Yamaha A3090/CON GUIDE(6/24) DSP A3090guide OWNER'S MANUAL
User Manual: Yamaha DSP-A3090guide OWNER'S MANUAL
Open the PDF directly: View PDF 
.
Page Count: 8
| Download | |
| Open PDF In Browser | View PDF |
DSP-A3090 GUIDE TO SYSTEM CONNECTION NATURAL SOUND DIGITAL SOUND FIELD PROCESSING AMPLIFIER CINEMA DSP 7ch DSP A3090 AC-3 PROCESSOR POWER TAPE 2 MONITOR AC 3 PRO LOGIC DSP DIGITAL SOURCE AC 3 PCM INPUT SELECTOR INPUT TRIM SET MENU PROGRAM EFFECT INPUT MODE VCR 1 PHONES VIDEO AUX S VIDEO VIDEO L AUDIO R BASS EXTENSION BASS TREBLE BALANCE VOLUME LD TV/DBS TAPE 1 TUNER REC OUT VCR 1 SOURCE TAPE 1 LD CD TV/DBS VCR 2 VCR 2 CD VCR 3/DVD PHONO VCR 3/DVD VIDEO AUX VIDEO AUX Set Up The Speakers Before Making Connections Place the Front Effect Speakers further apart from the Main Speakers, on either side of and a few feet behind and above the Main Speakers. If you will use a Subwoofer such as a Yamaha Active Servo Subwoofer System, the position of the subwoofer is not so critical because low bass tones are not highly directional. Place the Main Speakers in the normal position. Place the Rear Effect Speakers behind your listening position. They should be nearly six feet up from the floor. Place the Center Speaker precisely between the two Main Speakers. Main speaker Effect speaker Center speaker CONNECTING SPEAKERS Main Speaker R Main Speaker L Rear Speaker R AUDIO SIGNAL AUDIO SIGNAL VIDEO SIGNAL VIDEO O Rear Speaker L SPEAKERS A MAIN S VIDEO CENTER B A +B LD A OR B TV/DBS A + B: 4ΩMIN./SPEAKER A OR B: 8ΩMIN./SPEAKER 8ΩMIN./SPEAKER IN R FRONT REAR VCR 1 OUT E 1 AC OUTLETS SWITCHED IN VCR 2 E 8ΩMIN./SPEAKER 8ΩMIN./SPEAKER COUPLER OUT MONO SPLIT 2 IN FRONT MIX MAIN LEVEL VCR 3/DVD PAL NTSC 5ch 7ch VCR 3/DVD OUT CAN BE USED AS A 2ND MONITOR OUT, IF SELECTED MONITOR OUT BY SET MENU. I20V 60Hz I20W MAX. TOTAL ON OFF —I0dB 0dB OUT Front Effect Speaker R PRE MAIN OUT IN MAIN CH OUT CENTER IN SUB WOOFER FRONT REAR EFFECT Front Effect Speaker L Connect bare ends of speaker wires to terminals or use Banana Plugs Red: positive (+) Black: negative (–) 2 3 1 2 ➀ Unscrew the knob. ➁ Insert the bare wire. ➂ Tighten the knob and secure the wire. CENTER SPEAKER(S) To Use Two Center Speakers To Use One Center Speaker Set to “A + B”. SPEAKERS A SPEAKERS B CENTER A CENTER B A +B A+ B A OR B A OR B A + B: 4ΩMIN./SPEAKER A OR B: 8ΩMIN./SPEAKER A + B: 4ΩMIN./SPEAKER A OR B: 8ΩMIN./SPEAKER Set to “A OR B”. S UNSWITCHED I20V 60Hz I80W MAX. SUBWOOFER To Use One Subwoofer System MONO To Use Two Subwoofer Systems SPLIT MONO SUB WOOFER POWER HIGH CUT 40 Hz 140 Hz VOLUME 0 10 SPLIT SUB WOOFER R POWER HIGH CUT 40 Hz 140 Hz VOLUME 0 POWER 10 HIGH CUT 40 Hz 140 Hz VOLUME 0 10 L VV35040 CONNECTING VIDEO COMPONENTS 1 Audio Connections DIGITAL OUT LD Player AUDIO SIGNAL AUDIO SIGNAL VIDEO PHONO CD CD L IN R IN R OUT VIDEO SIGNAL GND LD L OUT R OUT L OUT R