Xmark H2H Infant Tag User Manual 980 000296 000 R1 0 indd

Xmark Corporation Infant Tag 980 000296 000 R1 0 indd

User Manual

StorageStore Hugs tags at room temperature.Speci cationsWarrantyVeriChip’s products are warranted against defects in materials and workmanship and shall perform in accordance with published specifi cations for a period of one year. VeriChip reserves the right to change specifi cations without notice.StatementsUnited States—Federal Communication Com-mission (FCC)This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environ-ment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful inter-ference in which case the user will be required to correct the interference at his own expense. Warning: Changes or modifications not expressly approved by VeriChip could void the user’s author-ity to operate the equipment.Canada—Industry CanadaThe term “IC:” before the certifi cation/registra-tion number only signifi es that Industry Canada technical specifi cations were met.European Union—CE declarationVeriChip hereby declares that this radio fre-quency transceiver tag is in compliance with the essential requirements and other relevant provi-sions of Directive 1999/5/EC.Limitation of LiabilityThis Product has been designed for use to assist in the prevention of infant abduction and/or mother/infant mismatching.The range, accuracy, function and performance of this Product may vary from the published speci-fi cations due to many factors, including, without limitation, site impairments from structural effects, metal objects in the vicinity, placement of the receiver and transmitter, interference from other electrical devices, atmospheric effects, installation, and maintenance. There may be other factors, which also affect performance of this Product. VeriChip does not guarantee that this Product will detect 100% of infant abductions and/or mother/infant mismatches. VeriChip does not guarantee that this Product will not return false reports of infant abductions and/or mother/infant mismatches. Monthly testing and maintenance of this Product, as described in the Product documentation, is essential to verify the system is operating correctly and to ensure that the probability of detecting an alarm and/or locating the transmitter are maximized. The failure to undertake regular testing and main-tenance will increase the risk of system failure and failure to detect infant abductions and/or mother/infant mismatches. The failure to undertake regular testing and maintenance will increase the risk of false reports of infant abductions and/or mother/infant mismatches.VeriChip hereby disclaims all warranties, express or implied, arising out of or in connection with any of its Products of the use or performance thereof, including but not limited to, where allowable by law, all other implied warranties or conditions of merchantable quality and fi tness for a particular purpose and those arising by statute or otherwise in law or from a course of dealing or usage of trade.VeriChip’s liability to you or anyone claiming through or on behalf of you with respect to any claim or loss arising out of the use or misuse of VeriChip’s Product, defective products or materials, improper installation or maintenance of VeriChip’s Product or products or the system in which they are incorporated, or alleged to have resulted from an act or omission of VeriChip or any person, negligent or otherwise, shall be limited to:A) the repair or replacement of defective Product or materials supplied by VeriChip during the warranty period as set out in the Product docu-mentation; or, at the option of VeriChip,B) refund of the purchase price of the Product supplied by VeriChip.In no event shall VeriChip be liable for general, specific, indirect, consequential, incidental, exemplary or punitive damages or any losses or expenses suffered by you or anyone else, whether or not VeriChip, or its employees, offi cers, agents, resellers or installers has been informed of the risk of such loss or expense and whether or not such losses or expenses were foreseeable.Frequency 433.92 MHzSupply Voltage 3.0 VDCBattery Life Warranted for one yearRF Transmission Rate0.2 sec in alarm mode, 10 sec at other times (typical)Temperature 32°F to 120°F (0°C to 49°C)Humidity 0-85% RH @ 70°F (21°C), non-condensingDimensions 1.2 x 0.52 x 1.4 in. (29 x 13 x 34 mm)Weight 0.35 oz. (10 g)Part No. 600-000296-000309 Legget Drive Ottawa, ON K2K 3A3 Canada Telephone: 1-866-559-6275 International: +1 613-592-6997 Facsimile: 1-613-592-4296 Web Site: www.verichiphealthcare.com© 2006 VeriChip Corporation. All Rights Reserved. Hugs, the Hugs logo and Kisses are registered trademarks of VeriChip Corporation Inc. in North America. VeriChip and the VeriChip logo are trademarks of VeriChip Corporation. All other company and product names may be trademarks of their respective companies. Printed in Canada. May 2006. 980-000296-000 R1.0Hugs® Tag User Guide
IntroductionThe Hugs® is part of the Hugs infant pro-tection system. The tag is attached to the infant using a tamper-proof strap. From the moment of attachment, the infant is automatically enrolled in the system, and protected against abduction. The Hugs tag incorporates a special sensor to detect if the strap is cut. In addition, attempting to remove the infant without authorization from the protected area will immediately cause an alarm. With optional with BabySense™ functional-ity, the Hugs tag can also detect when it is not securely attached to the infant.The Hugs tag may also be used with the optional Kisses® mother/infant matching component of the Hugs system to confi rm that the correct infant is matched with the correct mother. The Hugs tag automati-cally emits an audible beep to indicate an incorrect match.The Hugs tag is reusable, and does not interfere with other hospital or personal medical equipment. The patented asymmetrical shape of the tag ensures that it does not pinch or irritate the baby’s skin, and also helps prevent it from being kicked off, while still allowing the ankle joint to move freely. The tag is water proof which allows bathing of the infant. It is also resistant to soiling and UV light. Note: The tag is not sterilized at the fac-tory. You may wish to clean the tag prior to fi rst use.Items Required• Hugs tag (p/n 600-000296-000)• Hugs tag straps (p/n 806A1401)• Safety scissorsAttaching the Tag1 Align strap with tag slot.2 Make sure “This side out” is on the outside.3 Insert strap into tag slot starting from bottom of tag. 4 Pull through until the brown material extends beyond the slot.1 Wrap tag around baby’s ankle, and insert loose end of strap into second tag slot. 2 Pull strap through, and listen for the battery status chime (two short beeps). Check that the tag is snug and won’t rotate. The bottom (black) side of the tag and the strap must be fi rmly in contact with the baby’s skin.3 Trim both ends of strap.Check the following:• Tag wiggles, but won’t rotate easily.• Back of tag and strap are touching the baby’s skin. • Tag has Auto Admitted in the Hugs system software.Cleaning the TagFollow these recommendations for cleaning the tag.• Use any standard hospital disinfectant cleaner designed for plastics.• Do not soak the tag or immerse it when cleaning. • Thoroughly rinse the tag with water after cleaning• Do not use an autoclave to clean the tag or serious damage may result.Battery Status InformationThe Hugs system software automatically displays a Low Battery notifi cation if the Hugs tag enters a low battery state during use. However, depending on conditions, the battery may expire between uses.If you do not hear the battery status chime (two short beeps) during tag attachment, immediately dispose of the tag and attach a new tag to the infant.The front of the Hugs tag shows the war-ranty expiration date. The tag may have many months of use after this date, but you should exercise caution when using a tag out of warranty. Always listen for the battery status chime, and check that the tag has Auto Admitted in the Hugs system software.Handling InformationBattery Handling - this device contains a lithium battery. Do not force open, heat to 212°F (100°C), or dispose of in fi re.X-rays - Do not directly expose the tag to X-rays. (The tag is not affected by stray radiation.)Instructions for the Hugs® TagMAKE SURE BACKOF TAG AND STRAP TOUCH BABY’S SKINCerti ed to the ISO 9001 Quality Standard

Navigation menu