Zeeva EP-0546 BT LED WRAP EARBUDS AST User Manual IM EP 0546
Zeeva International Limited BT LED WRAP EARBUDS AST IM EP 0546
Zeeva >
User Manual
Headset Overview
3. Activate the Bluetooth function on your phone within range and select
“BT LED WRAP EARBUD” from the list shown.
4. The LED lights in blue when paired successfully.
Attention: If the pairing is not successful within 5 minutes, the headset will
power off, please repeat the pairing procedures to try again.
Pair BT LED WRAP EARBUDS with your mobile device
1. Keep the distance between your wireless headset and mobile phone
(or other devices) within 32.8 Feet.
2. Power on the BT LED WRAP EARBUDS
Reconnect BT LED WRAP EARBUDS to your mobile device
When powered on, the headset will automatically connect with the last
successfully paired device.
Disconnect the headset from your mobile device
Leave the headset 60ft away from your mobile phone or further.
Power off the headset; or
Switch off the Bluetooth on your mobile phone; or
Answer/Reject a call
End a call
When you receive a call, press the On/Off Button once to accept the call,
or answer the call normally via your mobile phone.
Long press On/Off Button to reject a call
Press the On/Off Button once to end the call or hang up your mobile phone.
Technical specification
FAQ
FCC ID: 2ADM5-EP-0546
Made Exclusively for Five Below
Distributed by Zeeva International Limited
Suite 1006C-8, 10th Floor, Exchange Tower,
33 Wang Chiu Road, Kowloon Bay,
Hong Kong, China
Keep all relevant information for future reference
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that
may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
LED indicator light turns red when charging your headset
LED indicator light turns blue when your headset are fully charged
Short press + Button to advance to next song
Long press + Button to turn up volume
Long press - Button to turn down volume
Short press - Button to go back to previous song
Functions
Charging your headset
Headset Overview
Power On/Off
LED Micro USB Charging Cable:
USB Plug
Micro USB Plug
Power on
Press and hold down the On/Off Button for 3 seconds
and the LED will flash in red and blue alternately.
Power off
Press and hold down the On/Off Button for 4 seconds
and the LED will turn off.
LED Flash Power On/Off
LED Power on
Double click the Vol+ button to switch On the LED flash.
LED Power off
Double click the Vol+ button to switch Off the LED flash.
If the BT LED WRAP EARBUDS cannot be paired with your device,
please try the following:
Ensure that your headset are in pairing mode or reconnection mode.
Ensure that Bluetooth search function of your mobile device is activated.
If the BT LED WRAP EARBUDS will not turn on:
Make sure the headset are fully charged.
Can I change the battery for the headset?
BT LED WRAP EARBUDS use a built-in non-detachable battery which
cannot be removed.
If the BT LED WRAP EARBUDS cannot be recharged:
If you use a power outlet, ensure that the power supply is connected securely
and the outlet works. If you use a computer, ensure that it is connected and
the USB port is powered.
-The input voltage to the product is 5V 1A.
-In order to charge the product in safe manner and reliable conditions, please
only adopt certified appropriate charger/ adapter for charging the product.
-Only charge the product at ambient temperatures between 10 deg °C/ 50 deg °F
and 40 deg °C/104 deg °F
.
-Do not heat above 70 deg °C/158 deg °F
, eg. Do not expose to sunlight or throw
into fire.
-Switch off the product after use.
-Please note that we won’t take any responsibility for any wrong operation
(e.g. Voltage higher than 5V) as this may result in severe injury or loss of
property, and we cannot control the operating process during the time the user
using this product.
-In extreme cases, abuse or misuse of Lithium battery pack can lead to
explosion, heat generation, fire development or smoke development.
Safety instructions for the lithium battery and charging the product
Thank you for purchasing the BT LED WRAP EARBUDS.
This manual provides more information about the wireless headset,
please read the instructions before using.
INSTRUCTION MANUAL
Vol-/
Previous Song
On/Off Button
Play/Pause Music
Answer/End Call
Vol+/
Next Song
Front: Side:
Microphone
Micro USB
Charging Port
Package Contents
BT LED WRAP EARBUDS x 1 pc
Micro USB Charging Cable x 1 pc
User Manual x 1
BT LED
WRAP EARBUDS
Impedance: 32 Ohms
Sensitivity: 95 dB +/- 3 dB
Frequency Response: 20 Hz - 20 KHz
Power Supply: Li-ion Battery 3.7V 60 mAh
Playing Time: 2-3 Hours
Charging Time: 2 Hours
Bluetooth Range: 32.8 Feet
Micro USB cable included.