Yinrun Industry Q13 RC DRONE User Manual Q13 manual

Download:
Mirror Download [FCC.gov]
Document ID	3063153
Application ID	4YRxSy+NQsqnfVtIAGvSAg==
Document Description	User manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	200.87kB (2510880 bits)
Date Submitted	2016-07-14 00:00:00
Date Available	2016-07-14 00:00:00
Creation Date	2016-06-28 14:32:31
Producing Software	Adobe PDF library 10.01
Document Lastmod	2016-06-28 14:32:31
Document Title	Q13 manual
Document Creator	Adobe Illustrator CS6 (Windows)

Parts name and direction define
Quadcopter Fuselage
A Propeller
NO.Q13
GREEN LIGHT
FRONT BLUE LIGHT
B Propeller
(On/Off Button)
QUADROTOR SERIES
HeliX
QUADROTOR SERIES
NO.Q13s
15CM
Power Switch
HeliX
HeliX
B Propeller
QUADROTOR SERIES
A Propeller
RED LIGHT
15CM
(2) Transmitter
PREFACE
lnstruction light
Fine-tuning Button
Power switch
② Backward (Backward Filp Mode)
Right Throttle
Left Throttle
SAFETY PRECAUTION
① Forward (Forward Filp Mode)
(for Forward/Backward)
③ Left-side Flight (Left-side Filp Mode)
(Up/Down/Left-turn /Right-turn)
Fine-tuning Button
Fine-tuning Button
④ Right-side Flight (Right-side Filp Mode)
(for Left-side/Right-side Flight)
(for Left-turn/Right-Turn)
LED Switch
Auto-clockwise Spinning Button
(Light On/Off)
Speed Switching Button
(Low/Middle/High Speed)
Headless Button
One Button Return
Flip Switching Button(Flip Mode)
“HeliX” Logo for Item No. Q13
LCD Screen for Item No. Q13s
Battery Assembly & Charging Instruction
PRODUCT INTRODUCTION
.Do not use
your Quadcopter
Please insert the USB line’s port into the computer
(As Fig. 4) and use another side of USB to connect
the Battery Plug (As Fig. 5), and then the light on
the USB is Red;When the charging is finished, the
light will be off.The Quadcopter can fly about 6
minutes after charging about 40 minutes.
USB Cable
Plug the USB charger into the Power Socket and connect
the USB port into the charger(As Fig.6), the red indicator
of the USB will keep eternal bright.Please use the USB’s
another side to connect the Battery Plug(As Fig. 7), the
light on the USB will be Red.When finished the charging,
the light will be off.
QUADROTOR SERIES
HeliX
IES
To find a place to fly
OTO
B Propeller
Transmitter
Quadcopter
(with rechargeable battery)
ADR
QU
liX
He
SER
ADR
QU
OTO
liX
He
SER
IES
A Propeller
Instruction Manual
Replacing the battery
Here’s the Flying tips for your reference:
Open the battery cover to disconnect the Battery Plug
and Circuit board Port, and pull the rechargeable
Li-battery out (As Fig.9).
Quadcopter
QUADROTOR SERIES
RO
TO
SER
HeliX
IES
liX
He
QU
AD
HeliX
QUADROTOR
SERIES
Control method
HeliX
QUADROTOR SERIES
QUADROTOR SERIES
HeliX
HeliX
QUADROTOR SERIES
(Fig.12)
HeliX
Quadcopter
QUADROTOR SERIES
TX
HeliX
QUADROTOR SERIES
HeliX
QUADROTOR SERIES
CH
Moving
Forward
HeliX
Quadcopter
QUADROTOR SERIES
TX
HeliX
QUADROTOR SERIES
HeliX
QUADROTOR SERIES
CH
Moving
backward
TX
HeliX
QUADROTOR SERIES
CH
Moving
Leftward
HeliX
HeliX
QUADROTOR SERIES
HeliX
QUADROTOR SERIES
QUADROTOR SERIES
TX
Fig. 13
HeliX
QUADROTOR SERIES
CH
Moving
Rightward
LED OFF
LED ON
TX
Moving
Left-Spin
HeliX
QUADROTOR SERIES
HeliX
QUADROTOR SERIES
Default Mode
CH
HeliX
HeliX
QUADROTOR SERIES
QUADROTOR SERIES
HeliX
HeliX
QUADROTOR SERIES
QUADROTOR SERIES
TX
Moving
Right-Spin
HeliX
CH
Fig. 14
(5) In the normal, you can fly the quadcopter according to the its default Flying direction that’s Green Lights indicate the Flying
Front-side and Red Lights indicate the Flying Back-side; Meantimes, the LCD screen of the transimitter will show Mode 1;
HeliX
0M
Slow Speed Mode
HeliX
HeliX
QUADROTOR SERIES
QUADROTOR SERIES
QUADROTOR SERIES
Middle Speed Mode
QUADROTOR SERIES
HeliX
QUADROTOR SERIES
High Speed Mode
3M
6M
Auto-clockwise Spinning
Fig 15
Fig 18
Notice
Left Flip Mode
Repair immediately when the Quadcopter is damaged or out
of shape.(If the rotor is seriously broken, do not fly the product,
or else it may cause some accident.)
When the quadcopter has run out of electricity or being placed
for 3 months, please timely charge it for 20 minutes and then
unplug it and keep it well.
LEFT FLIP
Right Flip Mode
Maintenance
Forward Flip Mode
Quadcopter
Quadcopter
Quadcopter
Backward Flip Mode
New 1.5V “AA” alkaline batteries, for the transmitter to
Check the Quadcopter regularly to make sure it’s in good
shape.
Trouble manage
Hel
QUADROT
iX
OR
SERIES
The Quadcopter Front Side
(The Headless Flying Front-side denifition )
(1). Propeller can’t move
(2). Suddenly stop and
drop down when flying
(1). ON/OFF switch is OFF
(2). Run out of power
(1). No response from the
Quadcopter
(2). The Quadcopter can’t
be hovering normally
(1). The quadcopter fails to be decoded.
(2).The band of the transmitter doesn’t
correspond to the decoding of the
Quadcopter
(1). Turn the power on.
(2). Recharge the Quadcopter or
change the transmitter’s batteries.
Adjust the band on the transmitter and keep
it the same as the Quadcopter.Please make
decoding once again by the following Step
Control method mentioned in
(3) or (4)
the Instrunction Manual.
FCC COMPLIANCE INFORMATION STATEMENT (U.S)
QUADROTOR SERIES
HeliX
Fig 16
LCD screen
is for Q13S
Fig 17
TX
MODE 2
CH
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
“The device must not be co-located or operating in conjunction with any other antenna or transmitter.”

