i Tech Dynamic C51-B305-XX i.Tech i.Car Kit 305 User Manual EN
i.Tech Dynamic Limited i.Tech i.Car Kit 305 EN
User Manual
Dispose of the packaging and this product in accordance
with the latest provisions.
2009 Hutchison Harbour Ring Enterprises Limited
All rights in this publication are reserved and no part may be reproduced without
the prior written permission of the publisher. The contents of this publication are
believed to be correct at the time of going to press, but any information,
specifications, products or services mentioned, and product I.D. shown may be
modified, supplemented or withdrawn without further notice. The Stylized i.Tech
logos are trademarks owned by Hutchison Harbour Ring Enterprises Limited or
its affiliates. All other trademarks or registered trademarks belong to their
respective owners.
02/2009
♦ Charging indication will be delayed for a few seconds if the carkit has not
been used for a long time or the battery is drained.
♦ 4 hours are required to fully charge the carkit.
Troubleshooting
I can hear crackling noise.
To receive the best audio quality, it is recommended to place your phone
closer to the carkit.
I can't hear anything in my carkit.
• Ensure the carkit is turned on and is properly charged.
• Ensure the carkit is properly paired with the mobile phone.
• Make sure that the mobile phone is connected with the carkit – if it does not
connect, either refer to the mobile phone's Bluetooth menu or by pressing
the MFB once (see “Using Your Carkit” and “Pairing Your Carkit with a
Bluetooth Mobile Phone”).
I can't connect my carkit with mobile phone.
• Ensure your carkit is turned off and is properly charged.
• Ensure the carkit is properly paired with your mobile phone.
Troubleshooting (cont'd)
• Ensure your mobile phone’s Bluetooth feature is activated. Please refer to
your mobile phone user guide for specific instruction.
• Ensure the carkit is within ten metres range of your mobile phone and
there are no obstructions, such as walls or other electronic devices in
between.
If the above steps do not solve your problem, please recharge the carkit and
remove your mobile phone’s battery for a while.
I can’t turn off the carkit or the carkit does not response
• You may do a “hardware reset” on your carkit if you can’t turn it off or it
doesn’t response.
• Plug the charging cable to the carkit and then press and hold the volume
key and MFB button.
• Release the both buttons and the status indicator will stay red again and
the carkit is reset.
• If you do not plan to use the carkit for a long period, please store it in a dry place
that is free from extreme temperatures and dust.
• Use only the charger supplied by the carkit’s original manufacturer to charge the
carkit. Other chargers may look similar but using them could be dangerous and
could damage the carkit.
Care and Maintenance (cont’d)
• Turn off your carkit before placing it in your pocket or bag. If the MFB is
accidentally depressed, your mobile phone may place an unintended call.
• Dispose of the battery and the carkit according to local regulations. Do not
dispose of them as household waste.
• Do not bring the carkit into contact with any sharp objects as this will cause
scratches and damages.
• Do not attempt to disassemble the carkit as it does not contain serviceable
components.
Care and Maintenance
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating instructions
for satisfying RF exposure compliance. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
FCC RF Radiation Exposure Statement:
Safety Information
• Check and observe local laws regarding the use of a mobile phone and a
carkit while driving. If you use the carkit while driving, ensure your full
attention and focus. It is your responsibility to drive safely. Consider to pull
off the road before making or answering a call.
• Never leave your carkit above any air bag deployment area inside your car
as serious injury may result when an air bag deploys.
• Never allow children to play with the carkit – small parts may be of choking
hazard.
• Do not expose the carkit to liquid, moisture or humidity, or rain as it is not
waterproof.
• Do not keep the carkit near a wash basin or other wet places.
• Do not leave the carkit in direct sunlight for an extended period of time.
• Do not expose the carkit to extremely high or low temperatures.
Safety Information (cont'd)
• Observe all signs and displays that require an electrical device or RF radio
product to be switched off in designated areas. These could include
hospitals, blasting areas, and potentially explosive atmospheres.
• Do not clean the carkit while it is being charged. Always disconnect the
charger from the carkit before cleaning.
• Avoid charging the carkit in extremely high or low temperatures.
• Do not attempt to force open the built-in battery.
• Only charge the carkit’s built-in battery in accordance with the instructions
described in this user guide.
