XIAMEN SUNLINK TECHNOLOGY RC002 Remote Control Handset User Manual
XIAMEN SUNLINK TECHNOLOGY CO., LTD. Remote Control Handset
Manual
USER Manual
Note: Before starting of installation please read this instruction and keep it carefully.
1. Main structions and application fields:
This Battery powered fountain pump is designed to run from provided battery pack,
the battery pack should be placed in a dry place when you use it for a fountain that we
provided or you purchase from other supplier.
2. Main parameter:
Battery: LiPo Battery 7.4V
Pump: DC6V-9V
LED light: DC6V
Remote Control Frequency: 433.92MHZ
Power Witch Button of remote control handset: ON/OFF
Button “2”: 2 hours timer
Button “3”: 3 hours timer
Button “4”: 4 hours timer
3. Installation and Maintenance
a. Assemble the battery, pump, LED light and remote box as below drawing.
b. Please always use the provided charger for battery charging in the home.
c. Please make sure the pump fully in water before you turn on it by remote control
handset
d. Please remove the fountain pump, battery pack, remote control and LED lights
and keep them all in the home during winter
4. Safety Directions:
a. Please always use our provide charger for battery charging in the home.
b. Please always place the battery pack in a dry place during use it
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device many not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.