Yamaha Ag03 Specifications Technical

AG03 Technical Specifications ag03_en_ts_a0

AG03 スペックシート ag03_enforja_ts_a0

2015-03-09

: Yamaha Ag03-Specifications yamaha-ag03-specifications-646882 yamaha pdf

Open the PDF directly: View PDF PDF.
Page Count: 2

General Specifications
0 dBu = 0.775 Vrms, Output impedance of signal generator (Rs) = 150 Ω
All level controls are nominal if not specified.
Frequency Response Input (MIC) to MONITOR OUT
via USB IN/OUT
+0.5 dB/-1.5 dB (20 Hz to 48 kHz @ Fs = 192 kHz),
refer to the nominal output level @ 1 kHz, GAIN knob: Min, TO PC: DRY CH1-2G
Total Harmonic Distortion *1
(THD+N) Input to MONITOR OUT 0.05% @ 0 dBu (20 Hz to 20 kHz), GAIN knob: Min
0.01% @ +4 dBu (1 kHz), GAIN knob: Min
Hum&Noise *2
(20 Hz to 20 kHz)
Equivalent Input Noise -128 dBu (Mono Input Channel, Rs: 150 Ω, GAIN knob: Max)
Residual Output Noise -103 dBu (MONITOR OUT, MONITOR knob: Min)
Crosstalk (1 kHz) *3 -80 dB
Input Channels
Mono (MIC/LINE): 1 including HEADSET MIC (Plug-in Power)
(CH1 MIC and HEADSET MIC cannot be used simultaneously.),
Stereo (LINE) / Mono (GUITAR) :1, USB IN:1, AUX IN:1
Output Channels MONITOR OUT: 2, PHONES: 2 including HEADSET PHONES
(PHONES and HEADSET PHONES cannot be used simultaneously.)
Bus Stereo: 1
Input Channel Function
(CH1)
PAD 26 dB
DSP COMP/EQ, EFFECT (SPX Reverb)
PEAK LED LED turns on when the signal reaches 3 dB below clipping level.
Level Meter USB Output Level 2x2 point LED meter [PEAK, SIG]
USB Audio 2 IN / 2 OUT USB Audio Class 2.0 compliant, Sampling Frequency: Max 192 kHz, Bit Depth: 24-bit
Phantom Power Voltage +48 V
FOOT SW EFFECT Mute on/off
Power Requirements DC 5 V, 500 mA
Power Consumption Max. 2.5 W
Dimensions (WxHxD) 129 mm x 63 mm x 202 mm (5.1” x 2.5” x 8.0”)
Net Weight 0.8 kg (1.8 lbs)
Included Accessory USB Cable (1.5 m), CUBASE AI DOWNLOAD INFORMATION, Owner’s Manual,
Technical Specifications (this leaflet)
Optional Accessory Foot Switch: FC5, Mic Stand Adaptor: BMS-10A
Operating Temperature 0 to +40°C
*1 THD+N is measured with 22 kHz LPF.
*2 Noise is measured with A-weighting filter.
*3 Crosstalk is measured with 1 kHz band pass filter.
The contents of this manual apply to the latest specifications as of the printing date. Since Yamaha makes continuous improvements to the product, this manual may not apply to the
specifications of your particular product. To obtain the latest manual, access the Yamaha website then download the manual file. Since specifications, equipment or separately sold
accessories may not be the same in every locale, please check with your Yamaha dealer.
Analog Input Characteristics
0 dBu = 0.775 Vrms
Input Jack PAD
26 dB
GAIN
Trim/SW
Position
Actual
Load
Impedance
For Use
with
Nominal
Input Level
Connector
Sensitivity *1 Nominal Max. Before
Clip
MIC/LINE 1
HEADSET MIC
OFF
10
3 kΩ
1.5 kΩ*4
50–600 Ω
Mics/Lines
-72 dBu
(0.195 mV)
-60 dBu
(0.775 mV)
-50 dBu
(2.451 mV)
Combo jack *2
(Balanced)
3.5 mm Phone jack
for HEADSET MIC
(Plug-in-Power/
Unbalanced)
0-26 dBu
(38.84 mV)
-14 dBu
(154.6 mV)
-4 dBu
(489.0 mV)
ON
10 -46 dBu
(3.884 mV)
-34 dBu
(15.46 mV)
-24 dBu
(48.90 mV)
00 dBu
(775.0 mV)
+12 dBu
(3.085 V)
+22 dBu
(9.757 V)
GUITAR 2G -
HIGH
1 MΩ -
-32 dBu
(19.5 mV)
-20 dBu
(77.5 mV)
-10 dBu
(245.1 mV) Phone jack *3
(Unbalanced)
LOW -12 dBu
(194.7 mV)
0 dBu
(775.0 mV)
+10 dBu
(2.451 V)
LINE 2/3 -
HIGH
10 kΩ 600 Ω Lines
-20 dBu
(77.5 mV)
-8 dBu
(308.5 mV)
+2 dBu
(973.7 mV) Phone jack *3
(Unbalanced)
LOW -10 dBu
(245.1 mV)
+2 dBu
(975.7 mV)
+12 dBu
(3.085 V)
AUX - - 10 kΩ 600 Ω Lines -14 dBu
(154.6 mV)
-8 dBu
(308.5 mV)
+2 dBu
(975.7 mV) Stereo mini jack
