Wintop Electronics BT-535 Bluetooth sport headset User Manual

Wintop Electronics Co., Limited Bluetooth sport headset

User Manual

Wintop Electronics Co., LtdModel No.：BT-535Description：In-ear Bluetooth EarphoneChipset：WT200 V4.0Date: 2017.5.20Product ImageSPECIFICATION
WintopElectronicsCo.,LtdProduct SizeProduct MaterialsTPE cableSilicone ear cushionPC+ABS earbudsSilicone “+” buttonSilicone MFB buttonSilicone “-” buttonPC+ABS controllerCharging port
WintopElectronicsCo.,LtdProduct FunctionParameter min type max Unit remarksLi-battery Spec. 380926Capacity 60 mAhWorking Voltage 3.3 3.7 4.2 VoltWorking current（playing music）20 mAWorking current（on talking）24 mAStandby current 1 3 mACharging current 60 mACharging time 1.2 1.5 2 HTurn-off current 7 uA2.Frequency Spec.Frequency response 20 20k HzMax output power 5 mWSNR：1K@0dB With IEC -88 dBDistortion rate: 1K@0dB 0.8 %Bluetooth receiver sensitivity -88 dBmWorking distance 10 M/360 度3.MIC Spec.Working voltage 1.8 VTesting voltage 4.5 VSensitivity -39 -42 -45 dBSensitivity（At 1khz/0.178v）87 90 93 dBFrequency range 20 20K HzDistortion rate:5% in shole range at1kHz ≤5%Impedance at 1kHz 16±15% ohmOut put power 3 mw
WintopElectronicsCo.,LtdBT-535 Function/ManualModel No.: BT-535Keys FunctionDescrip. Method LED flash tips VoicepromptMFBkeyOn/pairingoff/connectLong press MFB about 2.5 sec to turn on device when it’s in offThen wait 12 secs it will go into pairing mode automaticallyOr long press MFB button for around 8 secs, device will go intoparing modeBlue LED flash 3 times(Blue&red LED will flashalternately)Power on(paring)Long press MFB about 2.5 sec to turn off device when it’s instandby mode Red LED flash 3 times Power offMake sure device and phone are within 1 meter for repairing itfirst timeTurn on phone’s bluetooth function to select device and choosepairing name. Blue LED flashes SortconnectedClick repairing password“0000” if needRepeat above steps if failed repairing;Short press MFB once to answer the callCallfunctionShort press MFB once to end the call when the call is onLong press MFB for 1 sec to reject a callcontinuouslyshort press MFB twice to remake the last call you’vecalled during standby mode or music is onPlay/pausemusicPlay music by short press MFB once when the music is pausedPause music by short press MFB once when the music is playing+/-Voiceup/downshort press “+” to make louder musicshort press “-” to make lower musicPrevious/next songlong press “+” to next songlong press “-” to previous song
Wintop Electronics Co., LtdFCC STATEMENT :This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference that may cause undesired operation.Warning: Changes or modifications not expressly approved by the party responsible for compliance could void theuser's authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant toPart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference ina residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one or more of the following measures:Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.

Navigation menu