YUXINXIN ELECTRONICS 20180805 2-in-1 Audio Adapter User Manual

SHENZHEN YUXINXIN ELECTRONICS CO.,LTD 2-in-1 Audio Adapter Users Manual

User manual

RECEIVERTRANSMITTERBLS-TX7 2-in-1 Audio AdapterThe mode fo receiver感谢你购买本产品，使用前请详阅使用说明书1.3颗LED指示灯 4.Micro USB 充电孔2.电源开关 5.3.5mm音频输入3.3.5mm音频输出注意：发射和接收模式不能同时进行！按电源开关键越3秒即可开/关机开/关机 供电方式另购将内附充电线分别插入商品Micro USB及电脑USB孔/AC旅冲(另购)/车充(另购)/移动电源(另购)充电即可接收模式将3.5mm接头插入3.5mm输入孔（粉红孔位）按电源开关键约3秒后，右侧（RECEIVER）的LED指示灯蓝灯闪烁，此时即可进行配对开启手机（平板）蓝牙模式，搜索可配对装置，列表中选择，点选”BLS-TX7"配对配对成功后，右侧（RECEIVER）蓝灯常亮此时手机（平板）显示已连接将另一端3.5mm接头插入音响或者喇叭等设备，即可由喇叭等设备播放手机（平板）的音乐发射模式将3.5mm接头插入3.5mm输出孔(绿色孔位)另一端3.5mm接头插入电脑或者MP3等设备 按电源开关键3秒后,左侧(TRANSMITTER)的LED指示灯蓝灯闪烁,开启蓝牙设备(蓝牙耳机,蓝色音响)并进入配对模式约3~10秒,发射器自动搜索周边蓝牙设备,配对完成后,左侧(TRANSMITTER)侧蓝色灯常亮即可由蓝牙耳机(音响)等播放电脑或者MP3等设备的音乐接收模式连接示意图发射模式连接示意图注意事项本产品内置电池,所以必须在干燥的地方存放,不可以丢进水里或太潮湿的地方不可以拆卸本产品,以免触电!不可用力敲打以免损坏使用说明书BLS-TX7 二合一音频适配器发射蓝牙耳机蓝牙音响电视台式机电脑家用立体音响接收智能手机(平板)有线耳机笔记本电脑汽车音响指示燈低 电 量 ：红灯连闪三下,两分钟检测一次充电状态：充电中 红灯常亮 满 电 红灯熄灭BLS -TX 7BLS -TX 7BLS -TX 7BLS -TX 7Turn on the Bluetooth mode of the cell phone (tablet), search for the devices that can be matched, select from the list, point and select “BLS-TX7” for the match FCC StatementChanges or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:-- Reorient or relocate the receiving antenna.-- Increase the separation between the equipment and receiver.-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.-- Consult the dealer or an experienced radio/TV technician for helpThis device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

Navigation menu