OUT DIGITAL OUT AC-3RF OUT AC–3 RF SIGNAL L OUT Video Cassette Recorder 1 TV/Satellite Tuner SPEAKERS A MAIN S VIDEO CENTER B LD 1 COAXIAL TV/DBS 2 OPTICAL A 8ΩMIN./SPEAKER IN TUNER FRONT CD REAR VCR 1 3 TAPE PB TAPE 1 REC OUT OUT TAPE PB TAPE 1 4 IN REC OUT VCR 2 3 TAPE PB TAPE 2 LD 8ΩMIN./SPEAKER COUPLER OUT 4 IN REC OUT TV/DBS FRONT MIX MAIN LEVEL ON OFF —I0dB 0dB OUT VCR 3 /DVD 5ch 7ch VCR 3/DVD OUT CAN BE USED AS A 2ND MONITOR OUT, IF SELECTED MONITOR OUT BY SET MENU. L OUT R OUT L IN R IN L IN R IN L OUT DIGITAL SIGNAL R OUT SPLIT VCR 3/DVD PAL NTSC DIGITAL OUT Video Cassette Recorder 3 or Another Video Component 6 MONO Video Cassette Recorder 2 PRE MAIN OUT IN MAIN CH OUT CENTER IN SUB WOOFER FR Notes • If your components are equipped with digital audio signal output (and input) jacks, they can be connected to this unit’s DIGITAL SIGNAL input (and output) jacks. • Even if you connect a component to the DIGITAL SIGNAL jack of this unit, you must keep the component connected with the same named analog audio signal jacks of this unit, because digital signal cannot be recorded by a tape deck or VCR other than the tape deck connected to the OPTICAL TAPE 1 REC OUT jack of this unit. • If your LD player has an AC-3 RF signal output jack, connect it to this unit’s AC-3 RF SIGNAL input jack. Audio signals encoded with the Dolby Surround AC-3 are input to this unit by this connection. (General Model) A +B A OR B A + B: 4ΩMIN./SPEAKER A OR B: 8ΩMIN./SPEAKER To AC Outlet VOLTAGE SELECTOR AC OUTLETS SWITCHED UNSWITCHED I00W MAX. TOTAL 200W MAX. 8ΩMIN./SPEAKER RONT REAR EFFECT : RCA Pin Plug Connector Cable (Red): Right Audio (White): Left Audio : Optical Fiber Cable : Basic Connection (Required) : Additional Connection For Higher Sound Quality Or Special Performance 7 2 Video Connections If your video components offer S-Video capability, they can be connected to this unit’s S VIDEO jacks. Otherwise, connect the composite video input/output jacks of your video components to this unit’s composite VIDEO input/output jacks. LD Player AUDIO SIGNAL VIDEO OUT S-VIDEO OUT VIDEO OUT AC–3 RF SIGNAL AUDIO SIGNAL VIDEO SIGNAL GND VIDEO LD PHONO CD CD S-VIDEO OUT TV/Satellite Tuner S-VIDEO OUT VIDEO OUT VIDEO IN S-VIDEO IN Video Cassette Recorder 1 SPEAKERS A MAIN S VIDEO LD 1 COAXIAL TV/DBS 2 OPTICAL 8ΩMIN./SPEAKER IN TUNER FRONT CD VCR 1 3 TAPE PB TAPE 1 REC OUT OUT TAPE PB TAPE 1 4 IN REC OUT VCR 2 3 LD 8ΩMIN./SPEAKER COUPLER OUT TAPE PB TAPE 2 4 IN REC OUT TV/DBS FRONT MIX MAIN LEVEL VCR 3/DVD PAL NTSC ON OFF —I0dB 0dB OUT VCR 3 /DVD PRE MAIN OUT IN MAIN CH 5ch 7ch VCR 3/DVD OUT CAN BE USED AS A 2ND MONITOR OUT, IF SELECTED MONITOR OUT BY SET MENU. OUT Video Cassette Recorder 3 or Another Video Component Monitor TV Note If you wish to connect a second monitor TV (or a projector) to this unit, you can switch the VCR 3/DVD VIDEO OUT