXTIPtu84fmA==
Document Description	users manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	151.2kB (1889981 bits)
Date Submitted	2006-03-06 00:00:00
Date Available	2006-03-05 00:00:00
Creation Date	2005-08-16 11:00:53
Producing Software	Adobe PDF library 5.00
Document Lastmod	2006-03-06 10:49:33
Document Title	Manual2.ai
Document Creator	Adobe Illustrator 10

USER GUIDE
1313
© 2005-2006 Wi-Gear, Inc. All rights reserved. iMuffs, Wi-Gear, and the Wi-Gear logo are trademarks of WiGear Inc. The Bluetooth word mark and logo are owned by the Bluetooth SIG, Inc. and any use of such marks
by Wi-Gear Inc. is under license. iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other
countries. All other products and services may be marks of their respective owners. Printed in China.
www.wi-gear.com
Contents
Regulatory Information
Introduction
What's included in this package?
Product Features
Getting Started
Playing Music
Bluetooth phone operation
Troubleshooting
10
Specifications
11
Regulatory Information
13
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Radio and Television Interference
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT: Changes or modifications not expressly approved by Wi-Gear Inc. could void
the user's authority to operate the equipment.
IC Compliance Statement
The term "IC": before the certification/registration number only signifies that the Industry
Canada technical specifications were met.
13
Introduction
Battery
n Battery Type: Lithium-Polymer 500mAh
(built-in, not user-serviceable)
n Charge Time: Quick charge, 80% in 2 hours /
Full charge in 5 hours
n Up to 16 hours of continuous operation of the
headphones depending on usage pattern, distance
from adaptor, and battery age. iMuffs Adaptor for iPod
is dependent on iPod's actual battery capacity.
Power Input
n Standard USB voltage input (mini-USB, 5-pin) or
Provided AC-DC
n USB Power Adapter (110-240V)
Cut the cord today!
Congratulations on purchasing iMuffs™ wireless
headphones for your iPod™ AND Bluetooth® phone!
Soon you'll be enjoying these benefits:
Wireless Freedom - Throw your iPod in your backpack
and listen to your music wirelessly! No more cords to
untangle or snag. Enjoy near-CD quality sound up to 30'
(10m) away thanks to the Advanced Audio Distribution
Profile (A2DP) and Bluetooth 2.0.
Never Miss a Call - When your Bluetooth phone rings,
the iMuffs automatically pause your iPod and ring in the
headphones, and let you talk through the integrated
microphone.
Temperature
n Operating: 0°-35° C (32°-95° F)
n Storage: -20-50° C (-68°- 122° F)
Versatile - Listen to music from your laptop or
desktop1, iPaq, or MP3 smartphone2. Talk on the phone
or over iChat or Skype. Even chat while playing video
games.
Weight
n 2.3 oz (headphones)
n 0.3 oz (adaptor)
Ergonomic Controls - Intuitive controls let you pause,
change volume, and skip tracks right from the
headphones.
12
Currently, Windows XP only and requires a Bluetooth adaptor with A2DP
support (Bluetooth Stereo).
Must support Bluetooth Stereo using A2DP.
What's Included in this Package?
iMuffs Stereo Bluetooth Headphones
iMuffs Dock Adaptor for iPod (see below)
Travel charger/adaptor
USB cable
User Guide
Specifications
Wireless Range
n 3-10 meters (9-30 feet)
n Actual range depends on environmental factors:
orientation of devices relative to each other,
obstructions and enclosures, radio frequency noise,
and interference.
Bluetooth
n Bluetooth 2.0
n Advanced Audio Distribution Profile (A2DP)
n Audio Video Remote Control Profile (AVRCP)
n Headphones Profile (HSP)
n Handsfree Profile (HFP)
Compatible with these models:
iPod nano
iPod photo
iPod mini
iPod (3G)
iPod with
color display
iPod with
video (5G)
iPod (4G)
Audio Code
n Codec Encoder/Decoder Type: Sub-band Codec (SBC)
n Bit Rate: 328 kb/s (High Quality)
Audio Output
n Near CD-quality (44.1 KHz, 16-bit)
n Frequency response: 20Hz-20KHz
Audio Input
n Apple iPod Dock Connector Line Out
n Built-in unidirectional microphone
11
Troubleshooting
Product Features
If you have problems using the iMuffs Stereo Bluetooth
Headphones, this section may help. For further help,
please visit www.wi-gear.com.
Familiarize yourself with all of the controls located on the
right side of your iMuffs headphones. Please note that
the two LEDs are visible only when lit.
Most problems can be resolved with a simple reset.
Switch the headphones off, and then on. Unplug the
adaptor from the iPod, plug it back in.
Power
switch
You hear no sound.
Ensure the headphones are switched on and the iMuffs
Dock Adaptor for iPod is plugged into a compatible iPod.
If the iPod screen is blank, the iPod may have gone to
sleep mode. Press Menu on the iPod to turn it on.