Declaration of Conformity
We, i.Tech Dynamic Limited, declare that the following product: Product Name:
i.Tech i.Carkit 305
Model No.: C51-B305-XX
is in conformity with the following essential requirements of Council Directive
1999/5/EC (referred to as R&TTE Directive): Article 3.1a, 3.1.b and 3.2. and the
product is manufactured in accordance with Annex II of the above directive.
A copy of the Declaration of Conformity can be found at
http://www.itechdynamic.com.
Notes on Environmental Protection
After the implementation of the European Directive 2002/96/EU in the national
legal system, the following applies: Electrical and electronic devices must not be
disposed of with domestic waste. Consumers are obliged by law to return
electrical and electronic devices at the end of their service lives to the public
collection points that are set up for this purpose or designated points of sale.
However, such details are defined by the national law of the respective country.
This symbol on the product, the instruction manual or the packaging indicates
that the product is subject to these regulations. By recycling, reusing the
materials, or other forms of utilizing old devices, you are making an important
contribution in protecting our environment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
15.21
You are cautioned that changes or modifications not expressly approved by the
part responsible for compliance could void the user’s authority to operate the
equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
Federal Communications Commission (FCC) Statement
Getting Started
To use your i.Carkit 305 Bluetooth carkit (“carkit”), please follow the steps below:
1. Ensure your carkit is fully charged.
2. Pair your charged carkit with a Bluetooth-enabled mobile phone.
Charging Your Carkit
The carkit comes with a built-in rechargeable battery. Prior to using the carkit
for the first time, it is recommended to fully charge the battery.
1) Insert the car charger into the car cigarette socket
2) Plug the USB charging cable into the car charger USB slot
3) Connect the USB charging cable into the carkit charging socket as shown in
the figure.
4
5
6
6-7
8
9-10
10-11
11-15
16
17-18
19-20
21-22
22
Product Specifications
i.Carkit 305 Overview
Getting Started
Charging Your Carkit
Installing Your Carkit
Indicator Light
Pairing Your Carkit with a Mobile Phone
Using Your Carkit
Resetting Your Carkit / Removing the Pairing History
Troubleshooting
Safety Information
Care and Maintenance
Declaration of Conformity
Contents Product Specifications
Bluetooth Specification: v2.1 + EDR Class 2
Bluetooth Profiles Supported: Headset and Handsfree
Speaker Power: 1.5 watts
Range of Frequency: 2.4GHz spectrum
Nominal Charging Time: Within 4 hours
Talk Time*: Up to 8 hours
Standby Time*: Up to 800 hours
Dimensions: 79 (L) x 38 (W) x 12 (H) mm
Dimensions: 3.11’’ (L) x 1.50’’ (W) x 0.47’’ (T) inch
Weight: 90 grams / 3.17oz
* may vary due to the user’s habit, different modes of operation, and
mobile phone settings.
Indicator Light Indicator Light
Carkit Status Status Indicator Light (fig.1)
• Charging (OFF MODE)
• Fully charged (OFF MODE)
• Low battery
• Out of battery
• Charging (STANDBY MODE)
• Fully charged (STANDBY MODE)
• Out of Range
• Solid Red
• The light turns off
• Flash Red and short beep every minute
• The light turns off
• Solid Red with Blue flash in every 8 seconds
• Flash blue
• Long beep, flash purple 3 times and then
flash blue (repeat every 15 seconds)
Talk and Standby Time
A fully charged battery can offer up to 8 hours of talk time and up to 800
hours of standby time. The carkit remains in standby mode after being
turned on.
Pairing Your Carkit with a Bluetooth Mobile Phone
1) Ensure the carkit is off.
2) To activate the pairing mode, press and hold the carkit’s MFB for 8 seconds
without releasing your finger until its status indicator flashes blue and red
light alternately.
3) Activate your mobile phone’s Bluetooth, search Bluetooth devices, select
“i.Carkit 305” and enter the passcode “0000”. When the pairing is completed,
the carkit’s status indicator will flash blue light rapidly five times.
Pairing Your Carkit with a Bluetooth Mobile Phone
If the pairing cannot be completed within 3 minutes after the pairing mode
has been activated, the carkit’s status indicator will flash purple rapidly 5
times and then turns to standby mode. Repeat steps 1 to 3 to pair both
devices again.
