Wonde Proud Technology WPBT55X BLUETOOTH GPS RECEIVER User Manual USERS MANUAL

Wonde Proud Technology Co., Ltd. BLUETOOTH GPS RECEIVER USERS MANUAL

USERS MANUAL

*** USER’S MANUAL ***FCC ID : SRKWPBT55X
The Federal Communication Commission StatementThis equipment has been tested and found to comply with the limits for a Class B Digital Device,pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and canradiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of the following measures: --Reorient or relocate the receiving antenna.-Increase the separation between the equipment and receiver.-Connect the equipment into an outlet on a circuit different from that to which the receiveris connected.-Consult the dealer or an experienced Radio/TV technician for help.Use only shielded cables to connect I/O devices to this equipment. You are cautioned that change or modifications not expressly approved by the party responsible for compliance could void yourauthority to operate the equipment.THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFULINTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERECE RECEIVED,INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.1. This device may not cause harmful interference and2. This device must accept any interference received, including interference that may causeundesired operation.
Wonde ProudBluetooth GPSReceiverUser’s GuideJun. 12, 2004 V 1.0Wound Proud Corporation21F, NO. 100, SEC. 1, SINTAL 5TH RD., SIJHIH CITY, TAIPEI COUNTY 221, TAIWAN, R. O. C.Tel:886-2-26961179 Fax: 886-2-26968499Web: www.wondeproud.com Email: sales@wondeproud.com
BT-55 Button & SignalsBT-55 Quick TipsAfter acquiring your BT-55, proceed with the following steps:1. Install battery prior to use. Battery needs to be charged for at least eight hours at the first time.Battery low When LED 1 flashes green light, it signals battery low. Connect BT-55 to a power source for continue operation and recharge simultaneously.ChargingʳʳʳWhen battery is being charged, LED 1 turns to orange light; When the battery has been fully charged, LED 1 turns on green light.2.Turn on BT-55Press the power button for 2 second or until LED1 turns into red and green light flashing, and the LED 2 turns to blue flashing light. This is to activate Bluetooth pairing, it only required once on first use.3. Activate Bluetooth function in your PDA / PCPrior to activating the Bluetooth function in our PDA / PC, make sure your device is equipped with Bluetooth function, and the driver software has been installed. Illustrations using HP 2100 PDA as follows:LED1LED2PowerButtonExternalPowerSocket
Make sure Bluetooth is turned onቹ3.1 ቹ3.2Notice the Bluetooth symbol changed ቹ3.3Bluetoothmode OffBluetoothmode ONClick here to access Bluetooth
4. Activate Bluetooth Manager & Established New Connectionsቹ4.1 ቹ4.2Before going to next step, press Bluetooth GPS key for 4 seconds until LED 2 starting to flash, signaling the connecting is in progress. ቹ4.3 ቹ4.4Click here Click hereClick hereClick here
Use PDA pen to tap and selectቹ4.5 ቹ4.6ቹ4.7 ቹ4.8EnterPass Key"0000",ThenPress“Enter”Click here to activate input deviceClick here to select installationClick here to select service Enter key
ቹ4.9 ቹ4.10At this point, Bluetooth GPS connection has been successfully establishedቹ4.11ClickhereClickhereEstablishedconnection
5. Connecting Bluetooth GPS with Electronic Mapቹ5.1 ቹ5.2How to access electronic map – take “Papago” for exampleቹ5.3 ቹ5.4ClickhereAccess Electronic Map via COM 8ClickhereClick hereClick here
ቹ5.5 ቹ5.6When selection and set up in illustration 5.5 remain unchanged, user may skip to next step, illustration 5.6 direct. ቹ5.7 ቹ5.8When LED 2 flashes, it is signaling Bluetooth GPS and the electronic map connection is in progress.SelectCOM 8Set up 9600 bpsClick herePress here after finishing setting upClick hereClick here
6.Turn off BT55Press power button for 2 second or until LED1 indicator flashing red and green lights simultaneously.At the point, power will be automatically shut off.Suggest turn off electronic map first, then GPS, to avoid possible PDA /PC freeze.7. About signalsLED1 : a. Red light indicates GPS tracking function has been activated.b. Orange light indicates BT 55 is being charged.c. Green light, while flashing, indicates battery low, steady indicates battery fully charged.LED2 : a. Blue light, flashing swiftly signals pairing, flashing once a second signals PDA/PC and BT 55 has been connected; flashing every 3 seconds signals connection failed.Note!! BT 55 is compatible with ASUS-620, Compaq 2210, PH, Palm.

Navigation menu