eMoMo Technology W602 Warm feel CoCo Remote User Manual W60248ERR

Download:
Mirror Download [FCC.gov]
Document ID	3935046
Application ID	zjHuf3l4ahLwaFy/KXeiCw==
Document Description	Users manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	4.74kB (59281 bits)
Date Submitted	2018-07-23 00:00:00
Date Available	2018-07-23 00:00:00
Creation Date	2018-06-08 16:53:59
Producing Software	Corel PDF Engine Version 14.0.0.701
Document Lastmod	2018-07-19 16:15:09
Document Title	W60248ERR 說明書
Document Creator	CorelDRAW
Document Author:	Administrator

Cautions
Specification
♦Please read the user manual carefully before using.
♦Rated power：58W
Frequently asked quesitions
♦Apply to 110V-240V.
♦Rated input：29V
ISSUE
PROBABLY REASON
♦Please use the original switch power supply.
♦Rated currenty：2A
♦The remote does
♦Without battery or
♦Do not use when the fabric is fold or get wrinkled.
♦Input for knob：3V
not work
batteries are
installed incorrectly.
♦Do not detach and wash the fabric.
♦Remote battery：7#AAA
♦The batteries have
♦Please keep away from acid and alkaline liquid.
been ran out.
Operation
♦Not apply to children, pregnant woman, people who suffer
♦The device does
♦Power supply is
♦ Press on the rear cover of the remote and pull towards to
not work.
disconnected or
from bleeding tendency and bleeding illness, tuberculosis
the remote bottom to remove the back-up cover, then install 2pcs
isn't connected
malignant tumor and is not sensitive to heat.
properly.
7#AAA batteries （Ensure “+” and “-”is proper）。
♦Please troubleshoot the problems as  ♦Disconnect the power supply
♦The device hasn’t
paired successfully.
on this manual. If the problem is not mentioned, please cal after-sell ♦Press and hold TIME- for about 4s until the neck light flashes,
♦Shut down autoservice. Do not try to repair by yourself, or it may cause void warranty. then connect the power in 15s. The neck light lights off, pair successfully. ♦The device shut
down suddenly.
matically as limited
time has run out.
♦ Press it to turn on the device and heat function. Press it again
Buttons and functions
♦ Connectors do
to turn off the device and all functions. Press and hold for 3s to turn on/off the flashlight.
not connect
♦M Turn on/off massage function
properly.
1st press: Turn on massage function and all vibrators work in 3 modes cyclically.
Turn on/off
Turn on/off heat function
It works in each mode for 1 min then switch into the next mode automatically.
Turn on /off massage function
2nd press: Turn off massage function.
♦
Recline the headrest
♦
Lift the headrest.
Position indicators
♦
Open the chair.
♦
Close the chair.
Adjust recliner
Heat time indicators
♦ Reset the chair
♦
TIME- Press it to decrease the heat time. 15′/30′/60′available.
Adjust temperature
TIME
Temperature indicators LOW
If there is only 15 minutes left, press TIME- to turn off heat function.
/MID/HIGH
TEMP.
♦
TIME+ Increase heat time.15′/30′/60′available.
Massage time indicators
♦ TEMP.- Lower the heat temperature. Low/Med/High available. If it heats @low
TIME
Adjust massage
Massage intensity indicators
mode, the upper-left indicator lights red. If it heats @med mode, the upper indicator lights red.
If it heats @high mode, the upper-right indicator lights red.
INTENSITY
♦ TEMP.+ Upgrade the heat temperature. Low/Med/High available.
♦TIME- Decrease massage time.15′/30′/45′ available.
♦TIME+ Increase massage time.15′/30′/45′available.
♦INTENSITY- Decrease massage intensity. Low/Med/High available.
♦INTENSITY Upgrade massage intensity. Low/Med/High available.
TROUBLE SHOOTING
♦Install 2 pcs 7#AAA
batteries correctly.
♦Replace 2 new batteries.
♦Replug the power supply.
♦Re-pair signal.
♦Restar the device.
♦Check all connectors
and re-connect if it is
necessary.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly
approved by the party.
Responsible for compliance could void the user’s authority to operate this
equipment. (Example- use only shielded interface cables when connecting to
computer or peripheral devices).
This equipment complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
XMP Toolkit                     : 3.1-701
Create Date                     : 2018:06:08 16:53:59+08:00
Creator Tool                    : CorelDRAW
Modify Date                     : 2018:07:19 16:15:09+08:00
Metadata Date                   : 2018:07:19 16:15:09+08:00
Format                          : application/pdf
Creator                         : Administrator
Title                           : W60248ERR 說明書
Producer                        : Corel PDF Engine Version 14.0.0.701
Document ID                     : uuid:0f60c783-2d3b-4b5a-9323-fd709b4b95c0
Instance ID                     : uuid:5ea443fb-f090-4ad8-8dc5-60f7fff45c20
Page Count                      : 2
Author                          : Administrator

EXIF Metadata provided by EXIF.tools