user manual
Manual
impulse wireless
IFIMPH-BR0
Introduction
Turn on the Impulse Wireless headphones and experience
premium sound unleashed. The following will show you how to
enjoy your Impulse Wireless. To download a complete manual,
visit www.zagg.to/manuals.
Play Music
1. Press the Play button to begin playing your music.
2. While music is playing, press Play quickly to pause it. Press
Play quickly again to resume.
3. Quick-press the Volume Up or Volume Down buttons to
control your audio volume.
4. Press and hold the Volume Up or Volume Down buttons to
track forward and back through your playlist.
Power and Pair
1. To turn on your Impulse Wireless headphones, press
and hold the Power button for three seconds until the
light flashes red and blue, indicating pairing mode. The
next time you turn your Impulse on, a blue LED will blink,
indicating it is pairing.
2. Ensure your device’s Bluetooth® connection is on and
select “IFROGZ Impulse Wireless”. Complete any additional
pairing steps based on your device. The LED will flash blue
every five seconds while your Impulse are on and paired.
3. To turn your Impulse o, press and hold the Power button
for three seconds. The LED will flash red until they are
powered o.
NOTE: If you are pairing with a new device, with your
headphones o, press and hold the Power button for five
seconds until the light flashes red and blue, indicating
pairing mode.
1
3
2
impulse wireless instructions
Volume Down/
Track Back Button
Volume Up/
Track Forward Button
Power Button
Play/Pause Button
Take Calls
1. Press the Play button to answer an incoming call.
2. Press and hold the Play button for three seconds to send an
incoming call to your voicemail.
3. Press the Play button during a call to disconnect.
4
Charge
To charge your Impulse Wireless headphones, connect the
micro USB end of the included charging cable to the port
under the left ear cup and the USB end to your preferred USB
outlet. The LED will light red while your Impulse are charging.
It will turn o when they are fully charged.
5
impulse wireless instructions
This device complies with Part 15 of the FCC
©2016 ZAGG Inc All Rights Reserved | NASDAQ: ZAGG | MADE IN CHINA
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by ZAGG Inc is under license.
Other trademarks and trade names are those of their respective owners.
ZAGG and Impulse are trademarks of ZAGG Inc.
impulse wireless instructions
FCC STATEMENT
Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.