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
XMP Toolkit                     : Adobe XMP Core 5.3-c011 66.145661, 2012/02/06-14:56:27
Format                          : application/pdf
Title                           : Q13 manual
Metadata Date                   : 2016:06:28 14:32:31+08:00
Modify Date                     : 2016:06:28 14:32:31+08:00
Create Date                     : 2016:06:28 14:32:31+08:00
Creator Tool                    : Adobe Illustrator CS6 (Windows)
Thumbnail Width                 : 124
Thumbnail Height                : 256
Thumbnail Format                : JPEG
Thumbnail Image                 : (Binary data 9704 bytes, use -b option to extract)
Instance ID                     : uuid:4dd439aa-aa97-40aa-999f-0782ed27046a
Document ID                     : xmp.did:6C5857C2F93CE611ADB88EC1ECFC9443
Original Document ID            : uuid:5D20892493BFDB11914A8590D31508C8
Rendition Class                 : proof:pdf
Derived From Instance ID        : xmp.iid:6B5857C2F93CE611ADB88EC1ECFC9443
Derived From Document ID        : xmp.did:6B5857C2F93CE611ADB88EC1ECFC9443
Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8
Derived From Rendition Class    : proof:pdf
History Action                  : saved, saved
History Instance ID             : xmp.iid:C00E61E72332E3118EE1ECCB95F7B823, xmp.iid:6C5857C2F93CE611ADB88EC1ECFC9443
History When                    : 2013:10:11 11:19:13+08:00, 2016:06:28 14:32:18+08:00
History Software Agent          : Adobe Illustrator CS6 (Windows), Adobe Illustrator CS6 (Windows)
History Changed                 : /, /
Startup Profile                 : Print
Has Visible Overprint           : True
Has Visible Transparency        : True
N Pages                         : 1
Max Page Size W                 : 413.742532
Max Page Size H                 : 673.776961
Max Page Size Unit              : Millimeters
Font Name                       : ArialMT, Arial-BoldMT, Arial-Black, AdobeSongStd-Light
Font Family                     : Arial, Arial, Arial, Adobe 宋体 Std
Font Face                       : Regular, Bold, Black, L
Font Type                       : Open Type, Open Type, Open Type, Open Type
Font Version                    : Version 3.00, Version 3.00, Version 2.40, Version 5.002;PS 5.002;hotconv 1.0.49;makeotf.lib2.0.15106
Font Composite                  : False, False, False, False
Font File Name                  : ARIAL.TTF, ARIALBD.TTF, ariblk.TTF, AdobeSongStd-Light.otf
Plate Names                     : Cyan, Magenta, Yellow, Black
Swatch Groups Colorants Tint    : 100.000000
Swatch Groups Group Name        : 灰色
Swatch Groups Group Type        : 1
Swatch Groups Colorants Swatch Name: C=0 M=0 Y=0 K=100
Swatch Groups Colorants Mode    : CMYK
Swatch Groups Colorants Type    : PROCESS
Swatch Groups Colorants Cyan    : 0.000000
Swatch Groups Colorants Magenta : 0.000000
Swatch Groups Colorants Yellow  : 0.000000
Swatch Groups Colorants Black   : 100.000000
Producer                        : Adobe PDF library 10.01
Page Count                      : 1
Creator                         : Adobe Illustrator CS6 (Windows)

EXIF Metadata provided by EXIF.tools