jack (and S VIDEO jack also) to a second monitor out jack for the connection with another monitor TV. (See page 43 of the Owner’s Manual for details.) S-VIDEO OUT VIDEO OUT S-VIDEO IN VIDEO IN S-VIDEO IN VIDEO IN S-VIDEO IN VIDEO IN VIDEO OUT S-VIDEO OUT DIGITAL SIGNAL Video Cassette Recorder 2 (Yellow) : RCA Pin Plug Connector Video Cable : S-Video Cable VCR 3/DVD PAL NTSC OUT VCR 3/DVD OUT CAN BE USED AS A 2ND MONITOR OUT, IF SELECTED MONITOR OUT BY SET MENU. Second Monitor TV VIDEO IN S-VIDEO IN : Composite VIDEO Connection : S-VIDEO Connection CEN CONNECTING AUDIO COMPONENTS OPTICAL DIGITAL OUT COAXIAL DIGITAL OUT Turntable AC–3 RF SIGNAL AUDIO SIGNAL VIDEO SIGNAL VIDEO PHONO CD CD L OUT R OUT AUDIO SIGNAL GND LD Tuner L OUT R OUT L OUT R OUT GND CD Player SPEAKERS A MAIN S VIDEO LD 1 or COAXIAL TV/DBS 2 OPTICAL 8ΩMIN./SPEAKER IN TUNER FRONT CD VCR 1 3 TAPE PB TAPE 1 REC OUT OUT TAPE PB TAPE 1 4 IN REC OUT VCR 2 3 LD 8ΩMIN./SPEAKER COUPLER OUT TAPE PB TAPE 2 4 IN REC OUT TV/DBS FRONT MIX MAIN LEVEL VCR 3/DVD PAL NTSC ON OFF —I0dB 0dB OUT VCR 3 /DVD PRE MAIN OUT IN MAIN CH 5ch 7ch VCR 3/DVD OUT CAN BE USED AS A 2ND MONITOR OUT, IF SELECTED MONITOR OUT BY SET MENU. L OUT R OUT L IN R IN L OUT R OUT L IN R IN DIGITAL SIGNAL Tape Deck 2 Tape Deck 1 (DAT) DIGITAL IN DIGITAL OUT 4 OUT CEN Settings Of Switches On The Rear Panel MAIN LEVEL Switch COUPLER FRONT MIX PAL NTSC Normally set to “0 dB”. If desired, you can decrease the mainchannel output level at the MAIN speaker terminals by 10 dB by setting this switch to “–10 dB”. MAIN LEVEL FRONT MIX Switch Set to “OFF (7ch)” when setting up a full 7 or 6 speaker system, or to “ON (5ch)” when setting up a 5 or 4 speaker system. ON OFF —I0dB 0dB PRE MAIN OUT IN MAIN CH 5ch 7ch PAL/NTSC Switch (General Model Only) Set this switch to the position corresponding to the video format that your video equipment employs. Connecting External Power Amplifier(s) If you wish to use an external power amplifier to drive speakers for any channel, connect the power amplifier to the corresponding line-level output jacks of this unit. Main Speakers R L Front Effect Speakers R L Power Amplifier Power Amplifier 8ΩMIN./SPEAKER 8ΩMIN./SPEAKER COUPLER MONO SPLIT MAIN LEVEL —I0dB 0dB PRE MAIN OUT IN MAIN CH OUT CENTER IN SUB WOOFER FRONT REAR EFFECT Power Amplifier Monaural Power Amplifier Monaural Power Amplifier L Center Speaker Center Speaker R Rear Effect Speakers 5
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.2 Linearized : No Encryption : Standard V1.2 (40-bit) User Access : Print, Fill forms, Extract, Assemble, Print high-res Create Date : 1999:06:16 11:38:50 Producer : Acrobat Distiller 3.01 for Power Macintosh Author : SSS01 Creator : QuarkXPressª3.32E: PSPrinter 8.2.2 J Title : A3090/CON-GUIDE(6/24) Modify Date : 2000:07:20 16:14:44 Page Count : 8EXIF Metadata provided by EXIF.tools