Wonde Proud Technology WPSPT100 GSM/GPRS SMART PERSON TRACKING User Manual PT100SampleGuide

Wonde Proud Technology Co., Ltd. GSM/GPRS SMART PERSON TRACKING PT100SampleGuide

Contents

USERS MANUAL

*** USER’S MANUAL ***
FCC ID : SRKWPSPT100
FCC label requirement
Please note :
(1) The device must be designed for mobile or fixed operation only. (portable
is not permitted and requires separate approval)
(2) The device bear a label with FCC ID:SRKWPSPT100 attached on the bottom
of the device and a second label with FCC ID:UDV-0606020060002 attached
on RF module inside the device .
(3) FCC label shown as :
FCC ID: SRKWPSPT100
Contains FCC ID:UDV-0606020060002
FCC RF exposure requirement
To allow compliance with RF exposure requirement for the device which
maximum output power at antenna input terminal:
(a) For GSM 850MHz / GSM 900MHz band is 33dBm (= 2W ) , the maximum antenna
gain with cable is 0.5 dBi .
(b) For DCS1800MHz / PCS1900MHz band is 30dBm (= 1W) ,the maximum antenna
gain with cable is 1.0 dBi .
The device must be installed to provide a separation distance of at least 20cm
from all persons’head or body ,and must not be co-located or operating in
conjunction with any other antenna or transmitter .
1. Normal Mode :
A. Normal :
Power Button Long Press : Power OFF.
Power Button Short Press : Switch To GPS Info. Mode.
Button 1 Long Press : Parking ON/OFF
Button 2 Long Press : Dial Emergency Phone 1 (Set Up By Utility).
Button 3 Long Press : Dial Emergency Phone 2 (Set Up By Utility).
Button 4 Long Press : Dial Emergency Phone 3 (Set Up By Utility).
Button 5 Long Press : Send Emergency SMS (Set Up By Utility).
System Modes
B. When Ring In :
Power Button Long Press : Power OFF.
Power Button Short Press : Pick Up Phone.
Button 1~4 Short/Long Press: Pick Up Phone.
Button 5 Short/Long Press: Hand Up Phone.
C. When Talking :
Power Button Long Press : Power OFF.
Button 3 Short Press: Volume Up.
Button 4 Short Press: Volume Down.
Button 5 Short Press: Hand Up Phone.
C. When Parking Enable:
Power Button Long Press : Power OFF.
Button 3 Short Press: Volume Up.
Button 4 Short Press: Volume Down.
Button 5 Short Press: Hand Up Phone.
2. GPS Information Mode :
No Fix :
Fix :
A. Normal
Power Button Long Press : Power OFF.
Power Button Short Press : Switch To Dial Phone Mode.
Button 2 Long Press : Dial Emergency Phone 1 (Set Up By Utility).
Button 3 Long Press : Dial Emergency Phone 2 (Set Up By Utility).
Button 4 Long Press : Dial Emergency Phone 3 (Set Up By Utility).
B. When Ring In :
Power Button Long Press : Power OFF.
Power Button Short Press : Pick Up Phone.
Button 1~4 Short/Long Press: Pick Up Phone.
Button 5 Short/Long Press: Hand Up Phone.
3. Dial Phone Mode :
Power Button Long Press : Power OFF.
Power Button Short Press : Switch To Normal Mode.
Button 1 Short Press : Select Current Number To Dial List.
Button 2 Short Press : Clear Current Number To Dial List.
Button 3 Short Press : Right Shift Number .
Button 4 Short Press : Lift Shift Number .
Button 5 Long Press : Dial Out.
Note : System will go back to normal mode after 10 sec without any button press
1. Unit Setting
Unit ID : The identification number of the unit. The default unit ID is 1010000001.
Pin Code : The PIN code of the GSM/GPRS SIM card. (Max. 4 digits)
Sync. Timer : Synchronization message sending interval in seconds.(10 ~ 65535
seconds) 0: Only one sync message be transmited when the unit
connected to the server.
GPRS APN : GPRS Access Point Name. (Max. 35 characters)
GPRS User Name : GPRS login user name (Max. 15 characters)
GPRS Password : GPRS login password (Max. 15 characters)
Host Address : The base station static WAN IP/DNS address. (Max. 30 characters)
Host Port : The base station application port number of the UDP/TCP
Host DNS : DNS IP address.
Utility Setting
1-1. Save Setting
2. Phone Setting
2-1. Save Setting
3 . Firmware Upgrade
3-1. Select Firmware file (*.BIN)
3-2. Check Checksum
3-3. Finish

Navigation menu