XIAMEN SUNLINK TECHNOLOGY RC002 Remote Control Handset User Manual

XIAMEN SUNLINK TECHNOLOGY CO., LTD. Remote Control Handset

Manual

USER Manual Note: Before starting of installation please read this instruction and keep it carefully. 1. Main structions and application fields: This Battery powered fountain pump is designed to run from provided battery pack, the battery pack should be placed in a dry place when you use it for a fountain that we provided or you purchase from other supplier. 2. Main parameter: Battery: LiPo Battery 7.4V Pump: DC6V-9V LED light: DC6V Remote Control Frequency: 433.92MHZ Power Witch Button of remote control handset: ON/OFF Button “2”: 2 hours timer Button “3”: 3 hours timer Button “4”: 4 hours timer 3. Installation and Maintenance a. Assemble the battery, pump, LED light and remote box as below drawing. b. Please always use the provided charger for battery charging in the home. c. Please make sure the pump fully in water before you turn on it by remote control handset d. Please remove the fountain pump, battery pack, remote control and LED lights and keep them all in the home during winter 4. Safety Directions: a. Please always use our provide charger for battery charging in the home. b. Please always place the battery pack in a dry place during use it FCC Statement: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device many not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Navigation menu