Yunlink Technology XD3200 Wireless Access Point User Manual pt 2

Shenzhen Yunlink Technology Co., Ltd Wireless Access Point pt 2

Contents

User Manual pt 2

P35 Virtual AP 2.4G Access Control: Mainly show MAC allow or deny: P36 MAC Access Control 2.4G Advanced Settings: In this page, will show the regional, RF Power, Max user access...
P37 Advanced Setting 5.8G Wireless Setting: Almost same as 2.4G Wireless: P38 5.8G Wireless Setting Network setting: In this page, mainly to show the LAN setting and VLAN as follow:
P39 Network Setting
P40 Tag VLAN Setting Management: In this part, show the system time, Logs, upgrade firmware, system, user info. And we show System time, how to upgrade firmware and system page to users: P41 System Time P42 Firmware Upgrade United States
P43 System info 4th Share Internet and Obtain IP address automatically Set computer’s TPC/IP as Obtain an IP address automatically, Obtain DNS server address automatically as following picture showed. the computer will obtain the IP address from router or base station to get Internet. Tr oubl e Sh oo ti n g :
F 1 The Failure phenomenon and solution Failure phenomenon Solution SYS Indicator off Pls make sure the PoE module connection is right. POE Port connect with AP, LAN port connect with computer Can’t land to Wireless AP through Web page Pls check the IP address of computer and Wireless AP to see whether they are in same networking segment, The method is click “start”-“Run” input“cmd”，ping 192.168.188.253 to test the Wireless AP connectivity. Reset Wireless AP and load it again; Pls make sure the IP address 192.168.188.253 is not occupied by other device in Wireless AP’s networking; Check computer and cable problem, recommend to use 10/100M UTP unshielded cable; Clean up Arp binding from “Start”-“Run” input“cmd” arp –d Clean the IE Brower’s temporary files and Cache file。 Wireless AP can’t connect with AP （the status display unconnected） Try to scan the avaliable wireless networking again； Make sure the Wireless AP’s wireless standard（11b/g/n, 2.4G）is correct； The Security and passwords are matched between Wireless AP and AP； The signal strength of AP is too weak to connect, should be more than -75dBm； Can’t scan the wireless AP Scan it several times more； Make sure there are 5G signal existed. Reset the Wireless AP, scan it again after Wireless AP restart； The connection of Wireless AP and AP is success, but the computer can’t share internet Pls Check the computer’s IP address and DNS setting. If it is dynamin, set the network card as automatically obtain. If it is static IP, pls contact with ISP for correct IP address and DNS address. How to Reset Wireless AP Press the “Reset” button more than 15 seconds after power on. The Wireless AP will restore factory default after the Wireless AP restart.

Navigation menu