ZL WS 100 UG V3 B07DFLPTDK ZLINK Wall Switch Manual

: Z-Wave B07Dflptdk - Zlink Wall Switch Ws-100 Manual B07DFLPTDK_-_ZLINK_Wall_Switch_WS-100_Manual 728 docs

Open the PDF directly: View PDF .
Page Count: 2

Over the air (OTA) firmware upgrade

available with supported controllers

Instantly reports manual status change

to controller

Z-Wave Plus certified

Scene control capable

Fits standard single wall plate

Fits standard multiple gang junction box

This device requires neutral wire

Please note that the device will shut

OFF after a power failure. The device

will return to the last ON/OFF status

after power restore.

A Z-Wave certified controller of either

portable or static is capable of setting

up ZLINK units in your desired network.

Once the device is added,

you may assign it to a Group. It

will change its reaction when the All

command ON or OFF is received.

Furthermore, it can be set in Association

with another Z-Wave device to perform

a specific function. Please refer to the

instructions manual of your remote

controller for details and procedures on

how these settings can be done.

To install the WS-100 in a single gang

switch, no changes should be required.

For dual or higher gang configuration

where switches are next to each other,

the tabs need to be removed. Simply

take a pair of pliers, grab the tabs and

wiggle until the tabs break off.

device

device

device

device

device

device

device

light

WS-100

WS-100

WA-100

WA-100

WS-100

Use the manual reset procedure only

in the event that the network primary

controller is lost or otherwise inoperable.

The DSK and PIN can be found on

the metal yoke

ZLINK’s WS-100 is a Z-Wave Plus

certified device with S2 security and Smart

Start features. You can now add this

device securely and with ease using QR

code on the product with compatible

gateways supporting S2 and Smart Start.

Z-Wave Products WS-100 is a member of

the Z-Wave family and communicates

with other Z-Wave certified devices in a

control network. WS-100 replaces a

standard in-wall light switch and turns it

into a Z-Wave device serves as a node to

repeat the signal in the network, thus,

extending the overall Z-Wave mesh

wireless network range. Different types

and brands of Z-Wave devices can be

associated with ZLINK in your system and

they will work together to optimize and

expand the coverage of your Z-Wave

network. Once setup is completed, you

can enjoy the convenience and leisure

which WS-100 offers.

ZLINK

help@ZLINKproducts.com

ZLINK’s

Z-Wave Plus introduces a new

ZL-WS-100

process for scene activation –

“Central Scene Control”. Press and

release the button, it will send a

certain command to the central

controller via the lifeline association

group 1. This allows the controller to

react to key pressed, key released

and key held down.

Activation of Central Scene

The following default settings can be

Off

changed if configurable parameters are

supported by controller.

Configurable Parameters

The orientation of the ON/OFF on the

rocker switch can be inverted by

changing the following configuration

with a controller (if supported)

The ZLINK unit introduced in

this instructions manual has a Z-Wave

certification which guarantees such an

interoperability.

device

light

light

light

device

light is ON,

light is ON,

light

light

light

light

device

ZLINKProducts.com

70 Commercial Ave. Warehouse A

Moonachie, NJ 07074

WS-100_122617

WS-100

WS-100

WS-100 supports a maximum of 5

nodes for group #1