ZMODO Technology H0018 Smoke Detector User Manual 1

ZMODO Technology Shenzhen Corp. Ltd. Smoke Detector 1

Users Manual

SA-H0018 烟雾报警器 快操 REV-A00尺寸：75*90mm（成品尺寸） 材质:105g双铜+双面印刷4C +折页Pivot Quick Start Guide472. SupportHaving difficulty?For more instructions, troubleshooting, support, and other resources, please visit: www.zmodo.com/supportLike us on Facebook.com/Zmodo Scan the QR-code!Follow us on Twitter @Zmodo Scan the QR-code! 3. Connect with us!REV-A001 2Quick Start GuideSmoke DetectorThe Zmodo Smart Accessories Kit provides a full solution to monitor your home. All devices can be connected and controlled through the Zmodo app. The following describes the main features of this system.1.Mount and Connect your Smoke DetectorSmoke Detector: When paired with a Beam, the smoke detector alerts you with audible warning sounds and aphone notification when smoke is detected.Find a suitable location to install your smoke detector, and follow the instructions for installation.Wall-mounted detectors should be installed no further than 12 inches away from the ceiling. Install at least 10 feet away from cooking appliances to minimize false alarms. Mount your detector high on walls or ceilings. If you are installing in the basement, the detector should be installed on the ceiling at the bottom of the stairs leading to the next floor. In order to optimize performance, do NOT install near windows, doors, or vents.Tips: 16Turn the smoke detector clockwise and separate it from the mounting bracket. 1Insert one CR123A Battery (included) into the battery compartment.2In order to connect the smoke detector, access your smart hub's Device Settings and select the "Accessories" option. Select the Add Accessory option, follow the on-screen +instructions, and when prompted, press and hold the button on the detector for 3 seconds. When the status light is blinking red and the alarm sounds, release the button, and the detector will be paired with your Beam. Press here3Note: The Status Light will blink red when the smoke detector has low battery. 38 96Referring to the placement tips, find a suitable location for your smoke detector and install the mounting bracket with the provided screws. 4Fasten the smoke detector onto the mounting bracket. When in use and working properly, the status light will blink red every 48 seconds. When smoke is detected, the light will blink red, the alarm will sound, and you will receive a notification on your phone. You can deactivate the alarm from the mobile app or by pressing the button on the smoke detector.5Note: The line shown in red will be parallel to the edge of the smoke detector when the smoke detector is placed onto the mounting bracket. Make sure that this edge is parallel or perpendicular to the wall for aesthetic purposes. 145This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Consult the dealer or an experienced radio/TV technician for help.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Navigation menu