Yamaha Ag03 Specifications Technical
AG03 Technical Specifications ag03_en_ts_a0
AG03 スペックシート ag03_enforja_ts_a0
2015-03-09
: Yamaha Ag03-Specifications yamaha-ag03-specifications-646882 yamaha pdf
Open the PDF directly: View PDF 
.
Page Count: 2
| Download | |
| Open PDF In Browser | View PDF |
ZN43270 MIXING CONSOLE Analog Input Characteristics 0 dBu = 0.775 Vrms Technical Specifications GAIN Trim/SW Position PAD 26 dB Input Jack Input Level For Use with Nominal Actual Load Impedance Sensitivity *1 Nominal Max. Before Clip 10 -72 dBu (0.195 mV) -60 dBu (0.775 mV) -50 dBu (2.451 mV) 0 -26 dBu (38.84 mV) -14 dBu (154.6 mV) -4 dBu (489.0 mV) -46 dBu (3.884 mV) -34 dBu (15.46 mV) -24 dBu (48.90 mV) 0 0 dBu (775.0 mV) +12 dBu (3.085 V) +22 dBu (9.757 V) HIGH -32 dBu (19.5 mV) -20 dBu (77.5 mV) -10 dBu (245.1 mV) LOW -12 dBu (194.7 mV) 0 dBu (775.0 mV) +10 dBu (2.451 V) HIGH -20 dBu (77.5 mV) -8 dBu (308.5 mV) +2 dBu (973.7 mV) -10 dBu (245.1 mV) +2 dBu (975.7 mV) +12 dBu (3.085 V) -14 dBu (154.6 mV) -8 dBu (308.5 mV) +2 dBu (975.7 mV) OFF General Specifications MIC/LINE 1 HEADSET MIC 10 0 dBu = 0.775 Vrms, Output impedance of signal generator (Rs) = 150 Ω Total Harmonic Distortion *1 (THD+N) Hum&Noise *2 (20 Hz to 20 kHz) Input (MIC) to MONITOR OUT via USB IN/OUT +0.5 dB/-1.5 dB (20 Hz to 48 kHz @ Fs = 192 kHz), refer to the nominal output level @ 1 kHz, GAIN knob: Min, TO PC: DRY CH1-2G Input to MONITOR OUT 0.05% @ 0 dBu (20 Hz to 20 kHz), GAIN knob: Min 0.01% @ +4 dBu (1 kHz), GAIN knob: Min Equivalent Input Noise -128 dBu (Mono Input Channel, Rs: 150 Ω, GAIN knob: Max) Residual Output Noise -103 dBu (MONITOR OUT, MONITOR knob: Min) Crosstalk (1 kHz) *3 -80 dB Input Channels Mono (MIC/LINE): 1 including HEADSET MIC (Plug-in Power) (CH1 MIC and HEADSET MIC cannot be used simultaneously.), Stereo (LINE) / Mono (GUITAR) :1, USB IN:1, AUX IN:1 Output Channels MONITOR OUT: 2, PHONES: 2 including HEADSET PHONES (PHONES and HEADSET PHONES cannot be used simultaneously.) Bus Stereo: 1 PAD 26 dB DSP COMP/EQ, EFFECT (SPX Reverb) PEAK LED LED turns on when the signal reaches 3 dB below clipping level. Level Meter USB Output Level 2x2 point LED meter [PEAK, SIG] USB Audio 2 IN / 2 OUT USB Audio Class 2.0 compliant, Sampling Frequency: Max 192 kHz, Bit Depth: 24-bit Input Channel Function (CH1) 50–600 Ω Mics/Lines ON All level controls are nominal if not specified. Frequency Response 3 kΩ 1.5 kΩ*4 Phantom Power Voltage +48 V FOOT SW EFFECT Mute on/off Power Requirements DC 5 V, 500 mA Power Consumption Max. 2.5 W Dimensions (WxHxD) 129 mm x 63 mm x 202 mm (5.1” x 2.5” x 8.0”) Net Weight 0.8 kg (1.8 lbs) Included Accessory USB Cable (1.5 m), CUBASE AI DOWNLOAD INFORMATION, Owner’s Manual, Technical Specifications (this leaflet) Optional Accessory Foot Switch: FC5, Mic Stand Adaptor: BMS-10A Operating Temperature 0 to +40°C *1 THD+N is measured with 22 kHz LPF. *2 Noise is measured with A-weighting filter. *3 Crosstalk is measured with 1 kHz band pass filter. The contents of this manual apply to the latest specifications as of the printing date. Since Yamaha makes continuous improvements to the product, this manual may not apply to the specifications of your particular product. To obtain the latest manual, access the Yamaha website then download the manual file. Since specifications, equipment or separately sold accessories may not be the same in every locale, please check with your Yamaha dealer. GUITAR 2G - LINE 2/3 1 MΩ - - 10 kΩ 600 Ω Lines 10 kΩ 600 Ω Lines LOW AUX - - Connector Combo jack *2 (Balanced) 3.5 mm Phone jack for HEADSET MIC (Plug-in-Power/ Unbalanced) Phone jack *3 (Unbalanced) Phone jack *3 (Unbalanced) Stereo mini jack *1 Sensitivity is the lowest level that will produce an output of +0 dBu (0.775 V) or the nominal output level when the unit is set to maximum gain. (All level controls are at their maximum position.) *2 1&Sleeve = GND, 2&Tip = HOT, 3&Ring = COLD *3 Tip = Signal, Sleeve = GND *4 For