Wyse Technology J400 Windows-based Terminal User Manual

Download:
Mirror Download [FCC.gov]
Document ID	328826
Application ID	gCBKrrznrGFRwN2NM2U/JA==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	9.99kB (124822 bits)
Date Submitted	2003-05-28 00:00:00
Date Available	2003-05-28 00:00:00
Creation Date	2003-05-14 16:44:16
Producing Software	Acrobat Distiller 5.0 (Windows)
Document Lastmod	2003-05-14 16:45:00
Document Title	Winterm 9000 Series XPE-Based Terminals Quick Reference Guide
Document Creator	FrameMaker 6.0
Document Author:	Wyse Technology

xiii
FCC Statement
This equipment has been tested and found to comply with the limits for either Class A or
Class B digital devices (refer to "Terminal Requirements Compliance"), pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Caution
Changes or modifications not covered in this manual must be approved in
writing by the manufacturer’s Regulatory Engineering department. Changes
or modifications made without written approval may void the user’s authority
to operate the equipment.
Terminal Requirements Compliance
FCC Compliance
The Models 9235LE, 9440XL, and 9450XE terminals meet Class B requirements.
IEC/EN Compliance
The Model 9235LE, 9440XL, and 9450XE terminals meet Class B requirements.
Canadian DOC Notices
Refer to the previous section, "Terminal Requirements Compliance," to find out to which
terminal model each of the statements below refers.
Class A
This digital apparatus does not exceed the Class A limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la classe A prescrites dans le Réglement sur le
brouillage radioélectrique édicté par le Ministère des Communications du Canada.
xiv
Class B
This digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la classe B prescrites dans le Réglement sur le
brouillage radioélectrique édicté par le Ministère des Communications du Canada.
IEC/EN Notice
These products conform to the requirements of IEC950 and EN60950.
These products conform to requirements of EN55022 for Class A equipment or EN55022
for Class B equipment (refer to "Terminal Requirements Compliance").
Caution
For use with supplied power adaptor. Replace only with the same or
equivalent type as recommended by the manufacturer.
Model 9235LE Terminals
For use with External Power Supply DVE Model DSA-0301-05 or certified equivalent
model supplied by the manufacturer.
Model 9440XL Terminals
For use with External Power Supply Flytech/CARRY-I Model FT-8006A or certified
equivalent model supplied by the manufacturer.
Model 9450XE Terminal
For use with External Power Supply Li Shin Model LSE9802A1255 or certified equivalent
model supplied by the manufacturer.
Battery Information
The 9450XE terminal contains a replaceable battery.
Warning
There is a risk of explosion if the battery is replaced by an incorrect type.
Always dispose of used batteries according to the instructions accompanying
the battery.
Noise Suppressor
A noise suppressor (ferrite bead) must be installed on the network cable of your terminal.
This installation is necessary to maintain compliance with U.S. FCC B limits and European
CISPR B EN55022 Class B limits. The noise suppressor is supplied by the manufacturer
and is packed in your terminal’s shipping carton.
xv
Cable Notice
The use of shielded I/O cables is required when connecting this equipment to any and all
optional peripheral or host devices. Failure to do so may cause interference and violate
FCC and international regulations for electromagnetic interference.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Modify Date                     : 2003:05:14 16:45:00
Title                           : Winterm 9000 Series XPE-Based Terminals Quick Reference Guide
Subject                         : 883731-01 Rev. B
Author                          : Wyse Technology
Creator                         : FrameMaker 6.0
Producer                        : Acrobat Distiller 5.0 (Windows)
Create Date                     : 2003:05:14 16:44:16
Page Count                      : 3

EXIF Metadata provided by EXIF.tools