Blue LED
Orange LED
Next/FF
button
Verify that the devices are within the recommended
range of approximately 30 feet (10 meters).
The headphone does not power on.
The battery charge may be too low. In this case, the
orange LED may flash and be accompanied by alert
beeps.
Play/Pause/
Phone button
Previous/Rewind
button
Volume control/
button
Microphone
USB charging
port
View of controls (right side)
10
The iMuffs Dock Adaptor for iPod is powered by the iPod.
Plug it into the dock connector port of your compatible
iPod. When not using the iPod for a long period of time,
remove the adaptor to maximize your iPod's battery.
Using with a paired Bluetooth phone
When the phone rings (you will hear an audio tone in the
speakers), answer the call by pressing the
Play/Pause/Phone button.
When the phone rings, reject the call by pressing and
holding the Play/Pause/Phone button for 2 seconds.
iPod
Dock Connector
To end a call, press and hold the Play/Pause/Phone
button for 2 seconds.
To activate voice dialing (if supported by your phone),
press and hold the volume button in for 2 seconds.
To activate redial (if supported by your phone), press
and hold both the Rewind and FF buttons together for 2
seconds.
Blue
LED
iMuffs Dock Adaptor for iPod
Bluetooth Phone Operation
Getting Started
Your iMuffs headphones work with Bluetooth-enabled
phones. However, you will first need to pair the
headphones with your Bluetooth phone before they work.
Your iMuffs headphones are powered by a built-in
rechargeable battery. Before using your iMuffs for the first
time, you should fully charge the battery.
Pairing with a Bluetooth phone
Charging
1. Unplug the adaptor from your iPod, and make sure
your iMuffs headphones are powered off. Make sure
that the Bluetooth phone is nearby.
1. Plug the smaller end of the USB cable into the USB
charging port located at the bottom of the right ear cup
of the headphones.
2. Initiate "Discover" mode in your Bluetooth phone,
according to your phone's user manual.
2. Plug the other end of the USB cable into an open USB
port on your computer or into the travel charger and
then plug the travel charger into an outlet.
3. On the headphones, press and hold the volume button
in while switching the power on. This will initiate the
"Discoverable" mode in the headphones. The blue
LED will begin double-flashing.
4. If asked for a PIN, enter "0000" (four zeros).
5. If the pairing process is successful, the blue LED on
the headphones will stop flashing and stay on for 3
seconds.
3. The orange LED indicator lights up while the
headphones are charging.
4. The orange LED indicator will turn off when the battery
is fully charged.
5. Unplug the USB cable from the headphones.
When the battery is low, the orange LED will flash, and
an alert will sound in the speakers indicating that you
need to recharge the headphones.
Playing Music
The iMuffs Dock Adaptor for iPod enables the iPod to
transmit a stereo audio signal wirelessly to your iMuffs
Stereo Bluetooth Headphones, with a range of 30 feet
(10 meters).
1. Turn your iMuffs headphones on with the power
switch.
2. Plug the Bluetooth adaptor into the dock connector
port of your compatible iPod.
8. To increase the volume, rock the volume control up. To
decrease the volume, rock the volume control down.
The blue LED on the headphones will flash once
whenever a button is pressed, to indicate that a
Bluetooth signal has been transmitted. Accordingly, the
LED on the adaptor will flash whenever a Bluetooth
signal is received.
3. If your iPod is paused or asleep, press the menu
button on the iPod to resume operation.
4. Your iMuffs headphones and adaptor will automatically
connect. The blue LEDs on the headphones and
adaptor will flash while they seek a connection. When
the connection is successful, the LEDs will stay on for
3 seconds, and music will begin playing.
5. To pause music, you may press the Play/Pause button
on the headphones or the iPod itself. Pressing either
button again re-starts the music where it left off.
6. To access the next track, press the Next button. To
access the previous track, press the Previous button.
7. To fast-forward, press and hold the Next button. To
rewind, press and hold the Previous button.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 8
Creator                         : Adobe Illustrator(R) 10.0
For                             : No Spam,
Create Date                     : 1/18/06 6:51 PM
Bounding Box                    : 70 207 539 404
Creator Version                 : 10
Container Version               : 9
XMP Toolkit                     : XMP toolkit 2.9.1-13, framework 1.6
About                           : uuid:5cb3671d-0673-440d-a637-58ad8f61e6d8
Producer                        : Adobe PDF library 5.00
Modify Date                     : 2006:03:06 10:49:33-08:00
Creator Tool                    : Adobe Illustrator 10
Metadata Date                   : 2006:03:06 10:49:33-08:00
Document ID                     : uuid:294d3aa8-e727-450c-8b16-b0f78ed4809d
Format                          : application/pdf
Title                           : Manual2.ai
Image Height                    : 197
Image Width                     : 469
Image Size                      : 469x197
Megapixels                      : 0.092

EXIF Metadata provided by EXIF.tools