*1 Sensitivity is the lowest level that will produce an output of +0 dBu (0.775 V) or the nominal output level when the unit is set to maximum gain.
(All level controls are at their maximum position.)
*2 1&Sleeve = GND, 2&Tip = HOT, 3&Ring = COLD
*3 Tip = Signal, Sleeve = GND
*4 For CH1, HEADSET MIC
Analog Output Characteristics
0 dBu = 0.775 Vrms
Output Terminal Actual Source
Impedance For Use with Nominal
Output Level
Connecter
Nominal Max. Before Clip
MONITOR OUT [L, R] 150 Ω 10 kΩ Lines 0 dBu (0.775 V) +10 dBu (2.451 V)
Phone jack *5
(Impedance Balanced)
RCA pin
(Unbalanced)
PHONES 120 Ω 40 Ω Phones 1.5 mW + 1.5 mW 6 mW + 6 mW Stereo phone jack
Stereo mini jack
*5 Tip = HOT, Ring = COLD, Sleeve = GND
Digital Input / Output Characteristics
Terminal Format Data Length Sampling Frequency Connector
USB USB Audio Class 2.0/ Yamaha Steinberg USB Driver 24-bit 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz, 192 kHz USB Standard-B
ZN43270
MIXING CONSOLE
Technical Specifications
Block and Level Diagrams Dimensions
Manual Development Department
©2015 Yamaha Corporation
Published 01/2015 MWZC*.*-01A0
Printed in Indonesia
+30dBu
+20dBu
+10dBu
0dBu
-10dBu
-30dBu
-40dBu
-50dBu
-60dBu
-20dBu
+30dBu
+20dBu
+10dBu
0dBu
-10dBu
-30dBu
-40dBu
-50dBu
-60dBu
-20dBu
MONO INPUT MIC: [-60dBu] @GAIN=max
MONO INPUT LINE: [-34dBu] @GAIN=max MONO INPUT LINE: [-34dBu] @GAIN=max
MONO INPUT LINE: [+12dBu] @GAIN=min
Maximum Input Level: [+22dBu]
Clip Level: [+10dBu]
Maximum Input Level: [-4dBu]
Maximum Input Level: [+2dBu]
Maximum Output Level: [+10dBu]
MONO INPUT MIC: [-14dBu] @GAIN=min
26dB
OFF⇔ON
PHONES Level Control
MONITOR Level Control
MONITOR OUTPUT: [0dBu]
PHONES: [1.5mW] @40Ω
Maximum Output Level: [6mW] @40Ω
HA
STEREO INPUT LINE:
[+2dBu] @GAIN=LOW
Maximum Input Level: [+12dBu]
+48V
[FOOT SW]
Fx On-Off
L
R
LEVEL
Level Control
Clip Level: [+10dBu]
AUX INPUT: [-8dBu]
Maximum Input
Level: [+2dBu]
USB Audio Level Control
Clip Level: [+10dBu]
USB Audio
from PC: [+7dBu]
[MONITOR MUTE]
CH1-2G MUTE
[TO PC]
TOP: DRY CH1-2G
MID: INPUT MIX
BOT: LOOPBACK
L
R
[METER]
PEAK
SIG
REVERB
PUSH
Maximum Input Level:
[+10dBu] @GAIN=LOW
Hi-Z: [+0dBu]
@GAIN=LOW
Hi-Z: [-20dBu] @GAIN=HIGH
Maximum Input Level:
[-10dBu] @GAIN=HIGH
[LINE]
-8dBu/+2dBu
[GUITAR]
-20dBu/+0dBu
Hi-Z
INPUT 1
[MIC/LINE]
PAD=off: -60 ~ -14dBu
PAD=on: -34 ~ +12dBu
HEADSET
(Mic)
[MIC (Plug in power)]
INPUT 2/3
FOOT SW
[LINE]
-8dBu
AUX INPUT
GUITAR
(L/MONO)
(R)
L / R
GAIN
PAD PEAK COMP/EQ
LEVEL
GAIN GUITAR LEVEL
EFFECT
MONITOR
PHONES
MONITOR MUTE
METER
USB
L R
MONITOR
OUT (L/R)
PHONES
(L/R)
[MONITOR OUT L/R]
Nominal Output: 0dBu (@10kΩ)
Maximum Output: +10dBu (@10kΩ)
[PHONES L/R]
Nominal Output: 1.5mW (@40Ω)
Maximum Output: 6.0mW (@40Ω)
USB 2.0
5V DC
HEADSET
(Phones)
TO PC
[USB AUDIO]
from PC
+48V
OFF⇔ON
HIGH⇔LOW
HIGH⇔LOW
HIGH⇔LOW
PUSH
HPF/COMP/EQ
AMP
SIM
USB AUDIO
IN OUT
L
R
L
R
POWER
DETECT
POWER
-26dB
-26dB
+60dB
+14dB
-2dB +10dB
-2dB
+8dB
+20dB
-6dB +6dB
-10dB
+3dB
-16dB +20dB
-2dB
-12dB -6dB +6dB
STEREO INPUT LINE:
[-8dBu]@GAIN=HIGH
STEREO INPUT LINE:
[-8dBu] @GAIN=HIGH
129
28
28
56
202
201
2.3
63
Unit: mm
Jack and Plug List
Jacks and Plugs Polarities Balanced/
Unbalanced Congurations
MIC/LINE
Pin 1: Ground
Pin 2: Hot (+)
Pin 3: Cold (-)
Balanced
XLR Jack
INPUT
MIC/LINE*
MONITOR OUT*
Tip: Hot (+)
Ring: Cold (-)
Sleeve: Ground
Balanced
Ring
TipSleeve
TRS Phone Plug
HEADSET MIC
Tip: Signal
Ring: -
Sleeve: Ground
Unbalanced
PHONES
AUX
Tip: L
Ring: R
Sleeve: Ground
-
LINE 2/3
GUITAR
Tip: Signal
Sleeve: Ground Unbalanced
TipSleeve
TS Phone Plug
* These jacks also can be connected with TS phone plugs. If you use TS phone plugs, the connection will
be unbalanced.

Navigation menu