CH1, HEADSET MIC Analog Output Characteristics 0 dBu = 0.775 Vrms Output Terminal Actual Source Impedance Output Level For Use with Nominal Connecter Nominal Max. Before Clip Phone jack *5 (Impedance Balanced) MONITOR OUT [L, R] 150 Ω 10 kΩ Lines 0 dBu (0.775 V) +10 dBu (2.451 V) RCA pin (Unbalanced) PHONES 120 Ω 40 Ω Phones 1.5 mW + 1.5 mW 6 mW + 6 mW Stereo phone jack Stereo mini jack *5 Tip = HOT, Ring = COLD, Sleeve = GND Digital Input / Output Characteristics Terminal Format Data Length Sampling Frequency Connector USB USB Audio Class 2.0/ Yamaha Steinberg USB Driver 24-bit 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz, 192 kHz USB Standard-B Block and Level Diagrams Dimensions Unit: mm L MONITOR MUTE +48V MONITOR 56 129 OFF⇔ON INPUT 1 [MIC/LINE] PAD=off: -60 ~ -14dBu PAD=on: -34 ~ +12dBu PAD GAIN 26dB HA PEAK COMP/EQ LEVEL 2.3 R L R 63 +48V MONITOR OUT (L/R) EFFECT [MONITOR OUT L/R] Nominal Output: 0dBu (@10kΩ) Maximum Output: +10dBu (@10kΩ) HPF/COMP/EQ PUSH PUSH OFF⇔ON [MONITOR MUTE] CH1-2G MUTE REVERB HEADSET (Mic) TO PC 201 AMP SIM GAIN GUITAR LEVEL PHONES INPUT 2/3 [GUITAR] -20dBu/+0dBu GUITAR Hi-Z PHONES (L/R) [TO PC] TOP: DRY CH1-2G MID: INPUT MIX BOT: LOOPBACK HIGH⇔LOW [LINE] -8dBu/+2dBu 202 [MIC (Plug in power)] HEADSET (Phones) (L/MONO) [PHONES L/R] Nominal Output: 1.5mW (@40Ω) Maximum Output: 6.0mW (@40Ω) HIGH⇔LOW (R) 28 METER HIGH⇔LOW L R 28 [METER] PEAK SIG Jack and Plug List USB FOOT SW [USB AUDIO] from PC [FOOT SW] Fx On-Off POWER LEVEL L R AUX INPUT USB AUDIO IN 5V DC POWER R DETECT +10dBu 0dBu Maximum Input Level: [+22dBu] -26dB -2dB +10dB +14dB MONO INPUT MIC: [-14dBu] @GAIN=min +60dB MONO INPUT LINE: [-34dBu] @GAIN=max -2dB MONO INPUT MIC: [-60dBu] @GAIN=max Clip Level: [+10dBu] Maximum Input Level: [+2dBu] Clip Level: [+10dBu] USB Audio from PC: [+7dBu] +8dB AUX INPUT: [-8dBu] Hi-Z: [+0dBu] @GAIN=LOW Maximum Input Level: +20dB [-10dBu] @GAIN=HIGH -6dB +6dB Level Control Maximum Output Level: [+10dBu] -2dB -10dB +3dB USB Audio Level Control -16dB MONITOR OUTPUT: [0dBu] -12dB +20dB PHONES Level Control Maximum Output Level: [6mW] @40Ω PHONES: [1.5mW] @40Ω -6dB +6dB MONITOR Level Control +10dBu 0dBu -10dBu MIC/LINE* MONITOR OUT* Tip: Hot (+) Ring: Cold (-) Sleeve: Ground Balanced HEADSET MIC Tip: Signal Ring: Sleeve: Ground Unbalanced PHONES AUX Tip: L Ring: R Sleeve: Ground - LINE 2/3 GUITAR Tip: Signal Sleeve: Ground INPUT TRS Phone Plug Ring Sleeve Tip TS Phone Plug Unbalanced Sleeve Tip -20dBu -30dBu -40dBu -26dB -50dBu -60dBu STEREO INPUT LINE: [-8dBu]@GAIN=HIGH [-8dBu] @GAIN=HIGH STEREO INPUT LINE: [+2dBu] @GAIN=LOW Hi-Z: [-20dBu] @GAIN=HIGH -30dBu -40dBu Maximum Input Level: [+2dBu] Maximum Input Level: [-4dBu] -10dBu -20dBu Balanced +20dBu Maximum Input Level: [+10dBu] @GAIN=LOW Maximum Input Level: [+12dBu] Clip Level: [+10dBu] Configurations XLR Jack MIC/LINE +30dBu MONO INPUT LINE: [+12dBu] @GAIN=min Balanced/ Unbalanced Pin 1: Ground Pin 2: Hot (+) Pin 3: Cold (-) USB 2.0 L/R +20dBu Polarities L OUT [LINE] -8dBu +30dBu Jacks and Plugs -50dBu * These jacks also can be connected with TS phone plugs. If you use TS phone plugs, the connection will be unbalanced. -60dBu Manual Development Department ©2015 Yamaha Corporation Published 01/2015 MWZC*.*-01A0 Printed in Indonesia
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes Encryption : Standard V4.4 (128-bit) User Access : Print, Copy, Annotate, Fill forms, Extract, Print high-res Author : Manual Development Department, Yamaha Corporation Create Date : 2014:12:10 14:13:33+09:00 Modify Date : 2014:12:10 14:16:57+09:00 XMP Toolkit : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26 Metadata Date : 2014:12:10 14:16:57+09:00 Format : application/pdf Title : AG03 Technical Specifications Creator : Manual Development Department, Yamaha Corporation Document ID : uuid:8656207d-d2de-4ac5-b141-eaaff9b3dd2e Instance ID : uuid:302a222b-5868-4c37-8343-cd452b2f2cb8 Page Count : 2EXIF Metadata provided by EXIF.tools