When you turn on your carkit for the first time, the carkit proceeds into
pairing mode automatically, i.e. the status indicator flashes blue and red
alternately, so that you can immediately pair it with your mobile phone.
Using your Carkit
Function Button Audio Status Indicator
Power ON Short beep Flash blue light 3 times
Using your Carkit
Function Button Audio Status Indicator
Power OFF Press and hold the MFB for 2
seconds
Ringer tone
Press the End Button once
Press the Volume UP/DOWN
button once to increase /
decrease by 1 level (Total 6
levels)
Short beep at
max. volume
Incoming call
End a call
Adjust Volume
Voice Dialing* Press the MFB once
Red light for two seconds
and then the light goes off
Fast blinking purple light
Flashing blue light
Press the MFB button onceAnswer a call Flashing blue light
Flashing blue light
Flashing blue light
Long beep
Short beep
Say the voice tag as soon as you hear the short beep and you must have
recorded the voice tag into your mobile phone.
Using your Carkit
Function Button Audio Status Indicator
Last no. Redial* Double click the MFB
Press End Call button once
While speaking, press and
hold the volume Key for 2
seconds
While speaking, press MFB
once
Reject a call*
Call Transfer
(carkit to
mobile phone)*
Call Transfer
(mobile phone
to carkit)*
Flashing blue light
Flashing blue light
Flashing blue light
Flashing blue light
While speaking, press MUTE
button once
Call muting (Mic
ON/OFF)
Blue on and turn off every
8 seconds
Short beep
Short beepWhile speaking, press MUTE
button once
Call muting
while charging
(Mic ON/OFF)
*Multipoint function allows you to pair with two mobile phones simultaneously.
When either phone rings, you may pick the call by pressing the MFB. To pair the
phones:
1. Pair your headset with the 1st mobile phone as normal
2. Turn the carkit off and repeat the pairing procedure for the 2nd mobile phone
3. Reconnect the 1st mobile phone with the headset
When there is an incoming call from another phone, you can pick the 2nd call by
pressing the Call button on the phone
Purple on and turn off every
8 seconds
* Subject to mobile support
Short beep
Short beep
Factory Reset
You may reset the carkit to its default settings. Resetting will also remove the
pairing history of your carkit with the mobile phone.
1. Ensure the carkit is turned OFF.
Hold the volume key and plug charging cable into the charging socket. The
status indicator will alternately flash Red and Blue for 3 times.
2. Release the volume key.
3. The status indicator will stay red again and the carkit is reset.
i.Tech Bluetooth carkit is designed to work with Bluetooth devices. Due to
large variability between different Bluetooth devices from different
manufacturers, interoperability between the carkit and all
Bluetooth-enabled products is not guaranteed.
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Federal Communications Commission (FCC) Statement
Bluetooth Carkit
i.Carkit 305 User Guide
1. Multi-function Button (MFB)
• Power On / Off
• Pair with mobile phone
• Answer call
• Last number redial
• Voice dialing
2. Mute Button
3. Volume Up/Down Button
• Adjust volume up or down
• transfer a call
4. Status Indicator
5. End/Reject Call Button
6. Speaker
7. Microphone
8. Charging Socket
9. 3.5mm Line Out Socket
10. Detachable Visor Clip
i.Carkit 305 Overview
Use only the supplied charger / USB charging cable to charge the carkit.
Charge Plug
Charging Socket
Charging Your Carkit
456
7
To install your carkit, you should first slide the metal visor clip onto the
carkit, and then secure the carkit to the sun visor in your car as shown.
You may slide the clip onto the carkit in both directions for different
driving conditions.
8
Installing Your Carkit
910 11 12
13
Using your Carkit
Function Button Audio Status Indicator
14
Using your Carkit
Function Button Audio Status Indicator
15 16 17 18
19 20 21 22 23 24
25 26
3-26
25-43
44-62
63-81
82-100
101-121
122-139
140-158
159-178
English
French
German
Itanio
Espanish
Greek
Arabic
Romanian
Bulgarian
Press and hold the MFB for 2
seconds
10
(fig.1)
(fig.2)
(fig.3)
5
1
3
4
7
6
2
9
8