Zebra Technologies MD-ZLAN11B 802.11b Compact Flash Radio Module User Manual CERTIFICATE OF COMPLIANCE

Users Manual

Rhein Tech Laboratories, Inc. Client: Zebra Technologies

360 Herndon Parkway FCC: Part 15.247

Suite 1400 IC: RSS-210

FCC ID: I28MD-ZLAN11B Herndon, VA 20170

http://www.rheintech.com Model: ZLAN11B

Page 22 of 29

Appendix D: User Manual

Please refer to the following page, taken from the user manual.

Zebra 802.11b WLAN Radio Module

The following section only applies when the Zebra 802.11b WLAN radio module (with

FCC ID: I28MD-ZLAN11B) is installed in a RW printer. The FCC ID number is on the serial number

label on the back of the printer and can be read with the module installed. Other than conditions specified

elsewhere in this manual, only one of the radio options can be installed in the printer at one time and the

antenna used for these transmitters must not be co-located or must not operate in conjunction with any

other antenna.

Caution • The radiated output power of this internal 802.11b radio is far

below the FCC radio frequency exposure limits. Nevertheless, this radio

must be used in such a manner that the antenna is 2.5 cm. or further

from the human body. The radio and antenna are mounted internally

in this printer such that when the printer is worn with the back of the

printer against the body and the front of the printer (where paper exits)

away from the body, then the 2.5 cm distance between the antenna and

the users body will be met. Do not use the printer in an unauthorized

manner.